Question is ⇒ In a 4 bit counter the output of 3 JK FFs from MSB downward are connected to the NAND gate whose O/P is connected to CLR, Options are ⇒ (A) it is a MOD-14 counter, (B) it is MOD-13 counter, (C) it is divided by 13 counter, (D) it is divide by 10 counter, (E) , Leave your comments or Download question paper.

Question is ⇒ In a 4 bit counter the output of 3 JK FFs from MSB downward are connected to the NAND gate whose O/P is connected to CLR, Options are ⇒ (A) it is a MOD-14 counter, (B) it is MOD-13 counter, (C) it is divided by 13 counter, (D) it is divide by 10 counter, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a 4 bit counter the output of 3 JK FFs from MSB downward are connected to the NAND gate whose O/P is connected to CLR
A.	it is a MOD-14 counter [Correct Answer]
B.	it is MOD-13 counter [Wrong Answer]
C.	it is divided by 13 counter [Wrong Answer]
D.	it is divide by 10 counter [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In figure the collector to emitter breakdown voltage of the transistor (βV_CEO) shoul
more than V_CC
more than 0.5 V_CC
more than V_CC + E
more than 2 V_CC

⇒ Trinitron is a monochrome picture tube.
TRUE
FALSE

⇒ How many lines are there in address bus of 8085 μp?
6
8
12
16

⇒ End fire array has a dipole spacing of λ/2.
TRUE
FALSE

⇒ The accuracy of measurement using CRO is about
± 0.5%
± 0.05 %
± 1%
± 3%

⇒ The direction of vectors gives the direction of propagation of electromagnetic waves
Vector (E x H)
Vector (F x H)
Vector E
Vector H

⇒ Fortran 77 has six arithmetic operators.
TRUE
FALSE

⇒ In figure The minimum and maximum load currents
0 and 60 mA
0 and 120 mA
10 mA and 60 mA
10 mA and 120 mA

⇒ Which of these instruments is dynamometers type?
Wattmeter
Power factor meter
Frequency meter
Both (a) and (b)

⇒ In oscillator circuits the energy feedback to its input terminal from output is
always in phase with the input signal
90° out of phase with the input signal
180° out of phase with the input signal
270° out of phase with the input signal

⇒ The parameter β of a BJT change by 300%. If self bias is used in the amplifier using this BJT, the quiescent value of I_C and V_CE remain almost the same.
TRUE
FALSE

⇒ Start and stop bit do not contain any information but are used in serial communication for
error correction
error detection
synchronization
slowing down the communication

⇒ The characteristic impedance of coaxial cable is about
1000 ohm
500 ohm
250 ohm
75 ohm

⇒ The current through a 10 Ω resistance in a dc circuit having two emf sources is 3A. If this resistance is changed to 20 Ω, the new value of current will be
less than 3 A
equal or less than 3 A
equal to or less or more than 3 A
1.5 A

⇒ Consider the following statements about transport-lag

It is of non-minimum phase behaviour
It normally exists in thermal, hydraulic and pneumatic systems
It has an excessive phase lag with no attenuation at high frequency

Which of the above statements are correct?
1 only
1 and 2
All
2 and 3

⇒ The attraction between the nucleus and valence electron of copper atom is
zero
weak
strong
either zero or strong

⇒ Armstrong FM transmitter uses
LC oscillator
crystal oscillator
RC oscillator
either (a) or (c)

⇒ The RF section of a radio transmit generally consists of
master oscillator
final power amplifier to feed antenna
buffer stage
all of the above

⇒ Under low level injection assumption, the infected minority carrier current for an extrinsic semiconductor is essentially the
diffusion current
drift current
recombination current
induced current

⇒ The total number of channels allotted for cellular telephone is
666
333
221
111

⇒ If in a broadcasting studio, a 1000 kHz carrier is modulated by an audio signal of frequency range 100-5000 kHz, the width of channel is __________ kHz.
5
4.9
995
10

⇒ Pulse modulation is used in
radio navigation
automatic landing equipment
data communications
all of the above

⇒ Discharge breakdown in insulators is due to voids.
TRUE
FALSE

⇒ The ideal characteristics of a stabilizer is
constant output voltage with low internal resistance
constant output current with low internal resistance
constant output voltage with high internal resistance
constant internal resistance and constant output current

⇒

Assertion (A): A universal RLC bridge has a battery and also a high frequency ac source.

Reason (R): RLC bridge uses a Wienbridge arrangement for measuring capacitance.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The circuit of figur
Precision integrator
Hartley oscillator
Butterworth high pass filter
Wien bridge oscillator

⇒ If memory chip size is 256 x 1 bits, the number of chips required to make 1 k byte memory is
8
12
24
32

⇒ If PRIN = 200.0 and BINT = 0.0525 the result of expression INCOME = PRIN * (1 + BINT) will be
210
210.5
210.5
210.5

⇒ DMA stands for
Direct Memory Address
Distributed Memory Address
Direct Memory Accumulator
Decimal Machine Address

⇒ A second order system exhibits 100% overshoot. The damping ratio is
0
1
< 1
> 1