Question is ⇒ In a single sideband suppressed carrier AM system, the modulation index is changed from 0 to 1, the power content of the signal, Options are ⇒ (A) will be quarter, (B) will be doubled, (C) will increase by 50 percent, (D) will increase by 25 percent, (E) , Leave your comments or Download question paper.

Question is ⇒ In a single sideband suppressed carrier AM system, the modulation index is changed from 0 to 1, the power content of the signal, Options are ⇒ (A) will be quarter, (B) will be doubled, (C) will increase by 50 percent, (D) will increase by 25 percent, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a single sideband suppressed carrier AM system, the modulation index is changed from 0 to 1, the power content of the signal
A.	will be quarter [Wrong Answer]
B.	will be doubled [Wrong Answer]
C.	will increase by 50 percent [Correct Answer]
D.	will increase by 25 percent [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Bipolar IC memories are fabricated using
high density versions of the bipolar transistor flip-flop
low density versions of the unipolar transistor flip-flop
high density versions of the MOSFET
low density versions of the MOSFET

⇒ A permeable substance is one
which is strong magnet
which is a weak magnet
which is a good conductor
through which magnetic lines of force can pass easily

⇒ The following switching functions are to be implemented using a decoder

f₁ = ∑m (1, 2, 4, 8, 10, 14)
f₂ = ∑m (2, 5, 9, 15)
f₃ = ∑m (2, 4, 5, 6, 7)

The minimum configuration of decoder is
2 to 4 line
3 to 8 line
4 to 16 line
5 to 32 line

⇒ In figure the dc load line will meet the y and x axis respectivel
20 mA and 30 V
15 mA and 20 V
25 mA and 40 V
10 mA and 20 V

⇒ A bipolar differential amplifier uses a transistor having β₀ = 200, I_CQ = 100 mA, |A_dm| = 500 and CMRR = 80 dB. The value of R_c and R_E will be respectively __________ .
1.25 kΩ, 1.25 MΩ
125 kΩ, 1.25 MΩ
1.25 MΩ, 1.25 kΩ
3.25 kΩ, 3.25 MΩ

⇒ For a photo conductor with equal electron and hole mobilities and perfect ohmic contacts at the ends, an increase in the intensities of optical illumination results in
change in open circuit voltage
change in short circuit current
a reduction resistance
an increase of resistance

⇒ The Kirchoff's laws fail in which of the following circuits?
Linear circuits
Non-linear circuits
Lumped parameters circuits
Distributed parameters circuits

⇒ ALE stands for
Address Latch Enable
Accumulator Latch Enter
Address Latch Enter
Accumulator Latch Enable

⇒ The number of layers in a Shockley diode are
2
3
4
2 or 3

⇒ In LIFO
only the top of the stack is immediately accessible
only the top of the stack is never accessible
only the first-in is accessible
only the first-in is not accessible

⇒ Which of the following subtraction operations do not result in F₁₆?

(BA)₁₆ - (AB)_{161 and 2
1 and 3
2 and 3
1, 2 and 3}

⇒ A capacitance transducer can be used to measure
thickness of sheet
displacement
level of fluids
all of the above

⇒ The gain of an antenna with a circular aperture of diameter 3 metres at a frequency of 5 GHz, will be
2.4674
24.674
246.74
24674

⇒ Which liquid crystal is used for LCD display?
Mercury
Pneumatic fluid
Aqua regia
Liquid boron

⇒ In a modem digital computer, a subtractor in normally not used because
subtractors are very expensive
the design of a subtractor is very complex
the adder is geared for doing subtraction
most of the programs do not require subtraction

⇒ As per Boolean algebra, inputs can be interchanged in
OR gates
AND gates
both OR and AND gates
none of the above

⇒

Assertion (A): Microprocessor 8085 can address 65536 memory locations.

Reason (R): Microprocessor 8085 has 16 address lines.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ A combination circuit is one in which the output depends on
input combination at that time
input combination and previous output
input combination and previous input
present output and previous output

⇒ Which of the following does not cause losses in optical fibre cables?
Impurities
Microbending
Attenuation in glass
Stepped index operation

⇒

Match the following:

	List I		List II
A.	Very low response at very high frequencies	1.	Low-pass system
B.	Over shoot	2.	Velocity damping
C.	Synchro-control transformer output	3.	Natural frequency
		4.	Phase-sensitive modulation
		5.	Damping ratio

A-1, B-5, C-4
A-3, B-2, C-4
A-2, B-5, C-4
A-4, B-1, C-3

⇒ Panel type instruments are used in
power stations
automobiles
industries
all of the above

⇒ In a cable with ∈_r = 4, the wave velocity is
3 x 10⁸ m/s
0.75 x 10⁸ m/s
1.5 x 10⁸ m/s
10⁸ m/s

⇒ How many roots with positive real parts do the equation s³ + s² - s + 1 = 0 have?
Zero
One
Two
Three

⇒ For an npn transistor connected as shown in the figure V_BE = 0.7 volts. Given that reverse saturation current of the junction at room temperature 300K is 10^-13A, the emitter curr
30 mA
39 mA
49 mA
20 mA

⇒ A stepper motor is
a two phase induction motor
is a kind of rotating amplifier
is an electromagnetic transducer used to convert an angular position of shaft into electrical signal
is an electromechanical device which actuates a train of step angular movements in response to a train of input pulses on one to one basis

⇒ BCD number 1100111 = __________ ₁₀
66
67
68
69

⇒ Using 4-bit numbers (n = 4) if k = (0011)₂ how is k expressed in 2's complement.
(1011)₂
(1101)₂
(1100)₂
(0101)₂

⇒ For static electric and magnetic fields in an homogenous source-free medium, which of the following represents the correct form of Maxwell's equations?
Δ.E = 0
Δ.E = 0
Δ x E = 0
Δ x E = 0

⇒

Assertion (A): Drift velocity of electrons is proportional to the applied electric field E.

Reason (R): The average drift velocity per unit field is called mobility.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following is not a valid arithmetic statement in C?
x = x + 1
x = y ^* z
x ^* y = z
z = y / x