Question is ⇒ In the given figure, the flip flop, Options are ⇒ (A) negative edge triggered, (B) positive edge triggered, (C) level triggered, (D) either (a) or (c), (E) , Leave your comments or Download question paper.

Question is ⇒ In the given figure, the flip flop, Options are ⇒ (A) negative edge triggered, (B) positive edge triggered, (C) level triggered, (D) either (a) or (c), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In the given figure, the flip flop
A.	negative edge triggered [Correct Answer]
B.	positive edge triggered [Wrong Answer]
C.	level triggered [Wrong Answer]
D.	either (a) or (c) [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following 8085 instructions do not effect CY flag?
SEE M
SEE R
DCRM
ADC M

⇒ A generated voltage is equally dependent on three resistances R₁, R₂, R₃ and its value is V = (R₁R₂)/R₃. If tolerance of each resistor is 0.1%, the maximum error in voltage is
0.003
± 0.3%
0.001
± 0.1%

⇒ It is found that in a telephone system 60 subscribers initiate calls during a 30 minute interval and the total duration of all the calls is 100 minutes. The load is
2
3 erlang
3.333 erlang
0.333 erlang

⇒ In a single phase full wave regulator, the firing angles in the positive and negative half cycles are generally
equal
different
equal or different
different but sometimes equal

⇒

Match the following:

	List I		List II
A.	T (Reflection coefficient) = 0	1.	(Z_L - Z_o)/(Z_L + Z_o)
B.	T = - 1	2.	Z_L = Z_o
C.	T = + 1	3.	Z_L = 0
D.	- 1 < T < + 1	4.	Z_L = ∞

A-2, B-3, C-4, D-1
A-2, B-4, C-1, D-3
A-1, B-2, C-3, D-4
A-3, B-2, C-4, D-1

⇒ Radio broadcasting is a familiar example of
space multiplexing
time multiplexing
frequency multiplexing
none of the above

⇒ A PIN diode can be used
as a shunt mounted switch
as a series mounted switch
both as series or shunt mounted switch
non of the above

⇒ At 20 GHz , the gain of a parabolic dish antenna of 1 meter diameter and 70% efficiency is
15 dB
25 dB
35 dB
45 dB

⇒ A clipper
adds a dc component to the input signal
removes signal voltages above or below a specified value
both (a) and (b)
either (a) or (b)

⇒

Match the following:

	List I		List II
A.	DMA controller	1.	Interface between computer and video display adapter
B.	CKT controller	2.	Used to read data directly from disk into directly memory
C.	Interrupt controller	3.	Supervises the operation of control signal

A-1, B-2, C-3
A-2, B-3, C-1
A-3, B-2, C-1
A-2, B-1, C-3

⇒ ABCD + AB C D =
ABC
ABCD
A B D
ABCD

⇒ When an electron rises through a potential of 100 V it will acquired an energy of
100 eV
100 Joules
100 ergs
100 x 10^-6 Newtons

⇒ Pressing a key on telephone set generates two frequencies. The basis for selection of these frequencies is
the harmonics of one frequency should not be mistaken for the other frequency
the audio input to the handset transmitter should not be mistaken for a key pressing
both (a) and (b)
neither (a) nor (b)

⇒ For TM waves in a parallel plate waveguide, the minimum attenuation arising from imperfect conductors would occur at a freq. of (f_c is the cut off frequency)
3 f_c
3 f_c
2 f_c
2 f_c

⇒ Transistor T₁ operates at 30 kHz and T₂ operates at 300 Hz. The flicker noise is
not depend on frequency
T₁ > T₂
T₁ = T₂
T₁ < T₂

⇒ The light output of LED varies as (current)ⁿ. The value of n is about
0.5
1
1.3
2.1

⇒ A two stage amplifier has an upper cutoff frequency of 2 MHz and a lower cutoff frequency of 2 MHz and a lower cut off frequency of 30 Hz. If both stages are similar, their individual upper and lower cut off frequencies respectively are
4 MHz and 60 MHz
3 MHz and 20 Hz
3 MHz and 60 Hz
4 MHz and 20 Hz

⇒ A JFET operates in ohmic region when
V_GS = 0
V_GS is less than pinch off voltage
V_GS = is Positive
V_GS = V_DS

⇒ In Java 31% gives an answer
3
4
42798
42828

⇒ The dynamometer principle can be used for
ammeter only
voltmeter only
wattmeter only
ammeter, voltmeter and wattmeter

⇒ A delta modulation system is designed to operate at 3 times the Nyquist rate for a signal with a 3 KHz bandwidth. The quantization step size is 250 mv. The maximum amplitude of a 1 KHz input sinusoidal for which the delta modulator does not show slope overload is :
716.2 mV
500 mV
647.87 mV
400 mV

⇒ In an 8085 microprocessor, the instruction CMP B has been executed while the content of the accumulator is less than that of register B, As a result.
carry flag will be set but zero flag will be reset
carry flag will be reset but zero flag will be set
both carry flag and zero flag will be reset
both carry flag and zero flag will be set

⇒ At frequencies of 10 MHz and higher the impedance represented by ground is primarity
resistive
inductive
capacitive
partly resistive and partly capacitive

⇒ Which of the following could be the equation for non-linear resistor shown in figu
a + be + ce² + de³
a - be - ce² - de³
a + be + ce² - de³
a + be - ce² - de³

⇒ In high frequency region, an amplifier behaves like a
band pass filter
low pass filter
high pass filter
any of the above

⇒ Consider the following statements about DRAM

Page mode read operation is faster than RAS read
RAS input remains active during column address strobe
The row and column addresses are strobed into the internal buffers using RAS and CAS inputs respectively

Which of the above statements are correct?
1 and 3 only
All
1 and 2 only
2 and 3 only

⇒ In a TV studios, flying spot scanner is a device for
mixing video and audio signals
telecasting feature films
live telecast of outdoor programs
telecast of indoor music programs

⇒ A wave is propagated in a waveguide at frequency of 9 GHz and separation is 2 cm between walls find cut off wavelength for dominant mode.
4 cm
1 cm
2 cm
8 cm

⇒ The early effect in a BJT is caused by
fast turn on
fast turn off
large collector base reverse bias
large emitter base forward bias

⇒ As compared to a bipolar transistor, a JFET is
highly sensitive to changes in input voltage
more sensitive to changes in input voltage
less sensitive to changes in input voltage
equally sensitive to changes in input voltage