Question is ⇒ The directive gain of a transmitting antenna is, Options are ⇒ (A) proportional to wavelength, (B) inversely proportional to wavelength, (C) proportional to square of wavelength, (D) inversely proportional to square of wavelength, (E) , Leave your comments or Download question paper.

Question is ⇒ The directive gain of a transmitting antenna is, Options are ⇒ (A) proportional to wavelength, (B) inversely proportional to wavelength, (C) proportional to square of wavelength, (D) inversely proportional to square of wavelength, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The directive gain of a transmitting antenna is
A.	proportional to wavelength [Wrong Answer]
B.	inversely proportional to wavelength [Wrong Answer]
C.	proportional to square of wavelength [Wrong Answer]
D.	inversely proportional to square of wavelength [Correct Answer]
View Answer 1 -3 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For stable network, the real part of poles and zeros of driving point function must be
negative
negative or zero
zero
positive

⇒ If operator 'a' = 1 ∠120° then (1 - a²) =
1 ∠ - 30°
1 ∠ 30°
1 ∠ - 60°
1 ∠60°

⇒ Consider the following about 'return' statement in C

On executing the return statement, it immediately transfers the control back to the calling program.
There is no restriction on the number of 'return' statements present in a function.
The 'return' statement must be present at the end of called function.

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ Which of the following is equivalent to AND-OR realization?
NAND-NOR
NOR-NOR
NOR-NAND
NAND-NAND

⇒ Which of the following best represents the input impedance of an actual op-amp?
10 ohm
1 k ohm
1 M ohm
100 M ohm

⇒ In most transistor the collector region is made physically larger than the emitter region
for dissipating heat
to distinguish it from other regions
as it is sensitive to ultraviolet rays
to reduce resistance in the path of flow of electrons

⇒ 7BF₁₆ = __________ ₂
0111 1011 1110
0111 1011 1111
0111 1011 0111
0111 1011 0011

⇒ The common-drain amplifier, better known as the source follower, has a voltage gain __________ and the output signal is __________ with the input signal.
approaching unity, in phase
approaching unity, out of phase
is very high, in phase
is very high, in reverse phase

⇒ In 8085 microprocessor, what is the length of A-register?
6 bits
8 bits
12 bits
16 bits

⇒ The 10 MHz in the specification of CRO means that
the sweep frequency is 10 MHz
the frequency of input signal should not be more than 10 MHz
the vertical amplifier has been designed for 10 MHz
none of the above

⇒ For a stable system
both phase and gain margin are negative
both phase and gain margin are positive
phase margin is positive but gain margin is negative
gain margin is positive but phase margin is negative

⇒ Consider the following statements about diamagnetic material and diamagnetism.

The materials have negative magnetic susceptibility.
At very low temperature diamagnetic materials.

Which of the statements given above is/are correct?
1 only
2 only
Both 1 and 2
neither 1 nor 2

⇒ For matching over a range of frequencies in a transmission line it is best to use
a balun
a broad band directional coupler
double stub
a single stub of adjustable position

⇒ TM₀₁ mode in circular waveguide is analogous to
TM₁₀ mode in square waveguide
TM₁₁ mode in square waveguide
TM₂₀ mode in square waveguide
TM₀₂ mode in square waveguide

⇒ In a tape recorder the output from RF oscillator is given to
only erase head coil
only record head coil
coils of both erase head and record head
none of the above

⇒ In graphical analysis of BJT amplifier the slope of ac line is more than that of dc load line.
TRUE
FALSE

⇒ Consider a control system shown in given figure. For slight variation in G, the ratio of open loop sensitivity to closed loop sensitivity will be give
1 : (1 + GH)
1 : (1 + GH)^{- 1}
1 : (1 - GH)
1 : (1 - GH)^{- 1}

⇒ The reactance of bypass capacitor in a CE amplifier circuit should be
equal to the resistance in parallel with it
equal to 10% or less of the resistance in parallel with it
equal to 50% of the resistance in parallel with it
independent of the resistance in parallel with it

⇒ A thermistor is a
thermocouple
thermometer
miniature resistance
heat sensitive explosive

⇒ Which antenna is frequently used for local area transmission at UHF/VHF?
Ground monopole
Turnstile antenna
Slot antenna
Loop antenna

⇒ Alternating current can induce voltage because it has magnetic field which is
constant
time varying
stronger field than D.C.
closed loop nature.

⇒ Which of the following is also called Non volatile RAM?
Shadow RAM
UVEPROM
EEPROM
Both (b) and (c)

⇒ A thyristor has maximum allowable junction temperature of 110° C and the ambient temperature is 40°C, If the maximum internal power dissipation is 50 W, the thermal resistance is
2° C/W
1.4° C/W
0.7°C/W
2.2° C/W

⇒ In waveguide Degenerate modes are
two mode having same cut off frequency
two mode having same power
two mode having same phase velocity
it is a hypothetical mode

⇒ 25 persons are in a room. 15 of them play hockey, 17 of them play football and 10 of them play both hockey and football. Then the number of persons playing neither hockey nor football is:
2
17
13
3

⇒

Assertion (A): Radar gave birth to microwave technology.

Reason (R): In radar systems very high frequencies give the most accurate results.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In figure, the curre
is 2 A from A to B
is 2 A from B to A
depends on the value of R
none of the above

⇒

Assertion (A): Doping level in extrinsic semiconductors is very small.

Reason (R): Additional of impurity in the ratio of 1 part in 10⁸ parts increases the number of charge carriers by about 20.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ A dynamometer wattmeter is suitable for both dc and ac.
TRUE
FALSE

⇒ The parity bit is
always 1
always 0
1 or 0
none of the above