Question is ⇒ Industrial heating furnaces such as arc and induction furnaces operate on __________ power factor, Options are ⇒ (A) low leading, (B) low lagging, (C) high leading, (D) very low lagging, (E) , Leave your comments or Download question paper.

Question is ⇒ Industrial heating furnaces such as arc and induction furnaces operate on __________ power factor, Options are ⇒ (A) low leading, (B) low lagging, (C) high leading, (D) very low lagging, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Industrial heating furnaces such as arc and induction furnaces operate on __________ power factor
A.	low leading [Wrong Answer]
B.	low lagging [Wrong Answer]
C.	high leading [Wrong Answer]
D.	very low lagging [Correct Answer]
View Answer 1 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the following line 15
line 25
line 35
any of the lines 15 or 25, 35

⇒ A transmission line has characteristics impedance of (75 + j 0.01) Ω and is terminated in a load impedance of (70 + j 50) Ω. The reflection coefficient will be
0.08 + j 0.32
0.32 + j 1.38
0.70 - j 2.97
1.1 + j 0.32

⇒ The magnetic field due to current I equals
I/2 pr
I/4 pr
I²/2 pr
I²/4 pr

⇒ The number of logic devices required in a Mod-16 synchronous counter are
4
5
6
7

⇒ In an RLC series circuit having finite values of RLC, the phase difference between applied voltage and current is
always 0°
between 0 and 180°
between 0 and 90°
always 90°

⇒ A compiler converts a high level computer program into machine language program.
TRUE
FALSE

⇒ The eigen values of a skew symmetric matrix are
always zero
always pure imaginary
either zero or pure imaginary
always real

⇒ As frequency increases, the transmission efficiency
decreases
increases
is not affected
either (a) or (c)

⇒ In a synchro error detector, the output voltage is proportional to [ω(t)]ⁿ, where ω(t) is the rotor velocity and n equals :
-2
-1
1
2

⇒ Which of the following sampling frequencies is considered adequate in voice telephony?
4 kHz
8 kHz
16 kHz
32 kHz

⇒ In the schematic representation of bipolar junction transistor, the direction of arrow shows the direction of flow of
holes
electrons
holes in pnp and electrons in npn
electrons in pnp and holes in npn

⇒ A narrowband amplifier is one that has a passband
limited to 2000 Hz only
limited to audio frequency range only
near cut off region of active device
approximately 10% of its central frequency

⇒

Assertion (A): The impedance of a series resonant circuit is minimum at resonance.

Reason (R): Resonance condition implies unity power factor condition.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The current rating of a cable depends on
length of cable
diameter of cable
both length and diameter of cable
none of the above

⇒ In 8085 the term 'absolute addressing' means
Direct addressing
Immediate addressing
Register addressing
Register indirect addressing

⇒ In Bode analysis the correction at corner frequency is 3 dB.
TRUE
FALSE

⇒ A FET is a better clapper than a BJT because it has
lower off-set voltage
higher series ON resistance
lower input current
higher input impedance

⇒ In Jone chopper, the commutating element
is a capacitor
is a capacitor and an inductor
is a capacitor and an auto transformer
none of the above

⇒

Match the following:

	List I		List II
A.	LED	1.	Heavy Doping
B.	Avalanche Photodiode	2.	Coherent Radiation
C.	Tunnel diode	3.	Spontaneous Emission
D.	LASER	4.	Current gain

A-2, B-4, C-3
A-2, B-3, C-1, D-4
A-3, B-4, C-1, D-2
A-2, B-1, C-4, D-3

⇒ The tuned circuit of the oscillator in a simple AM transmitter employs a 50 H coil and a 1 nanofarad capacitor. If the oscillator output is the carrier frequency will be
448 kHz
555 kHz
625 kHz
712 kHz

⇒

Match the following:

	List I		List II
A.	RF amplifier	1.	Amplifier received carrier and sidebands
B.	Loudspeaker	2.	Gives acoustic output
C.	Demodulator	3.	Has IF input and AF output
D.	IF amplifier	4.	Fixed-tuned to intermediate frequency

A-1, B-2, C-3, D-4
A-2, B-1, C-3, D-4
A-3, B-4, C-1, D-2
A-1, B-4, C-3, D-2

⇒ At very low frequencies a series R-C circuit behaves as almost purely __________ .
resistive
inductive
capacitive
none of the above

⇒ In an AM system, doubling of modulation index doubles the antenna current. The system is
single side band full carrier
vestigial side band
single side band suppressed carrier
double side band full carrier

⇒ Which of the following device acts as an N-P-N and a P-N-P transistor connected base to base and emitter to controller?
UJT
SCR
Diac
Triac

⇒ AE 139 is a
tunnel diode
germanium power transistor
photoconductive cell
silicon diode

⇒ For an insulating material, dielectric strength and dielectric loss should be respectively
high and high
low and high
high and low
low and low

⇒ For most static RAM the maximum access time is about
1 ns
10 ns
100 ns
1 μs

⇒ A UPS contains
rectifier
inverter
either rectifier or inverter
both rectifier and inverter

⇒ For the logic circuit of the given figure the simplified Boolean expression
A ⊕ B
A + B
AB
A + B

⇒

Assertion (A): The amount of photoelectric emission depends on the intensity of incident light.

Reason (R): Photo electric emission can occur only if frequency of incident light is less than threshold frequency.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true