Question is ⇒ The figure of merit for a logic family is, Options are ⇒ (A) gain band width product, (B) (propagation delay time) (power dissipation), (C) (fan out) (power dissipation), (D) (noise margin) (power dissipation), (E) , Leave your comments or Download question paper.

Question is ⇒ The figure of merit for a logic family is, Options are ⇒ (A) gain band width product, (B) (propagation delay time) (power dissipation), (C) (fan out) (power dissipation), (D) (noise margin) (power dissipation), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The figure of merit for a logic family is
A.	gain band width product [Wrong Answer]
B.	(propagation delay time) (power dissipation) [Correct Answer]
C.	(fan out) (power dissipation) [Wrong Answer]
D.	(noise margin) (power dissipation) [Wrong Answer]
View Answer 1 -7 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The feedback control system shown in figure is stable for what values of K and
K < 0, T > - 1
K > 0, T > 0
K > 0, T > - 1
K < 0, T > 0

⇒ Wagner earthing device eliminates
all stray capacitance in the circuit
stray capacitances between components
stray capacitance between detector terminal and ground
mutual coupling between components

⇒ An end fire array consisting of several half-wave lengths of directive gain 40, then find the width of major lobe
60
50
51.25
None of the above

⇒ During testing of an energy meter, the energy recorded by meter was 0.05 kWh and correct energy was found to be 0.09 kWh. The error and correction respectively are
-0.01 kWh and 0.01 kWh
0.01 kWh and -0.01 kWh
-0.01 kWh and ± 0.01 kWh
± 0.01 kWh and 0.01 kWh

⇒ In a modem digital computer, a subtractor in normally not used because
subtractors are very expensive
the design of a subtractor is very complex
the adder is geared for doing subtraction
most of the programs do not require subtraction

⇒ For emitter-couple logic, the switching speed is very high because
negative logic is used
the transistors are not saturated when conducting
emitter-coupled transistors are used
multi-emitter transistors are used

⇒ In a 3 phase full converter the average load current is 150 A. The average thyristor current is
150 A
75A
50 A
25 A

⇒ Consider the following rules for constructing variable names in C

It can have alphabets, digits or underscores but no other special character.
The maximum number of characters is 8.
The first character may be an alphabet or digit but not underscore.

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ Maximum power from a source having internal resistance R_i is delivered to a resistive load R_L, if
R_i > R_L
R_i < R_L
R_i = R_L²
R_i = R_L

⇒ The two pressure coils in a single phase power factor meter of turns
the same dimension and the same numbers of turns
the same dimension but different number of turns
different dimension and different numbers of turns
different dimension but the same numbers of turns

⇒ 2's complement representation of a 16 bit number (one sign bit and 15 magnitude bits) is FFFF. Its magnitude in decimal representation is
0
1
32, 767
65, 535

⇒ In a ferromagnetic material, the internal field seen by a dipole is
equal to applied field
equal to applied field minus a contribution from neighbouring dipoles
equal to applied field plus a contribution from neighbouring dipoles
equal to or less than applied field

⇒ Which of the following is not valid in case of FETs?
It has low voltage gain
It has high input impedance
It has fast switching time
It is voltage controlled device

⇒ The RF section of a radio transmit generally consists of
master oscillator
final power amplifier to feed antenna
buffer stage
all of the above

⇒ Satellite communication systems use the frequency band
10 to 20 MHz
50 to 70 MHz
3 to 6 GHz
100 to 120 GHz

⇒ In the analogy between electric and magnetic circuits permeability is analogous to
resistivity
conductivity
electric field intensity
current density

⇒ A permanent magnet moving coil measures
true rms value
dc value
peak value
rms plus dc value

⇒ In a rectangular waveguide
the broad width is generally labelled 'a' and height 'b'
the broad width is generally labelled 'b' and height 'a'
any one of the dimensions may be labelled 'a' and the other 'b'
the length is labelled as 'a'

⇒ A two branch tuned circuit has a coil of resistance R and inductance L in one branch and capacitance C in the second branch. If R is increased, the dynamic resistance
increases
decreases
remains constant
may increases or decreases

⇒ The refractive index of E layer at frequency of 81 N
0
∞
1
0.5

⇒ Which of the following theorems is a manifestation of law of conservation of energy?
Tellegen's theorem
Reciprocity theorem
Thevenin's theorem
Norton's theorem

⇒ A difference amplifier using op-amp has closed loop gain = 50. If input is 2 V to each of inverting and non-inverting terminals, output is 5 mA. Then CMRR =
20000
2000
200
20

⇒ In an end fire array, the radiation pattern
is in the plane of array
is at right angles to array
is at an angle to the plane of array
either (b) or (c)

⇒ Thevenin's impedance of an ac network is in general
resistance
R and L in series
R and C in series
Either R and L or R and C in series

⇒ Consider the following time parameters

Domain growth time constant.
Transit time.
Dielectric relaxation time in positive mobility regime.

Which of the above are used in connection width transferred electron device?
1, 2, and 3
1 and 2 only
1 and 3 only
2 and 3 only

⇒ A ground wave travels along surface of ground.
TRUE
FALSE

⇒ The r_e model equivalent circuit shown in figure is
CE amplifier
CC amplifier
CB amplifier
None of the above

⇒ Two coils having self inductances of 10 mH and 40 mH are mutually coupled. The maximum possible mutual inductance is
40 mH
20 mH
10 mH
5 mH

⇒ Consider the following

Generation of SSB signals
Design of minimum phase type filters
Representation of band pass signals

Which of the above applications is Hilbert transform used?
1 only
1, 2 and 3
1, 2 only
1 and 3

⇒ The symbol ! in Java means
logical NOT
logical OR
AND
logical XOR