Question is ⇒ Poor power factor, Options are ⇒ (A) reduces load handling capability of electrical system, (B) results in more power losses in the electrical system, (C) overloads alternators, transformers and distribution lines, (D) all, (E) , Leave your comments or Download question paper.

Question is ⇒ Poor power factor, Options are ⇒ (A) reduces load handling capability of electrical system, (B) results in more power losses in the electrical system, (C) overloads alternators, transformers and distribution lines, (D) all, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Poor power factor
A.	reduces load handling capability of electrical system [Wrong Answer]
B.	results in more power losses in the electrical system [Wrong Answer]
C.	overloads alternators, transformers and distribution lines [Wrong Answer]
D.	all [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The circuit shown below is functionally equivalen
NOR gate
OR gate
EX-OR gate
NAND gate

⇒ In a TV studio the illuminance is about
200 lux
1000 lux
10000 lux
10 lux

⇒ If the average power of radar transmitters is 2 kW and the peak power of the transmitter is 1000 kW, what will be the duty cycle?
0.002
0.02
0.001
0.01

⇒ Which of the following will increase the antenna radiation efficiency?
Use of larger section of conductor
Providing insulation on conductor
Top loading of antenna
Any of the above

⇒ For any test point s on the real axis, the sum of angular contributions of the complex conjugate poles is
90°
180°
270°
360°

⇒ Peak to peak value of a sine wave is equal to twice the peak value
TRUE
FALSE

⇒ Negative feedback in amplifier
reduces gain
increases frequency and phase distortion
reduces bandwidth
increases noise

⇒ Let JCOKE = 3 and LPEPSI = 5. Consider the statement 8
1
15
10

⇒ A doped semi-conductor is called
impure semi-conductor
dipole semi-conductor
bipolar semi-conductor
extrinsic semi-conductor

⇒ Which of the following is used as a passive component in electronic circuits?
Tunnel diode
Capacitor
Transistor
Vacuum tube

⇒ For Bode plot of (1 + jωT) has
slope of 20 dB/decade and phase angle + tan^-1 (ωT)
slope of - 20 dB/decade and phase angle + tan^-1 (ωT)
slope of 20 dB/decade and phase angle - tan^-1 (ωT)
slope of - 40 dB/decade and phase angle - tan^-1(ωT)

⇒ The energy of one quantum of light equal to hf.
TRUE
FALSE

⇒ In cell communication, cell stands for
Geographical Area
Battery
Location
No meaning

⇒ Most small signal transistors are
N-P-N, silicon, in a plastic package
P-N-P, silicon, in a plastic package
N-P-N, germanium in a metallic case
P-N-P, germanium in a metallic case

⇒ A band elimination constant k filter has series resonant circuit in series arms.
TRUE
FALSE

⇒ Figure represen
JFET shunt switching circuit
JFET series switching circuit
JFET analog switch
multiplexing

⇒ Which of the following uses 'transferred electron effect' for production of microwaves?
Silicon
Germanium
Metal-semiconductor junction
Gallium Arsenide

⇒ In a modem digital computer, a subtractor in normally not used because
subtractors are very expensive
the design of a subtractor is very complex
the adder is geared for doing subtraction
most of the programs do not require subtraction

⇒

Assertion (A): Impedance measurement at microwave frequencies is done by finding SWR.

Reason (R): SWR and reflection coefficient depend on the characteristic impedance and load impedance.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ If both emitter base and collector base junctions of a BJT are forward biased, the transistor is in
active region
saturated region
cut off region
inverse mode

⇒ Which of the following is not a key word in C?
pop
for
if
union

⇒ In a bipolar transistor, emitter efficiency is about
0.99
0.9
0.8
0.7

⇒ A generator with an internal resistance of 600 Ω drives an amplifier whose input resistance is 400 Ω. The generator's open circuit voltages is 1 mV; the amplifier develops 100mV across an 8kΩ load. The current amplification is
2.5
12.5
25
125

⇒ The range of values of a and b for which the linear time invariant system with impulse respon
|a| > 1, |b| > 1
|a| < 1, |b| < 1
|a| < 1, |b| > 1
|a| > 1, |b| < 1

⇒ A reflex klystron oscillator uses
one cavity resonator
two cavity resonators
three cavity resonators
none of the above

⇒ The relation between thermal conductivity K (W/m/°C), heat flow density Q (watt/m²) and dT/dx (°C per metre) is
Q = K(dT/dx)
Q = - K(dT/dx)
K = Q(dT/dx)
dT/dx = - QK

⇒ Consider the sequence x[n] = [- 4 - j5 1 + J2 4]
[- 4 - J2.5 J2 4 - J2.5]
[- J2.5 1 J2.5]
[- J5 J2 0]
[- x 1 4]

⇒ 2's complement representation of a 16 bit number (one sign bit and 15 magnitude bits) is FFFF. Its magnitude in decimal representation is
0
1
32, 767
65, 535

⇒ A dielectric should have poor heat conductivity.
TRUE
FALSE

⇒ Resistivity of hard drawn copper is
less than that of annealed copper
more than that of annealed copper
same as that of annealed copper
decreasing when temperature increases