Question is ⇒ ZL = 200 Ω and it is desired that Zi = 50 Ω The quarter wave transformer should have a characteristic impedance of, Options are ⇒ (A) 100 Ω, (B) 40 Ω, (C) 10000 Ω, (D) 4 Ω, (E) , Leave your comments or Download question paper.

Question is ⇒ ZL = 200 Ω and it is desired that Zi = 50 Ω The quarter wave transformer should have a characteristic impedance of, Options are ⇒ (A) 100 Ω, (B) 40 Ω, (C) 10000 Ω, (D) 4 Ω, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Z_L = 200 Ω and it is desired that Z_i = 50 Ω The quarter wave transformer should have a characteristic impedance of
A.	100 Ω [Correct Answer]
B.	40 Ω [Wrong Answer]
C.	10000 Ω [Wrong Answer]
D.	4 Ω [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a bipolar junction transistor a_dc = 0.98, I_CO= 2 μA and 1_B = 15 μA. The collector current I_C is
635 mA
735 mA
835 mA
935 mA

⇒ In Vidicon camera tube, the resistance of photoconductive material on the target plate
is constant
is more in darkness and less in brightness
is more in brightness but less in darkness and brightness
may be more or less in darkness and brightness

⇒ During forward blocking state of SCR, the voltage and current respectively are
high and high
low and low
high and low
low and high

⇒ The following circuit diagram resembl
logic 0
logic 1
f(A, B, C) = Σm(0, 1, 4, 6, 7)
none

⇒ If the numerator of Z(s) is one degree higher than denominator, Z(s) has a pole at infinity.
TRUE
FALSE

⇒ Which one of following is correct condition to check the stability of system?
Bounded I/P unbounded O/P
Bounded I/P and O/P
Bounded O/P and I/P
Bounded I/P Bounded O/P

⇒ Work function of oxide coated cathode is much lower than that of tungsten cathode.
TRUE
FALSE

⇒ In a self bias circuit for CE amplifier, an increase in emitter resistance R_E results in
increase in emitter voltage
decrease in emitter voltage
increase in emitter current
decrease in emitter current

⇒ In a CD the sampling frequency is nearly
half the highest frequency in audio signal
equal to highest frequency in audio signal
double the highest frequency in audio signal
four times the highest frequency in audio signal

⇒ A dc circuit breaker must use
natural commutation
forced commutation
both natural and forced commutation
either natural or forced commutation

⇒ A single phase half wave converter is feeding a resistive load. Just before triggering, the voltage across thyristor is
zero
about 1 V
same as input voltage
twice the input voltage

⇒ A crystal is frequently used in digital circuits for timing purpose because of its
low cost
high frequency stability
simple circuitry
ability to set frequency at desired value

⇒ Chrome signals in PAL colour television system consist of
R - Y and B - Y signal
V and U signals
I and Q signals
R - Y and G - Y signals

⇒ The given figure shows a constant current source driving a parallel RC circuit. It is equivalen
a lag network
a lead network
a lag-lead network
either (a) or (b)

⇒ Which one of the following is correct? Energy of a power signal is
finite
zero
infinite
between 1 and 2

⇒ Consider the following statements for a driving point function F(jω):

Re F(jω) is an even function of ω and is 0 or positive for all values of ω.
Im F(jω) is an even function of ω and is 0 or positive for all values of ω.
Re F(jω) is an odd function of ω and is 0 or negative for all values of ω.
Re F(s) = 0 for Re s = 0.

Which one of the statements given above is/are correct?
1 only
1 and 4
2, 2 and 4
4 only

⇒ The forms of IF statements in FORTRAN 77 are called
logical IF and Block IF
logical IF, block IF and arithmetic IF
logic IF, block IF, arithmetic IF and negate IF
logical IF and arithmetic IF

⇒ The V-I characteristic of a semi-conductor diode is shown in figure. From this figure it can be concluded
The diode is a silicon diode
The diode is a germanium diode
Break down voltage of the diode is 0.7 V
At 1 V rated current will pass through the diode

⇒ Vestigial sideband is most commonly used in
radio transmission
television transmission
telephony
all of the above

⇒ In the circuit shown in the given figure, power dissipated in the 5 Ω resisto
zero
80 W
125 W
405 W

⇒ Nichrome is commonly used for
lamp filaments
transformer winding
heater coils
battery connections

⇒ A series resonant circuit has R = 10 Ω, L = 1 μH and C = 1 mF. If R is increased to 20 Ω the resonant frequency
increases
decreases
remains constant
may increases or decreases

⇒ The root locus branches
start from open loop poles and terminate at zeros
start from open loop zeros and terminate at poles
may start from pole or zero and terminate at another pole or zero
none of the above

⇒ At half power frequencies the current in R-L-C series circuit is __________ times current at resonance
1/3
1/4
1/2
42737

⇒ The correct sequence of events to improve system stability is
insert derivative action, use negative feedback, reduce gain
reduce gain, use negative feedback, insert derivative action
reduce gain, insert derivative feedback, use negative feed back
use negative feedback, reduce gain, insert derivative action

⇒

Assertion (A): When excited by a unit step voltage, an inductor behaves as open circuit at t = 0.

Reason (R): Inductance has the property of inertia.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The application of gate signal decreases the break over voltage of on SCR.
TRUE
FALSE

⇒ A single phase semiconverter has a freewheeling diode. If the firing angle is a and the load is purely resistive, the periods of conduction and freewheeling respectively are
p - a and 0
p - a and a
p + a and 0
p + a and a

⇒ In a three input AND gate A = 1, B = 1, C = 0 The output Y =
ABC
ABC
ABC
ABC

⇒

Assertion (A): The maximum range of a radar is proportional to fourth root of the peak transmitted pulse power.

Reason (R): Radar signals are subjected twice to inverse square law.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct