Question is ⇒ The emission of light is LED due to, Options are ⇒ (A) emission of holes, (B) emission of electrons, (C) generation of electromagnetic radiations, (D) conversion of heat energy into illumination, (E) , Leave your comments or Download question paper.

Question is ⇒ The emission of light is LED due to, Options are ⇒ (A) emission of holes, (B) emission of electrons, (C) generation of electromagnetic radiations, (D) conversion of heat energy into illumination, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The emission of light is LED due to
A.	emission of holes [Wrong Answer]
B.	emission of electrons [Wrong Answer]
C.	generation of electromagnetic radiations [Correct Answer]
D.	conversion of heat energy into illumination [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The circuit shown in figure, will act as an ideal current source with respect to terminals A and B, when frequenc
zero
1 rad/s
4 rad/s
16 rad/s

⇒ Macroscopic quantities of a given material
are absolutely constant
are a function of temperature
are a function of temperature, pressure field
none of the above

⇒ If a line is open circuited Z_in = Z₀ tanh (gl).
TRUE
FALSE

⇒ Assume that only x and y logic inputs are available. What is the minimum number of 2-input NAND gates required to implement x ⊕ y?
2
3
4
5

⇒ In the circuit shown in given figure, the values of i(0⁺) and I(∞), will be respecti
zero and 1.5 A
1.5 A and 3 A
3 A and zero
3 A and 1.5 A

⇒ In an impedance smith chart, a clockwise movement along a constant resistance circle gives rise to
decrease in the value of reactance
an increase in the value of reactance
no change in the reactance value
no change in the impedance value

⇒ A dc series motor is coupled to a load whose torque is proportional to speed. It is fed by a single phase ac supply through a full converter. When speed is 500 rpm, firing angle is 45°. It is desired to raise the speed. It will be necessary to
decrease the firing angle
increase the firing angle
either decrease or increase the firing angle depending on the required speed
decrease the load torque

⇒ The number of valence electrons in germanium atom is
4
2
1
zero

⇒ The ratio of the diffusion coefficient in a semiconductor has the units
V^-1
em.V^-1
V.cm^-1
V.s

⇒ In RAM, all the information can be obtained at the output with
minimum time delay
unequal time delay
nearly identical time delay
maximum time delay

⇒ It is desired that transmission line and load should match for a range of frequencies. The best method is
to use a balun
to use a single stub of adjustable position
to use a double stub
to use a broad band amplifier

⇒ Let f₁(t) = G₁(t) + 4, f₂(t) = G₂(t) + 3. If G₁(t) and G₂(t) are uncorrected then the correlation between f₁(t) and f₂(t) are
12
7
6
zero

⇒ The noise temperature of sky is about __________ °K.
100
273
0
30

⇒ It is required to measure temperature in the range of 1300-1520°C. The most suitable thermocouple is
chromel constantan
iron constantan
chromel aluminium
platinum-rhodium

⇒ A pre-emphasis circuit
boosts base frequencies
pre amplifies the complete audio band
amplifies higher audio frequencies
converts FM into phase modulation

⇒ In a conductor which of the following relations hold good?
∇ x D = r
∇ . D = r
∇ x D = 0
∇ . D = 0

⇒ In figure, the short circuit current through terminal AB wil
1.5 A
0.125
0.0833333333333333
0.0416666666666667

⇒ An FM transmitter has maximum frequency deviation of 75 kHz and reproduces audio signals up to 15 kHz. Minimum channel width required is __________ kHz.
180
120
90
60

⇒

Assertion (A): The output of a NOR gate is equal to the complement of OR of input variables.

Reason (R): A XOR gate is a universal gate.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The characteristic equation of an SR flip-flop in given by
Q_n+1 = S + RQ_n
Q_n+1 = RQ_n + SQ_n
Q_n+1 = S + RQ_n
Q_n+1 = S + RQ_n

⇒ The input impedance for folded dipole antenna (two half dipole) is
73 n²
377 n²
73 n
377 n

⇒ In which region of a CE bipolar transistor is collector current almost constant?
Saturation region
Active region
Breakdown region
Both saturation and active region

⇒

Assertion (A): A RAM with access time of the order of hundreds of nano seconds is suitable for a control memory.

Reason (R): The time taken to execute an operation in a microcomputer is critically de pendent on access time of control memory.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ A trigonometric series has
single sided spectra
zero
sync function
undefined

⇒ In PAL system
phase of U signal is reversed on alternating lines
phase of V signal is reversed on alternating lines
phases of both U and V signals are reversed on alternating lines
none of the above

⇒ As EM waves travel in free space they get
reflected
refracted
attenuated
absorbed

⇒ Forbidden energy gap in germanium at 0 K is about
10 eV
5 eV
2 eV
0.78 eV

⇒ In a number system with radix r, the decimal value of 110 is equal to 4r. The decimal values of 111 and r respective are equal to
20, 5
16, 4
13, 3
8, 2

⇒ Which one is Analog Continuous modulation technique?
AM
DM
PAM
PCM

⇒ Maximum efficiency of class B power amplifier is 50%.
TRUE
FALSE