Question is ⇒ <p>Match the following:</p><table cellpadding="0" cellspacing="0" border="0" class="matching"><tbody><tr><th width="5%"> </th><th>List I </th> <th width="5%"></th><th>List II </th></tr><tr><td>A.</td><td>Output of signal generator</td><td>1.</td><td>Modulated</td></tr><tr><td>B.</td><td>Error signal from a synchro</td><td>2.</td><td>Digital</td></tr><tr><td>C.</td><td>Output of a JK flip flop</td><td>3.</td><td>Analog</td></tr><tr><td>D.</td><td>Signal received by radar</td><td>4.</td><td>Stoichastic</td></tr></tbody></table>, Options are ⇒ (A) A-1, B-3, C-2, D-4, (B) A-3, B-1, C-2, D-4, (C) A-3, B-1, C-4, D-2, (D) A-1, B-3, C-4, D-2, (E) , Leave your comments or Download question paper.

Question is ⇒ <p>Match the following:</p><table cellpadding="0" cellspacing="0" border="0" class="matching"><tbody><tr><th width="5%"> </th><th>List I </th> <th width="5%"></th><th>List II </th></tr><tr><td>A.</td><td>Output of signal generator</td><td>1.</td><td>Modulated</td></tr><tr><td>B.</td><td>Error signal from a synchro</td><td>2.</td><td>Digital</td></tr><tr><td>C.</td><td>Output of a JK flip flop</td><td>3.</td><td>Analog</td></tr><tr><td>D.</td><td>Signal received by radar</td><td>4.</td><td>Stoichastic</td></tr></tbody></table>, Options are ⇒ (A) A-1, B-3, C-2, D-4, (B) A-3, B-1, C-2, D-4, (C) A-3, B-1, C-4, D-2, (D) A-1, B-3, C-4, D-2, (E) , Leave your comments or Download question paper. Previous question Next question

Q1.

Match the following:

	List I		List II
A.	Output of signal generator	1.	Modulated
B.	Error signal from a synchro	2.	Digital
C.	Output of a JK flip flop	3.	Analog
D.	Signal received by radar	4.	Stoichastic

A-1, B-3, C-2, D-4

A-3, B-1, C-2, D-4

A-3, B-1, C-4, D-2

A-1, B-3, C-4, D-2

View Answer 1 -1

Explanation:-
Answer : B
Discuss it below :

!! OOPS Login [Click here] is required to post your answer/result
Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The Darlington pair consists of the following two stages
CE and CC
both CE
both CC
CE and CB

⇒ The coil of a moving iron instrument has a resistance of 500 Ω and an inductance of 1 H. It reads 250 V when a 250 V dc is applied. If series resistance is 2000 Ω, its reading when fed by 250 V, 50 Hz ac will be
260 V
252 V
250 V
248 V

⇒ The open wired circuit in the given figure works
EX - NOR gate
AND gate
XOR gate
NOR gate

⇒ Isotropic radiator is one that radiates energy
uniformly in all direction
inside a hollow sphere
in a well defined isotropic direction
none of the above

⇒ In body centred cubic structure, comers and centre of the cube are occupied by identical atoms.
TRUE
FALSE

⇒ A balanced modulator is used in the generation of which of the following?
DSB-SC signal
FM signal
PM signal
PAM signal

⇒ A NOR gate is a combination of
OR gate and AND gate
AND gate and NOT gate
OR gate and NOT gate
two NOT gates

⇒ A receiver has poor selectivity. It will also have poor
sensitivity
double spotting
blocking
diversity reception

⇒ I-PD controlled system has
I, P and D actions in forward path
I, P and D actions in feedback path
I action in forward path but P and D action in feedback path
I action in feedback path but P and D actioins in forward path

⇒ If we need a low noise device, we should use
BJT
FET
thyristor
UJT

⇒ The radar cross-section of a target depends an
frequency
polarization of incident wave
aspect of target
all of the above

⇒ If interrupt service request have been received from all of the following interrupts, then which one will be serviced last?
RST 5.5
RST 6.5
RST 7.5
None of these

⇒ As compared to TTL, ECL has
lower power dissipation
lower propagation delay
higher propagation delay
higher noise margin

⇒ The Truth Table shown is f
CMO
counter
flip-flop
half adder

⇒ In a loss line R_L < Z₀, then
Reflection coefficient is zero
Reflection coefficient is ∞
Reflection coefficient is negative
Reflection coefficient is positive

⇒ In 8085 microprocessor, what is the memory address stored on the stack, when the program is interrup
0210 H
0.211 H
0118 H
020 FH

⇒ One of the function of the Sio₂ layer in an IC is to
act as a dielectric for capacitors
prevent shorting of elements by interconnections
from cathodes for diodes
afford protection from the radiations

⇒ Read the following statements about sets

If A and B are sets then A + B denotes union of sets A and B.
The union of A and B is that set whose elements are in either A or B or both.
If A and B are sets, then difference of sets A and B is denoted by A - B.
A - B in the set obtained by removing elements of A from B.

Which of the above are true?
All
1, 2 and 3 only
2 and 3 only
1 and 4 only

⇒ In intrinsic semiconductor, the fermi level
lies at the centre of forbidden energy gap
is near the conduction band
is near the valence band
may be anywhere in the forbidden energy gap

⇒ For an illumination control circuit it is advisable to use a matched TRIAC-DIAC pair.
TRUE
FALSE

⇒ A P-N junction offers
high resistance in forward as well as reverse direction
low resistance in forward as well as reverse direction
conducts in forward direction only
conducts in reverse direction only

⇒ The Z parameters Z₁₁ and Z₂₁ for the 2-port network in the fig
Z₁₁ = - 6/₁₁Ω; Z₂₁ = 16/₁₁Ω
Z₁₁ = 6/₁₁Ω; Z₂₁ = 4/₁₁Ω
Z₁₁ = 6/₁₁Ω; Z₂₁ = - 16/₁₁Ω
Z₁₁ = 4/₁₁Ω; Z₂₁ = 4/₁₁Ω

⇒ The potential of suppressor grid (with respect to cathode) is usually
zero
negative
positive
zero or positive

⇒ In microprocessor 8088
8 data bits are multiplexed with 8 least significant bits of address bus
8 data bits are multiplexed with 8 most significant bits of address bus
16 data bits are multiplexed with 16 bits of address bus
none of the above

⇒

Assertion (A): At a temperature of 1000 K, thermionic emission current is about 0.1 A/cm² of surface.

Reason (R): Thermionic emission current is given by I_th = SA₀ T² e^-Ew/kT.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ RESET OUT signal when high indicates that
program counter etc. are being set
program counter etc. are being reset
either (a) or (b)
none of the above

⇒ The function shown in the fig
impulse function
signum function
unit step function
none of the above

⇒ The number of leads in a DIAC are
2
3
4
6

⇒ A quiescent state of a transistor implies
zero bias
no output
no distortion
no input signal

⇒ Typical values of current gains for CE, CB and CC amplifiers are
120, 120 and 1 respectively
120, 1 and 120 respectively
1, 120 and 120 respectively
1, 1 and 120 respectively