Question is ⇒ Which of the following is a microwave power amplifier?, Options are ⇒ (A) Gunn diode, (B) Reflex klystron, (C) Magnetron, (D) Travelling wave tube, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following is a microwave power amplifier?, Options are ⇒ (A) Gunn diode, (B) Reflex klystron, (C) Magnetron, (D) Travelling wave tube, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following is a microwave power amplifier?
A.	Gunn diode [Wrong Answer]
B.	Reflex klystron [Wrong Answer]
C.	Magnetron [Wrong Answer]
D.	Travelling wave tube [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ As regards dielectric constant ε_r
the units are farads/m
the units are newton/coulomb
it is dimensionless
the units are farads

⇒ A vertical wire of 1 meter length carries a current of 1 A at 10 MHz. The total radiated power is nearly
0.13 W
0.88 W
7.3 W
73 W

⇒ In 8085, TRAP is
always maskable
cannot interrupt a service subroutine
used for catastrophic events like temporary power failure
lowest priority interrupt

⇒ Fourier transform of signal obtained after taking difference between step function and its reverse version is given as __________ .
2jω
2/jω
4/jω
4jω

⇒ Consider the following statements

An iron cored choke is non linear and passive device.
A carbon resistor kept in sunlight is a time invariant and passive device.
A dry cell is a time varying and active device.
An air capacitor is time invariant and passive device.

Of these statements
1, 2, 3 and 4 are correct
1, 2, 3 are correct
1, 2, 4 are correct
2 and 4 are correct

⇒ The 'h' parameters of the circuit shown in the figure are h_ib = 25 Ω, h_fb = 0.999 and h_ob = 10^-6Ω The Voltage gai
0.99
1.98
2
4

⇒

Assertion (A): Electronic and Ionic polarization in a polyatomic gas are independent of temperature.

Reason (R): The orientation polarization is independent of temperature.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ A lag compensator is essentially a
low pass filter
high pass filter
band pass filter
either (a) or (b)

⇒ Find current flowing through 1 H inductor at t = 0, at which switch 'S' is ope
0
2
3
5

⇒ Four terminal approach is used in measuring low resistance because it
eliminates thermoelectric energy
eliminates stray capacitance
eliminates stray inductance
eliminates the effect of leads and contacts

⇒ The channel required for FM telemetry is
same as required for AM telemetry
smaller than that required by AM telemetry
100 times that required for AM telemetry
10 times that required for AM telemetry

⇒

Assertion (A): A sweep circuit operates by virtue of recurring transient phenomenon.

Reason (R): Transients are always undesirable.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In a bridge rectifier circuit the rms value of input ac voltage is 10 V. The PIV across each diode is
7.07 V
14.14 V
10 V
28.28 V

⇒ The main advantage of TDM over FDM is that it
needs less power
needs less bandwidth
needs simple circuitry
gives better S/N ratio

⇒ The dielectric losses do not depend on frequency.
TRUE
FALSE

⇒ A network contains only independent current source and resistors. If the values of all resistors are doubled, the value of the node voltage
will become half
will remain unchange
will become one third
cannot be determined unless the circuit configuration and the values of the resistors are known

⇒

Assertion (A): In a parallel circuit having two branches, each branch current may be more than source current.

Reason (R): Calculations in ac circuits use rules of complex algebra.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ An electromagnetic wave can be completely guided by a dielectric rod or slab.
TRUE
FALSE

⇒ The h parameter h₁₁ is the same in CE and CC circuit.
TRUE
FALSE

⇒ The modulation index is, if f_m = 500 Hz, Δf = 2.25 kHz
2.25
4.5
9
18

⇒ For a good public address system the sound intensity at the farthest point should be at least
20 dB over threshold of hearing
40 dB over threshold of hearing
80 dB over threshold of hearing
120 dB over threshold of hearing

⇒ An homogeneous dielectric material is subjected to an electric field E. If a small cavity is made inside the material, the electric field intensity inside and outside the cavity are different.
TRUE
FALSE

⇒ A parallel ac circuit in resonance will
act like a resistor of low value
have a high impedance
have current in each section equal to the line current
have a high voltage developed across each inductive and capacitive section

⇒ The directive gain of λ/2 resonant wire is 1.64.
TRUE
FALSE

⇒ In a Hurwitz polynomial
all coefficients are non-negative
both the odd and even parts have roots on jω axis
the continued fraction expansion is the ratio of odd to even parts of a Hurwitz polynomial yields all positive quotient terms
all of the above

⇒ The thermionic emission current is given by
Fermi-Dirac distribution
Maxwell's equation
Richardson Dushman equation
Langmuir Child law

⇒ Which of the following addressing modes is used in the instruction PUSH B?
Direct
Register
Register Indirect
Immediate

⇒ If the reverse voltage across a p-n junction is increased three times, the junction capacitance
will decrease
will increase
will decrease by an approximate factor of about 2
will increase by an approximate factor of about 2

⇒ In TV transmitter, visual exciter may consist of

Video processing unit
Visual modulator
VSB filter
Delay equaliser
Frequency converter

Which of the above are actually a part of visual exciter?
1, 2 and 3
2, 3 and 4
1, 2, 3 and 4
1, 2, 3, 4 and 5

⇒ In a series resonant circuit Q is more than 10. Then the lower half power frequency ω₁, and resonant frequency ω₀ are related as
ω₁ = ω₀ + bandwidth
ω₁ = ω₀ + 0.5 (bandwidth)
ω₁ = ω₀ - 0.5 (bandwidth)
ω₁ = ω₀ + bandwidth