Question is ⇒ If all other parameters are the same, a capacitor with mica as dielectric has higher capacitance than air capacitor., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ If all other parameters are the same, a capacitor with mica as dielectric has higher capacitance than air capacitor., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If all other parameters are the same, a capacitor with mica as dielectric has higher capacitance than air capacitor.
A.	TRUE [Correct Answer]
B.	FALSE [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The inputs A, B, C of the given figure are applied to a 3 input NOR gate. The outpu
HIGH from 4 to 0
LOW from 0 to 4
HIGH from 0 to 1 and LOW from 1 to 4
LOW from 0 to 2 and HIGH from 2 to 4

⇒ MS Access is a DBMS software.
TRUE
FALSE

⇒ When a p-n-p transistor is properly biased to operate in active region the holes from emitter.
diffuse through base into collector region
recombine with electrons in base
recombine with electrons in emitter
none of the above

⇒ The device having highest photo sensitivity is
photoconductive cell
photovoltaic cell
photodiode
phototransistor

⇒ In CCD
a small charge is deposited for logical 1
a small charge is deposited for both logical 1 and 0
a small charge is deposited for logical 0 and large charge for logical 1
none of the above

⇒ An m derived and constant k filter section connected in cascade give
proper impedance matching
proper phase shift characteristic
proper attenuation characteristic
all of the above

⇒

Assertion (A): Static RAMS are used where speed of operation is of primary concern.

Reason (R): Dynamic RAM has lower cost per bit than static RAM.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒

Assertion (A): Class A and Class B amplifier predominate in audio applications.

Reason (R): Class C amplifier is used at radio frequencies.

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ An electromechanical closed loop control system has the following characteristics equation :s³ + 6Ks² + (K + 2)s
K = 0.528
K = 2
K = 0
K = -2528

⇒ The PCM signal shown below uses amplitude level of +1 volt and -1 volt to represent binary symbol 0 and 1 respectively. Each code word consists of 4 bits. The sampled version of analog signal from which this PCM signal is derived
EB596
CD231
DA495
25B6A

⇒ A single phase half wave rectifier is feeding a resistive load. As firing angle is increased
dc output voltage and rms output voltage decrease in the same proportion
dc output voltage and rms output voltage decrease
dc output voltage and rms output voltage increase
dc output voltage and rms output voltage increase in the same proportion

⇒ Noise can be reduced by increasing sampling rate
TRUE
FALSE
can't say
insufficient data

⇒ The frequency of the driving network connected between pins 1 and 2 of a 8085 chip must be
equal to the desired clock frequency
twice the desired clock frequency
four times the desired clock frequency
eight times the desired clock frequency

⇒ By placing an inverter between both inputs of an S-R flip-flop, the resulting flip-flop becomes
J-K flip-flop
D-flip-flop
T-flip-flop
Master salve JK flip-flop

⇒ Force = Electric intensity x current.
TRUE
FALSE

⇒ A carrier is modulated by two modulating waves A and B having modulation indices of 0.6 and 0.8 respectively. The overall modulation index is
1
0.7
0.2
1.4

⇒

Match the following:

	List I (μP)		List II (Number of bits in register)
A.	8085	1.	32 bit
B.	8086	2.	16 bit
C.	68000	3.	8/16 bit

A-1, B-2, C-3
A-2, B-3, C-1
A-3, B-2, C-1
A-3, B-1, C-2

⇒ The circuit consisting of two transistor connected in series with the d.c. supply voltage is called
push pull
differential pair
stacked V⁺
complementary symmetry

⇒ If a two port network is represented by an equivalent T network the admittance of series arm in term of ABCD parameter is equal to
C
1/C
(A - 1)/B
1/B

⇒ Consider the sequence x(n) whose fourier transform X(e^jω) is depicted for - p ≤ ω ≤ p as shown in fig
1 - True, 2 - True, 3 - True, 4 - True
1 - False, 2 - True, 3 - False, 4 - True
1 - True, 2 - False, 3 - True, 4 - False
1 - False, 2 - False, 3 - False, 4 - True

⇒ What is the frequency of audio modulation?
1000 Hz
2000 Hz
3000 Hz
2000 kHz

⇒ The radiation resistance of a λ/16 wire dipole in free space will be nearly
1 Ω
3 Ω
13 Ω
30 Ω

⇒ To ensure that only dominant TE₁₀ mode propagates in a rectangular waveguide, the operating frequency
must be more than cutoff frequency of TE₁₀ mode
must be less than cutoff frequency of TE₂₀ mode
must be more than cutoff frequency of TE₁₀ mode and less than cutoff frequency of TE₂₀ mode
must be less than cutoff frequency of TE₁₀ mode

⇒ For a type 1 system and unit parabolic input, the steady state error is
0
∞
1
1/K_v

⇒ When a reverse bias is applied to a p-n junction, the width of depletion layer.
decreases
increases
remains the same
may increase or decrease

⇒

Assertion (A): Rochelle salt and Barium titanate are both ferroelectric.

Reason (R): Ferroelectric materials exhibit hysteresis effect.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which mode has the minimum cutoff frequency in rectangular wave guides?
TE₁₁
TE₁₀
TE₀₁
TE₂₀

⇒ In 8085
RST 6.5 and RST 5.5 are high level sensitive interrupts
RST 6.5 and RST 5.5 are low level sensitive interrupts
RST 5.5 is low level sensitive interrupt but RST 5.5 is high level-sensitive interrupt
RST 5.5 is low level sensitive interrupt but RST 6.5 is high level sensitive interrupt

⇒

Match the following:

	List I (Operator)		List II (Description)
A.	? :	1.	Modulus
B.	[ ]	2.	Array expression
C.	%	3.	Conditional

A-3, B-2, C-1
A-1, B-2, C-3
A-1, B-3, C-2
A-2, B-3, C-1

⇒ In elemental dielectrics, the orientation and ionic polarization are absent.
TRUE
FALSE