Question is ⇒ A mod-2 counter followed by a mod 5 is same as, Options are ⇒ (A) mod-7 counter, (B) A decade counter, (C) mod-3 counter, (D) none, (E) , Leave your comments or Download question paper.

Question is ⇒ A mod-2 counter followed by a mod 5 is same as, Options are ⇒ (A) mod-7 counter, (B) A decade counter, (C) mod-3 counter, (D) none, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A mod-2 counter followed by a mod 5 is same as
A.	mod-7 counter [Wrong Answer]
B.	A decade counter [Correct Answer]
C.	mod-3 counter [Wrong Answer]
D.	none [Wrong Answer]
View Answer 6 -3 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following circuit has the greatest bandwidth?
f_r = 455 MHz; Q = 10
f_r = 455 MHz; Q = 100
f_r = 1 MHz; Q = 100
f_r = 1 MHz; Q = 10

⇒ Optical encoders most commonly used in control systems are
absolute encoders
secondary encoders
incremental encoders
none of the above

⇒ The number of valence electrons in silicon atom is
4
2
1
zero

⇒ The characteristic equation of a feedback control system is given by s³ + 5s² + (K + 6)s + K
(- 3, 0)
(- 2, 0)
(- 1, 0)
(2, 0)

⇒ In the circuit, V_s = 10 cos ωt, power drawn by the 4Ω resistor is 8 watt. The power facto
1
0.5
0.85
0

⇒ In which condition does BJT behave like a closed switch?
Cut off
Saturation
Forward active
Reverse active

⇒ Frequency range for satellite communication is
1 kHz to 100 kHz
100 kHz to 10 MHz
10 MHz to 100 MHz
1 GHz to 30 GHz

⇒ A class A transformer coupled power amplifier is to deliver 10 W output. The power rating of transistor should not be less than
5 W
10 W
20 W
40 W

⇒ For any given two port network, any parameter set can be determined from measurements made at the two ports.
TRUE
FALSE

⇒ In a resistor the current is i and the voltage is v. The rate of dissipation of heat at any time t is
vi
vit
vt
vit²

⇒ In the given figure the reflected current wave after first reflectio
0.18 A
-0.18 A
0.3 A
-0.3 A

⇒ The depletion layer width of Junction
decreases with light doping
is independent of applied voltage
is increased under reverse bias
increases with heavy doping

⇒ The shot circuit admittance matrix of a two port network is
non-reciprocal and passive
non-reciprocal and active
reciprocal and passive
reciprocal and active

⇒ The use of thermocouple meters for ac measurement leads to a scale which is
linear
square law
logarithmic
exponential

⇒ Which of the following terminations makes the input impedance of a line equal to characteristic impedance Z₀?
line open circuited at far end
line terminated in Z₀
line short circuited at far end
line terminated in inductance

⇒ In 8085 microprocessor, which of the following is not vectored interrupt?
RST 5.5
RST 6.5
RST 7.5
INTR

⇒ The resonant frequency of an R_F amplifier is 1 MHz and its bandwidth is 10 kHz. The Q factor will be
10
100
0.01
0.1

⇒ A square current wave of magnitude 1 A is applied to an element for 5 seconds. The voltage across the element rises linearly from 0 to final value linearly. The element is
resistance
inductance
capacitance
R and C in series

⇒ It is required to measure temperature in the range of 1300-1520°C. The most suitable thermocouple is
chromel constantan
iron constantan
chromel aluminium
platinum-rhodium

⇒ To draw dc equivalent circuit for a CE amplifier circuit we should
Reduce all ac sources to zero
Open all capacitors
Reduce all ac sources to zero and open all capacitors
Reduce all ac sources to zero and short all capacitors

⇒ A narrow band FM does not have the following feature
it has two sidebands
both sideband equal in magnitude
both sideband have same Phase Difference
it does not show Amplitude variation

⇒ A signal having uniformly distributed amplitude in the interval (- V to + V) is to be encoded using PCM with uniform quantization. The signal to quantization noise ratio is determined by
dynamic range of signal
sampling rate
number of quantizing levels
power spectrum of signal

⇒ In a BJT amplifier circuit the size of coupling capacitor depends on
lowest frequency
highest frequency
average of lowest and highest frequencies
none of the above

⇒ In a power amplifier the collector current flows for 270° of the input cycle. The operations is
class A
class B
class AB
class C

⇒ Which device uses Pneumatic fluid?
LED
LCD
VF display
None of these

⇒

Assertion (A): It is not desirable to drive a transistor into hard saturation in high speed switching circuits.

Reason (R): It may not be possible to bring it back to cutoff state, if it is driven into hard saturation.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which is the dominant mode in rectangular waveguides?
TE₁₀
TE₁₁
TE₀₁
TM₁₁

⇒ Which of the following statement about modulation is correct?
It avoid use of antennas
It reduces bandwidth
It ensures transmission over long distances
It combines different transmissions

⇒ A signal is x + f(t) where x is constant and f(t) is a power signal with zero mean value. The power of the signal is
x²
x² + f²(t)
more than x² + f²(t)
less than x² + f²(t)

⇒ In an R-L-C circuit, v(t) = 20 sin (314 t + 5 p/6) and i(t) = 10 sin (314 t + 2p/3). The p.f of the circuit is
0.5 lead
0.866 lag
0.866 lead
0.5 lead