Question is ⇒ During fast forward operation of a tape recorder, Options are ⇒ (A) all heads are withdrawn, (B) all amplifiers are shut off, (C) tape is not pressed against capstan, (D) all of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ During fast forward operation of a tape recorder, Options are ⇒ (A) all heads are withdrawn, (B) all amplifiers are shut off, (C) tape is not pressed against capstan, (D) all of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	During fast forward operation of a tape recorder
A.	all heads are withdrawn [Wrong Answer]
B.	all amplifiers are shut off [Correct Answer]
C.	tape is not pressed against capstan [Wrong Answer]
D.	all of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The emission of light is LED due to
emission of holes
emission of electrons
generation of electromagnetic radiations
conversion of heat energy into illumination

⇒

Assertion (A): A JFET behaves as a resistor when V_GS < V_P.

Reason (R): When V_GS < V_P, the drain current in a JFET is almost constant.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a platinum RTD, the change in resistance for a temperature rise of 50° C is about
0.02
0.1
0.2
0.4

⇒ If the oscillator output is modulated by audio frequencies upto 10 kHz, the frequency range occupied by the side bands will be
711.9 kHz to 712.1 kHz
702 kHz to 722 kHz
692 kHz to 732 kHz
71.2 kHz to 71.20 kHz

⇒ As per Boolean algebra, inputs can be interchanged in
OR gates
AND gates
both OR and AND gates
none of the above

⇒ The time constant of the circuit after the switch shown in the figure is opene
0.2 s
5 s
0.1 s
dependent on R and hence cannot be determined unless R is known

⇒ A conditionally stable system has
one phase crossover frequency
two phase crossover frequencies
two or more phase crossover frequencies
one or more phase crossover frequencies

⇒ The range of visible light is
300 to 2000 Å
200 - 4000 Å
4000 to 7700 Å
more than 10000 Å

⇒ For the logic circuit of the given figure the simplified Boolean expressio
Y = AB + A C
Y = (AB) (A C)
Y = ABC
Y = A B + A C

⇒ If q is charge on an electron, R is radius of electron orbit and ω is angular velocity of electron rotation, the magnetic dipole moment of electron in orbit is
0.5 qωR
0.5 q²ω²R²
0.5 qωR²
0.5 qω²R

⇒ If W_F is the Fermi level, then in a metal at T = 0
all energy levels above W_F filled, all those below W_F are empty
all energy levels below W_F are filled, all those above W_F are empty
some energy levels, both below and above W_F, are filled
all energy levels below and above W_F are filled

⇒

Assertion (A): Even if TTL gates and CMOS gates used in a realization have the same power supply of + 5 V, suitable circuit is needed to interconnect them

Reason (R): V_OH, V_OL, V_IH and V_IL of a TTL gave are respectively 2.4, 0.4, 2 and 0.8 V respectively. If supply voltage is + 5 V. V_IL and V_IH for CMOS gate for the supply voltage of + 5 V are 1.5 V and 3.5 V respectively.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ If operator 'a' = 1 ∠120° then (1 + a²) =
3
3 ∠30°
3 ∠ - 30°
3 ∠60°

⇒ Final value theorem is used to find
steady state value of system output
initial value of output
transient beaviour of output
none of these

⇒ If F = 95.0 what will be the result of following FORTRAN 77 program? 35
35
25
25

⇒

Assertion (A): The scale a PMMC ammeter is linear.

Reason (R): The deflecting torque of PMMC is proportional to current in the coil.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ T-flip-flop is commonly used as
a delay switch
a digital counter only
a digital counter and frequency divider
any of the above

⇒ In a loss line R_L < Z₀, then
Reflection coefficient is zero
Reflection coefficient is ∞
Reflection coefficient is negative
Reflection coefficient is positive

⇒ For satellite transmission, analog signals may be converted into digital form with the help of
modem
transponder
codec
compandor

⇒ For maximum output the width of air gap of audio head should be
equal to wavelength
half the wavelength
one quarter the wavelength
very small as compared to wavelength

⇒ Surface waves can propagate on Piezoelectric substrates.
TRUE
FALSE

⇒ The noise figure of klystron amplifier is about
25 dB
3 dB
zero
1 dB

⇒ Which junction has least junction capacitance?
Alloy
Grown
Diffused
Point contact

⇒ For a system with transfer funct
2.828
5.2915
5.088
cannot be determined

⇒ The function H (s) is positive real if
H (s) has no poles or zeros in right half plane
The poles of H(s) on the imaginary axis are simple with real and positive residues
Re [H(jω)] ≥ 0 for 0 ≤ ω ≤ ∞
all of the above

⇒ If the energy gap of a semiconductor is 1.1 eV, then it would be.
opaque to the visible light
transparent to the visible light
transparent to the ultraviolet radiation
opaque to the infrared radiation

⇒ The expression A ** B / C + D is equivalent to
AB / C + D
AB / C + D
AB / (C + D)
None of the above

⇒ With the switch in STOP position, Y will be equa
0
1
CLK
none of these

⇒ In a flip flop which input determines the state to which output will transistion?
Control input
Clock input
Both control and clock input
Either control or clock input

⇒ Consider the amplitude modulated (AM) signal A_c cos ω_ct + 2 cos ω_mt cos ω_ct For demodulating the signal using envelope detector, the minimum value of A_c should be
2
1
0.5
0