Question is ⇒ Assertion (A): Silicon is the most favoured semiconductor material.Reason (R): PIV for silicon diode is more than that for germanium diode., Options are ⇒ (A) Both A and R are true and R is correct explanation of A, (B) Both A and R are true but R is not correct explanation of A, (C) A is true but R is false, (D) A is false but R is true, (E) , Leave your comments or Download question paper.

Question is ⇒ Assertion (A): Silicon is the most favoured semiconductor material.Reason (R): PIV for silicon diode is more than that for germanium diode., Options are ⇒ (A) Both A and R are true and R is correct explanation of A, (B) Both A and R are true but R is not correct explanation of A, (C) A is true but R is false, (D) A is false but R is true, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Assertion (A): Silicon is the most favoured semiconductor material. Reason (R): PIV for silicon diode is more than that for germanium diode.
A.	Both A and R are true and R is correct explanation of A [Wrong Answer]
B.	Both A and R are true but R is not correct explanation of A [Wrong Answer]
C.	A is true but R is false [Correct Answer]
D.	A is false but R is true [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The output V-I characteristics of an Enhancement type MOSFET has
only an ohmic region
only a saturation region
an ohmic region at low voltage value followed by a saturation region at higher voltages.
an ohmic region at large voltage values. Preceded by a saturation region at lower voltages.

⇒ Pirani gauge is used to measure
very low pressure
high pressure
pressure in the range of 1 atmosphere
fluid flow

⇒ In cable TV local programmes can be telecast at any frequency.
TRUE
FALSE

⇒ The most effective anti jamming technique is
frequency hopping
spread-spectrum modulation
key leverage
once-only key

⇒ A moving iron instrument can be used for
dc only
ac only
both dc and ac
dc and high frequency ac

⇒ SSB can be generated by
filter method
phase cancellation method
good attenuation characteristics
all of the above

⇒ A modem is
a form of commutator
a device for digitizing speech
a circuit used for suppressing microwave mterference
an electronic circuit which carries out modulation and demodulation of a carrier frequency

⇒ In figure, the switch is closed at t = 0. After some time i = 6A and rate of change of current was 4A/s. The value of inducto
1 H
1.5 H
indeterminate
0.5 H

⇒ An op-amp is fed from a signal source through resistance R₁. If it is to work as sign changer, the feedback resistance R_f should be
equal to R₁
twice R₁
half R₁
either (b) or (c)

⇒ The phase angle of lead circuit is
between 0 and -90°
between 0 and +90°
90°
more than 90°

⇒ For an amplifier the input output signals are shown in figure. The class of amplifie
A
AB
B
C

⇒ The feedback control system shown in figure is stable for what values of K and
K < 0, T > - 1
K > 0, T > 0
K > 0, T > - 1
K < 0, T > 0

⇒ What is typical bandwidths of a 2-wire telephone line?
300 Hz to 3.4 kHz
20 Hz to 4 kHz
dc to 4 kHz
20 Hz to 20 kHz

⇒ The most widely used diode rectifier circuit is
half wave
full wave with centre tapped transformer
bridge
either (a) or (b)

⇒ Which of following is recursive system?
y(n - 1)
y(n + 1)
y(n)
y(n) + y(n + 1)

⇒ Wood is a diamagnetic material.
TRUE
FALSE

⇒ For matrix A, A^-1 A = 1
TRUE
FALSE

⇒ Brownian motion is
random emission of electrons in vacuum tubes
thermal motion of electrons in a resistance
random diffusion of holes and electrons in semi- conductors
both (b) and (c)

⇒ Noise with uniform power spectral density of N₀ω/H_z is passed through a filter H(ω) = 2 exp (-J ω t_y) followed by an ideal low pass filter of bandwidth B Hz. The output noise power in watts is
2 N₀B
4 N₀B
8 N₀B
16 N₀B

⇒ In the given fi
0 rad/sec
2 rad/sec
3/2 rad/sec
None of these

⇒ Computers use RC circuit for edge triggering.
TRUE
FALSE

⇒ A linear displacement digital transducer generally uses
straight binary code
BCD
gray code
hexadecimal code

⇒

Match the following:

	List I		List II
A.	Resistance	1.	M^-1L^-2T⁴I²
B.	Inductance	2.	ML²T^-2I^-2
C.	Capacitance	3.	ML²T^-3I²

A-1, B-2, C-3
A-2, B-1, C-3
A-2, B-3, C-1
A-3, B-2, C-1

⇒ In a network containing resistances, reactances the root of the characteristic equation give for the circuit
the forced response
the total response
the natural response
the damped response

⇒ A microprocessor uses 3 MHz oscillator. The duration of one T state is
1 μs
0.666 μs
0.333 μs
3 μs

⇒ In a semi converter feeding a resistive load,
the waveshapes of input voltage and input current are always similar
the waveshapes of input voltage and input current can never be similar
the waveshapes of input voltage and input current are similar only if firing angle is zero
the waveshapes of input voltage and input current are similar only if firing angle is high

⇒ Consider the equation s² + 2s + 2 + K(s + 2) = 0. Where do the roots of this equation break on the root loci plot?
-3.414
-2.414
-1.414
-0.414

⇒ A clipper
adds a dc component to the input signal
removes signal voltages above or below a specified value
both (a) and (b)
either (a) or (b)

⇒ For measuring inductance with high Q, we should use
Maxwell's bridge
Maxwell Wien bridge
Hay's bridge
Either (a) or (b)

⇒ A cycloconverter is a group of controlled rectifiers.
TRUE
FALSE