Question is ⇒ Material which lack permanent magnetic dipoles are known as, Options are ⇒ (A) paramagnetic, (B) diamagnetic, (C) ferromagnetic, (D) ferrimagnetic, (E) , Leave your comments or Download question paper.

Question is ⇒ Material which lack permanent magnetic dipoles are known as, Options are ⇒ (A) paramagnetic, (B) diamagnetic, (C) ferromagnetic, (D) ferrimagnetic, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Material which lack permanent magnetic dipoles are known as
A.	paramagnetic [Wrong Answer]
B.	diamagnetic [Correct Answer]
C.	ferromagnetic [Wrong Answer]
D.	ferrimagnetic [Wrong Answer]
View Answer 2 -3 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If h₁[n] = 3δ[n] + δ[n - 1], h₂[n] = 2δ[n] + δ[n
{6, 18, 7, 4, 0, - 6, 9}
{9, 0, - 6, 21, 7, 6, 1}
{7, - 1, 3, 1, 7, 0, 6}
{9, - 6, 0, 1, 21, 7, 18, 6}

⇒ In figure, the charge on 0.8 μF capacito
100 μC
50 μC
40 μC
20 μC

⇒ A choke coil has a resistance to reactance ratio of 0.2. The power factor of the choke coil is
less than 0.2 lagging
less than 0.2 leading
about 1
about 0

⇒ Which of the following noise does not occur in transistors?
Partition noise
Shot noise
Flicker noise
Resistance noise

⇒ In a microprocessor the clock signal
is always generated internally
is always supplied externally
may be generated internally or supplied externally
is mostly supplied externally

⇒ In a N-P-N transistor of the emitter junction is reverse biased and collector junction is also reversed biased, the transistor will operate in
active region
saturation region
cut-off region
inverted region

⇒ In an intrinsic semiconductor, the intrinsic charge concentration at any absolute temperature T is proportional to
T
T²
T³
T⁴

⇒ State transition table and state transition diagram form part of design steps for
combinational circuits
sequential circuits
delay circuits
all of the above

⇒ At present, the radio-frequency band mainly used by most satellites is
EHF
UHF
VHF
SHF

⇒

Match the following:

	List I (Modes)		List II (Characteristic)
A.	Evanescent	1.	Rectangular waveguide does not support
B.	Dominant mode	2.	No wave propagation
C.	TM₁₀ and TM₀₁	3.	Lowest cut-off frequency

A-1, B-2, C-3
A-2, B-3, C-1
A-1, B-3, C-2
A-2, B-1, C-3

⇒ LCD uses
nematic crystals
sematic crystals
cholesteric crystals
twisted nematic crystal

⇒ The no. of FF required and the maximum decimal no. of a MOD-12 counter is
12, 12
4, 11
3, 6
4, 10

⇒ A sinusoidal signal is measured by CRO. The scale is set at 4 mV/cm. If vertical distance between positive and negative peaks is 6 cm, the peak value of ac signal is
6 mV
12 mV
24 mV
3 mV

⇒ A two branch parallel tuned circuit has a coil of resistance 100 Ω and inductance 0.005 H in one branch and 10 nF capacitor in the second branch. At resonance frequency, the dynamic resistance is
1 Ω
10 Ω
100 Ω
more than 100 Ω

⇒ The coil of a moving iron instrument has a resistance of 500 Ω and an inductance of 1 H. It reads 250 V when a 250 V dc is applied. If series resistance is 2000 Ω, its reading when fed by 250 V, 50 Hz ac will be
260 V
252 V
250 V
248 V

⇒ Magnetic hysteresis phenomenon is explained by
motion of domain walls
motion of domain walls and domain rotation
domain rotation
none of the above

⇒ The spectral component of noise associated with k^th frequency is given, in the limit as Δf → 0 by n_k(t) written as n_k(t) = C_k cos (2pk Δft + θ_{k1, 2 only
1, 3 only
1, 2, 3
2, 3 only}

⇒ Pick the odd one out
PPM
PDM
PWM
PLM

⇒ In which frequency range is the noise figure in a transistor minimum
intermediate frequencies
low frequencies
high frequencies
very high frequencies

⇒ The adjustment of position of shading bands, in an energy meter, is done to provide
friction compensation
creep compensation
braking torque
none of the above

⇒ Lines of magnetic field attract each other.
TRUE
FALSE

⇒ The 8085 instruction 'PUSH PSW' belongs to the group
data transfer
arithmetic
logic
none of the above

⇒ What is the address space of 8086 CPU?
One Megabyte
256 Kilobytes
1 K Megabytes
64 Kilobytes

⇒ F₂ layer of atmosphere extends from
250 km to 400 km
150 km to 250 km
50 km to 150 km
15 km to 50 km

⇒ Television receiver antenna is usually
loop type
yagi antenna
parabolic dishes
none of the above

⇒ In band III of TV, distant reception (beyond line of sight range) is possible due to
tropospheric bending by refraction
reflection of waves
ionospheric scattering
none of the above

⇒ 1274₁₆ - 3A7₁₆ = __________ .
ACA₁₆
ACB₁₆
ECD₁₆
AAA₁₆

⇒ The tape recorders used in homes have
common head and common amplifier system for recording and playback
different heads and amplifiers for recording and playback
same head but different amplifiers for recording and playback
different heads but same amplifier for recording and playback

⇒ When an electron breaks a covalent bond and moves away,
a hole is created
a proton is also lost
atom becomes an ion
rest of the electron move at a faster rate

⇒ In a 5 x 7 dot matrix, format, to store 64 alphanumeric characters we require
1120 bits
2240 bits
33 bits
64 bits