Question is ⇒ A material which is lightly repelled by a magnetic field is known as, Options are ⇒ (A) diamagnetic material, (B) non-magnetic material, (C) ferromagnetic material, (D) paramagnetic material, (E) , Leave your comments or Download question paper.

Question is ⇒ A material which is lightly repelled by a magnetic field is known as, Options are ⇒ (A) diamagnetic material, (B) non-magnetic material, (C) ferromagnetic material, (D) paramagnetic material, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A material which is lightly repelled by a magnetic field is known as
A.	diamagnetic material [Correct Answer]
B.	non-magnetic material [Wrong Answer]
C.	ferromagnetic material [Wrong Answer]
D.	paramagnetic material [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A series RL circuit is excited by a voltage v(t) = V_msin (ωt + Φ). The transient current will be zero if
Φ = 0
ω = 0
Φ = tan^-1 (ωL/R)
ω - tan^-1 (ωL/R) = p/2

⇒ The FM broadcast band is from
550 to 1600 kHz
88 to 108 kHz
88 to 108 MHz
1600 kHz to 59.75 MHz

⇒ Soft iron is suitable for making temporary magnets.
TRUE
FALSE

⇒

Match the following:

	List I (μP)		List II (Number of bits in register)
A.	8085	1.	32 bit
B.	8086	2.	16 bit
C.	68000	3.	8/16 bit

A-1, B-2, C-3
A-2, B-3, C-1
A-3, B-2, C-1
A-3, B-1, C-2

⇒ A FET is to be operated as voltage variable resistor. For this drain to source voltage V_DS should be,
74
= V_P
< V_P
> V_P

⇒ The read and write cycle times of cache memory are in the range of
1 - 3 ns
25 ns - 45 ns
200 ns - 300 ns
1 μs

⇒ An ac circuit has two branches in parallel. The impedances of the two branches are equal. The p.f. of one branch is 0.8 lagging and 0.8 leading. The overall p.f. is
zero
0.5 lagging
1
0.7 lagging

⇒ The current through a 1 mH inductance is i(t) = 2.56 x 10^-2 - 4 x 10³ t for 2 ≤ t ≤ 20 μ sec. The voltage across the inductor is
4
8
0
8 x 10³

⇒ In a PCM system, if we increase the quantization levels from 2 to 8, how do the relative bandwidth requirements vary?
Get doubled
Get tripled
Remains same
Become eight times

⇒ If the target cross-section is changing, the best scanning system for accurate tracking is
lobe switching
monopulse
sequential lobing
conical scanning

⇒

Assertion (A): In some materials, ∈_r is independent of temperature while in others, ∈_r depends on temperature.

Reason (R): If permanent dipoles are absent, ∈_r varies with temperature.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a series RC circuit Z = (R² + ω²C²)^0.5.
TRUE
FALSE

⇒ The resonance frequency is
ω_r = a
ω_r = b
ω_r = k
ω_r = ba

⇒ It is desired that transmission line and load should match for a range of frequencies. The best method is
to use a balun
to use a single stub of adjustable position
to use a double stub
to use a broad band amplifier

⇒ Measurement of Hall coefficient enables the determination of
mobility of charge carriers
type of the conductivity and concentration of charge carriers
temperature coefficient and thermal conductivity
fermi level and forbidden energy gap

⇒ An oscillator requires an amplifier
with negative feedback
with positive feedback
with either positive or negative feedback
none of the above

⇒ Which of the following is not correct in C?
6 / 4 = 1
2 / 5 = 0
2.0 / 5 = 0
2.0 / 5.0 = 0.4

⇒

Assertion (A): Microprocessor 8085 has on-chip oscillator with inbuilt crystal.

Reason (R): For frequency stability crystal oscillator is preferred.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Light dependent resistor is
photo resistive device
photo voltaic device
photo emissive device
either (a) or (c)

⇒ If E_b, the energy per bit of a binary digital signal is 10^-6 watt sec. and the one sided power spectral density of the white noise N₀ = 10^-5 W/Hz, then the output SNR of the matched filter is
26 dB
10 dB
20 dB
13 dB

⇒ The beam of a radar should be
very narrow
very wide
neither too narrow nor very wide
either (b) or (c)

⇒ If e = 110 sin (ωt + p/3) and i = 5 sin (ωt - p/3), the impedance of the circuit is
22 Ω
16 Ω
30.8 Ω
11 Ω

⇒ The converter whose conversion time is independent of number of bits is
dual stope
counter type
parallel conversion
successive approximation

⇒ The most commonly used magnetron is
cylindrical
parallel plate
inclined plate
flat plate

⇒ Zero bias works only with
D MOSFETs
E MOSFETs
both D and E MOSFETs
neither D nor E MOSFETs

⇒ An ac network has a power factor of 0.8 leading if the applied wave is of fundamental frequency. If the applied wave contains third and fifth harmonics, the overall power factor will be
0.8 leading
less than 0.8 leading
more than 0.8 leading
0.8 leading or more

⇒ In a self bias circuit for CE amplifier the collector supply voltage is made twice. The collector current will
decrease
increase
remain the same
increase or decrease

⇒ An ammeter of 0-25 A range has a guaranteed accuracy of 1% of full scale reading. The current measured is 5 A. The limiting error is
0.02
0.025
0.04
0.05

⇒ A function will have only sine terms if
f(t) = - f(t)
f(-t) = f(t)
f(-t) = -f(t)
none of the above

⇒ In a semi converter feeding a resistive load,
the waveshapes of input voltage and input current are always similar
the waveshapes of input voltage and input current can never be similar
the waveshapes of input voltage and input current are similar only if firing angle is zero
the waveshapes of input voltage and input current are similar only if firing angle is high