Question is ⇒ A crystal is frequently used in digital circuits for timing purpose because of its, Options are ⇒ (A) low cost, (B) high frequency stability, (C) simple circuitry, (D) ability to set frequency at desired value, (E) , Leave your comments or Download question paper.

Question is ⇒ A crystal is frequently used in digital circuits for timing purpose because of its, Options are ⇒ (A) low cost, (B) high frequency stability, (C) simple circuitry, (D) ability to set frequency at desired value, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A crystal is frequently used in digital circuits for timing purpose because of its
A.	low cost [Wrong Answer]
B.	high frequency stability [Correct Answer]
C.	simple circuitry [Wrong Answer]
D.	ability to set frequency at desired value [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If the load current is high, the pressure coil of wattmeter should be connected directly across the load.
TRUE
FALSE

⇒ Which of the following statement is correct?
FET and junction transistor both are unipolar
FET and junction transistor both are bipolar
The FET is bipolar, while junction transistor are unipolar
The FET is unipolar, while junction transistor are bipolar

⇒ The radiation resistance of a doublet antenna of length dl is proportional to
δ l
(δ l)²
(δ l)³
(δ l)⁰⁵

⇒

Match the following:

	List I (Operator in C)		List II (Priority of Operation)
A.	!	1.	1
B.	< >	2.	2
C.	∗	3.	3
D.	=	4.	4

A-1, B-2, C-3, D-4
A-1, B-3, C-2, D-4
A-4, B-3, C-2, D-1
A-3, B-2, C-1, D-4

⇒ Two voltmeters are each 0-300 V range. Their internal resistances are 10 kΩ and 20 kΩ They are connected is series and a voltage of 400 V is applied. Their readings respectively will be
266.6 and 133.3 V
133.3 and 266.6 V
200 V each
100 and 300 V

⇒ For iron, the ferromagnetic Curie temperature is
about 20 K
about 100°C
about -20°C
about 1000 K

⇒ Consider the following digital circu
1 and 2
3 and 4
1, 2 and 3
1, 2, 3 and 4

⇒ During forward blocking state of SCR, the voltage and current respectively are
high and high
low and low
high and low
low and high

⇒ The minimum sampling frequency in sample/sec. required to reconstruct the following signal from its samples wuthout distor
2 x 10³
4 x 10³
6 x 10³
8 x 10³

⇒ A 10 bit ADC with a full scale output voltage of 10.24 V is to be designed to have ± LSB/2 accuracy. If ADC is calibrated at 25°C, the maximum net temperature coefficient of ADC should not exceed
± 200 μV/°C
± 400 μV/°C
± 600 μV/°C
± 800 μV/°C

⇒ In a CRO the Y plates are oriented
horizontally
vertically
at an angle of 20° of horizontal
at an angle of 70° of horizontal

⇒ A generated voltage is equally dependent on three resistances R₁, R₂, R₃ and its value is V = (R₁R₂)/R₃. If tolerance of each resistor is 0.1%, the maximum error in voltage is
0.003
± 0.3%
0.001
± 0.1%

⇒ In a 3 input NAND gate, the number of states in which output is 1 equals
8
1
6
5

⇒ Which of the following is a valid integer variable in FORTRAN 77?
ALPHA
NEXT
BANGLORE
ABC

⇒ In a tape recorder the erase head is
engaged during playback but disengaged during recording
engaged both during recording and playback
disengaged both during recording and playback
engaged during recording but disengaged during playback

⇒ A 750 A circuit uses thyristor of current rating 175 A. If derating is 25%, the number of thyristors in parallel is
3
4
6
10

⇒ The volt ratio box is basically a
potential divider
current transformer
a high resistance voltmeter
either (a) or (c)

⇒ An intrinsic silicon sample has 2 million free electrons. The number of holes in the sample is
2 million
almost zero
more than 2 million
less than 2 million

⇒

Assertion (A): The main use of Miller integrator is to generate ramp

Reason (R): An inverting amplifier can handle more than one input at the same time.

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In which of the following circuits is op-amp used in open loop configuration?
Comparator
Summing amplifier
Integrating amplifier
Logarithmic amplifier

⇒ If a fuse is higher than required current rating is employed in a circuit, it will
blow more frequently since it carries more current
afford better protection to the circuit
seriously overload the circuit
lead to larger maintenance cost

⇒ At night the ionosphere can be considered to be consisting of
D, E, F₁ and F₂ layers
D, E, F₁ layers
D, E, F₂ layers
E and F₂ layers

⇒ For transmission line load matching over a range of frequencies, it is best to use a
double stub
balun
single stub of adjustable position
broadband directional coupler

⇒ A balun provides an impedance transformation of
0.667361111111111
0.334027777777778
0.167361111111111
0.0840277777777778

⇒ For an ideal transformer
only Y parameter exist
only Z parameter
Z, Y both exist
neither Z parameter nor Y parameter exist

⇒

Assertion (A): Laplace transform can be used to evalute integrals.

Reason (R): Laplace transform can be used to solve differential equations.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A T.V. station works at 300 MHz and radiates 100 kW of power. This signal received at a distance of 200 km will be
a few μV/m due to attenuation by atmosphere
1-5 mV due to ionospheric reflection
nil since propagation is line of sight
nil because signal fades completely at 300 MHz

⇒ 4 bit ripple counter and 4 bit synchronous counter are made using flip-flop having a propagation delay of 10 ns each. If the worst case delay in the ripple counter and the synchronous counter be R and S respectively, then
R = 10 ns, S = 40 ns
R = 40 ns, S = 10 ns
R = 10 ns, S = 30 ns
R = 30 ns, S = 10 ns

⇒ In a 50 cm TV tube, a path difference of 2 km between direct wave and interfering wave would mean a displacement between main image and ghost image equal to
0.3 cm
3 cm
6 cm
9 cm

⇒ Which of the following laws of electromagnetic theory is associated with the force experienced by two loops of a wire carrying currents?
Maxwell's law
Coulomb's law
Ampere's law
Laplace's law