Question is ⇒ The typical squelch circuit, Options are ⇒ (A) cuts off an IF amplifier when the AGC is maximum, (B) cuts off an IF amplifier when the AGC is minimum, (C) cuts off an audio amplifier when the carrier is absent, (D) eliminates the RF interference when the signal is weak, (E) , Leave your comments or Download question paper.

Question is ⇒ The typical squelch circuit, Options are ⇒ (A) cuts off an IF amplifier when the AGC is maximum, (B) cuts off an IF amplifier when the AGC is minimum, (C) cuts off an audio amplifier when the carrier is absent, (D) eliminates the RF interference when the signal is weak, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The typical squelch circuit
A.	cuts off an IF amplifier when the AGC is maximum [Wrong Answer]
B.	cuts off an IF amplifier when the AGC is minimum [Wrong Answer]
C.	cuts off an audio amplifier when the carrier is absent [Correct Answer]
D.	eliminates the RF interference when the signal is weak [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If a system is to follow arbitrary inputs accurately the bandwidth should be
large
small
very small
neither small nor large

⇒ Consider the following applications

TV tuning
Active filter
Microwave frequency multiplication

In which of above can a varactor diode be used?
1 2 and 3
l and 2 only
1 and 3 only
2 and 3 only

⇒ If the frequency of a wave 20 Hz, the time period is
20 secs
2 secs
0.2 secs
0.05 secs

⇒ Which chopper circuit operates in all the 4 quadrants?
A
C
D
E

⇒ Ferroelectric materials are those which
cannot be polarized
have a permanent polarization
have a_e equal to zero
have μ_p = 0

⇒ The bandwidth of an amplifier can be reduced by
miller effect compensation
pole zero compensation
dominant pole compensation
lead compensation

⇒ RC network shown in the given figure can provide a maximum theoretical phase shif
90°
180°
270°
360°

⇒ Double spotting in a receiver is due to
poor sensitivity of RF amplifier
high gain of IF amplifier
inadequate image frequency rejection
all of the above

⇒ In electronic voltmeters the measuring device is a
moving coil instrument
moving iron instrument
dynamometer instrument
none of the above

⇒ In figure which is correct at any time t
I = i_R + i_L
I = i_R + i_L i_C
I = i_R + i_L - i_C
I = i_R - i_L - i_C

⇒ A minimum function has
poles and zeros on imaginary axis of s plane
no poles or zeros on imaginary axis of s plane
only poles but no zeros on imaginary axis of s plane
only zeros but no poles on imaginary axis of s plane

⇒
Assertion (A): ECL is fast as compared to TTL.
Reason (R): ECL dissipates less power than TTL.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ If ωε is the displacement current factor and s is conduction current density factor then which of the following statements is incorrect?
For a lossless dielectric σ = 0
For an imperfect dielectric σ = 0
For a dielectric ωε >> σ
For a semiconductor ωε = σ

⇒ Which of the following noise becomes of great importance at high frequencies?
Transit-time noise
Shot noise
Flicker noise
Agitation noise

⇒ In modern MOSFET_S, the material used for the gate is
high purity silicon
high purity silica
heavily doped polycrystalline silicon
epitaxial grown silicon

⇒ For signal diodes the PIV rating is usually in the range
1 V to 10V
10 V to 30V
30 V to 150V
150 V to 400V

⇒ Flash ADC is
serial ADC
parallel ADC
series-parallel ADC
successive approximation ADC

⇒ In figure readings of the two voltmeters shoul
100 V on each meter
200 V on each meter
150 V on V₁ and 50 V on V₂
50 V on V₁ and 150 V on V₂

⇒ A single phase energy meter operates on induction principle.
TRUE
FALSE

⇒ Which of the following statements is correct?
Convex lens has positive focal power and concave lens have negative focal power
Convex lens has negative focal power and concave lens have positive focal power
All lens have positive focal power
All lens have negative focal power

⇒
Assertion (A): Direct coupled amplifiers are rarely used
Reason (R): Direct coupled amplifiers suffer from the disadvantage of drift

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Dielectric constant of transformer oil is about
1
4
10
20

⇒ In broadcast television, the number of lines per frame is chosen to be odd number to
reduce the required bandwidth
improve resolution
reduce peak power requirement
make interlacing easier

⇒ If interrupt service request have been received from all of the following interrupts, then which one will be serviced last?
RST 5.5
RST 6.5
RST 7.5
None of these

⇒ Unit step is a
energy signal
power signal
neither energy nor power signal
none

⇒ If the AF voltage is raised to 10 V, while the AM is dropped to 200 Hz, what is the deviation?
10 kHz
15 kHz
20 kHz
40 kHz

⇒ The number of comparator circuits required to build a three-bit simultaneous A/D converter is
7
8
15
16

⇒ An AC source or RMS voltage 20V with internal impedance Z_s = (1 + 2j) Ω feeds a load of impedance Z_L = (7 + 4j) Ω in the figure below. The reactive power consumed by the loa
8 VAR
16 VAR
28 VAR
32 VAR

⇒ In a flip flop which input determines the state to which output will transistion?
Control input
Clock input
Both control and clock input
Either control or clock input

⇒ The main drawback in the performance of shunt peaked wide band amplifier is
two low gain at low frequency
poor phase response
reduce frequency at middle frequency
that the maximum gain of the stage is small

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math