Question is ⇒ In figure, E = 1 V (rms value). The average power is 250 mW. Then phase angle between E and, Options are ⇒ (A) 90°, (B) 60°, (C) 45°, (D) 30°, (E) , Leave your comments or Download question paper.

Question is ⇒ In figure, E = 1 V (rms value). The average power is 250 mW. Then phase angle between E and, Options are ⇒ (A) 90°, (B) 60°, (C) 45°, (D) 30°, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In figure, E = 1 V (rms value). The average power is 250 mW. Then phase angle between E and
A.	90° [Wrong Answer]
B.	60° [Correct Answer]
C.	45° [Wrong Answer]
D.	30° [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a minimum phase system
all poles lie in the left half plane
all zeros lie in the left half plane
all poles lie in the right half plane
all except one pole or zero lie in the left half plane

⇒ The magnitude plot of a rational transfer function G(s) with real coefficients is shown below. Which of the following compensators has such a magnitude p
Lead compensator
Lag compensator
PID compensator
Lead-lag compensator

⇒ Which among the following waveforms can be reconstructed from its samples without distort
1 and 2
2 and 3
1 and 3
Only 2

⇒ Pick the odd one
variance
standard deviation
expectation
chebyshev inequality

⇒

Assertion (A): Field emission is substantially independent of temperature.

Reason (R): When a high electric field is created at metal surface field emission may occur.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a receiver, which of the following device has IF input but RF output?
Demodulator
Loudspeaker
Audio amplifier
Frequency changer

⇒ A wire strain gauge has a gauge factor of 2, resistance of 125 Ω and length 1 m. If length of wire changes by .005 m, change in resistance will be
0.25 Ω
0.5 Ω
1.25 Ω
2.5 Ω

⇒ When a line of any odd multiple of a quarter wavelength is short-circuited it represents
unit impedance
infinite impedance
zero impedance
none of the above

⇒ M circles are symmetrical with respect to real axis.
TRUE
FALSE

⇒ Power gain of antenna equals directive gain in VHF and UHF range if and only if efficiency of the antenna is
0.25
0.5
0.75
1

⇒ Thyristors are suitable for dc circuit breakers but not for ac circuit breakers.
TRUE
FALSE

⇒ A transistor has a power rating of 8 W for a case temperature of 25°C. If derating factor is 30 mW/°C, the power rating for 55°C, case temperature is
8 W
7.5 W
7.1 W
6.8 W

⇒ An S/N ratio of 3 expressed in db is
4.8 dB
2.4 dB
0.48 dB
0.24 dB

⇒ In a loss less line the propagation constant is equal to
jωLC
LC
jωLC
LC

⇒ The time needed by a TTL circuit to switch from 0 to 1 or 1 to 0 is about
10 μs
10 ns
100 μs
50 ns

⇒ Which of these devices is used in relaxation oscillator?
UJT
SCR
DIAC
TRIAC

⇒ In Modulation, "carrier" is
resultant wave
speech voltage to be transmitted
voltage with constant frequency, phase or amplitude
voltage for which frequency, phase or amplitude is varied

⇒ The polar plot of a transfer function passes through (-1, 0) point. The gain margin is
zero
- 1 dB
1 dB
infinity

⇒ The figures shows the symbo
p channel depletion MOSFET
p channel enhancement MOSFET
complementary MOSFET
p channel JFET

⇒

Assertion (A): Potentiometers can not be used as error detectors in position control systems.

Reason (R): The resolution of a potentiometer places an upper limit on its accuracy

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ The input gate current of a FET is
a few amperes
a few milli amperes
a few micro amperes
negligible

⇒ A TRIAC can be turned on :
by applying a positive signal to gate
by applying a negative signal to gate
by applying either positive or negative signal to gate
none of the above

⇒ Final value theorem is used to find
steady state value of system output
initial value of output
transient beaviour of output
none of these

⇒ In a voltage regulated power supply the zener operates in the breakdown region when (V_in is input voltage and V_z is zener breakdown voltage)
V_in < V_z
V_in > V_z
V_in = V_z
both (a) or (b)

⇒ Transistor T₁ operates at 30 kHz and T₂ operates at 300 Hz. The flicker noise is
not depend on frequency
T₁ > T₂
T₁ = T₂
T₁ < T₂

⇒ What are the ultimate purpose of minimizing logic expressions?

To get small size expression.
To reduce the number of variables in the given expression.
To implement the function of the logic expression with least hardware.
To reduce the expression for making it feasible for hardware implementation.

Select the correct answer from the codes given below:
1 only
2 and 3
3 only
3 and 4

⇒ The baud rate is
always equal to the bit transfer rate
equal to twice the bandwidth of an ideal channel
not equal to the signalling rate
equal to one half the bandwidth of ideal channel

⇒ An RC series circuit is charged by a voltage E. After a long time the battery is removed and a short circuit is placed across R-C. Then
the polarity of voltage across R is same during discharge and during charge
the polarity of voltage across R during discharging is opposite to that during charging
the polarity of voltage across R depends on time constant RC
none of the above

⇒ A current of 1 A in the coil of an iron cored electromagnet causes B = 0.5T. If current is 2A, B =
0.5 T
1 T
1 T or more
1 T or less

⇒ Master control facility (MCF) for INSAT-2 series satellites is located at
Madras
New Delhi
Leh
Hassan