Question is ⇒ In the given circuit, the switch is open for a long time. At time <i>t</i> = 0, the switch is closed. What are the initial and final values of voltages across the induc, Options are ⇒ (A) 0 V and 0 V, (B) 0 V and 80 V, (C) 80 V and 0 V, (D) 80 V and 80 V, (E) , Leave your comments or Download question paper.

Question is ⇒ In the given circuit, the switch is open for a long time. At time <i>t</i> = 0, the switch is closed. What are the initial and final values of voltages across the induc, Options are ⇒ (A) 0 V and 0 V, (B) 0 V and 80 V, (C) 80 V and 0 V, (D) 80 V and 80 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In the given circuit, the switch is open for a long time. At time t = 0, the switch is closed. What are the initial and final values of voltages across the induc
A.	0 V and 0 V [Wrong Answer]
B.	0 V and 80 V [Wrong Answer]
C.	80 V and 0 V [Correct Answer]
D.	80 V and 80 V [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For maximum output the width of air gap of audio head should be
equal to wavelength
half the wavelength
one quarter the wavelength
very small as compared to wavelength

⇒ In an AM transmitter after the modulation stage, class C amplifier
can be used
cannot be used
may be used, but it has no use
can't be determine to use

⇒ The number of bits in EBCDIC is
12
10
8
6

⇒ A periodic voltage has following values for equal time intervals changing suddenly from one value to next : 0, 5, 10, 20, 50, 60, 50, 20, 10, 5, 0, - 5, - 10
42.2 V
19.098 V
38.2 V
none of these

⇒ A(A + B) =
A
A B
AB
AB

⇒ Magnetisation of a material is the magnetic dipole moment per m³.
TRUE
FALSE

⇒ In AM receiver the oscillator frequency is
always equal to signal frequency
always equal to 455 kHz
always higher than signal frequency
always lower than signal frequency

⇒

Assertion (A): A graph is planar if it has a dual.

Reason (R): The dual of a graph can be found by window dot method.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ An active network has
an e.m.f source
a current source
neither of the above
either (a) or (b)

⇒ The seven bit Hamming code received is 0010001. If even parity has been used, the correct code is
10001
1110001
110001
11001

⇒ An 8085 microprocessor based system uses a 4 k x 8 bit RAM whose address in AAOOH. The address of the last byte in this RAM is
OFFFH
1000H
B9FFH
BA00H

⇒ In a NAND SR latch S = R = 1. Then
Q = 1, Q = 0
Q = 0, Q = 1
both Q and Q will be same as before
the latch will be set

⇒ Figure shows characteristics curves for bipolar transistor. These curves
output characteristics of n-p-n transistor (common base)
output characteristics of p-n-p transistor (common base)
output characteristics of n-p-n transistor (common emitter)
output characteristics of p-n-p transistor (common emitter)

⇒ The cascade amplifier is a multistage configuration of
CC-CB
CE-CB
CB-CC
CE-CC

⇒ The function H (s) is positive real if
H (s) has no poles or zeros in right half plane
The poles of H(s) on the imaginary axis are simple with real and positive residues
Re [H(jω)] ≥ 0 for 0 ≤ ω ≤ ∞
all of the above

⇒ Which of the following configuration has low thermal stability?
CB
CC
CE
All have identical thermal stability

⇒ In an R-C circuit, the impedance is 40 Ω at a frequency of 100 Hz. At 200 Hz the impedance should be
40 Ω
80 Ω
20 Ω
more than 20 Ω but less than 40 Ω

⇒ In an amplifier the stray capacitances assume impedance at low frequencies
TRUE
FALSE

⇒ A temperature sensistive transducer is subjected to sudden temperature change. It takes 10 seconds for transducer to reach equilibrium condition (five times time constant). The time taken to reach half of temperature difference will be
1.38 s
5 s
8.62 s
0.9 s

⇒ A TV receiver has a width of 60 cm. The aspect ratio is 4/3. The required EHT supply is about
29 kV
2.9 kV
45 kV
4.5 kV

⇒ Consider the following C program int
All
1, 2, 3 only
2, 3, 4 only
1, 2, 4 only

⇒ Minimum number of J-K flip-flop needed to construct a BCD counter is
2
3
4
5

⇒ If the Q of a single-stage single-tuned amplifier is doubled, then its bandwidth will
remain same
become half
become doubled
become four times

⇒ The problem of logic race occurs in
SOP functions
POS functions
Hybrid function
SOP and POS functions

⇒ Maximum effective aperture (A_e)max of short dipole antenna is
1.119 λ²
0.119 λ²
1.19 λ²
1.919 λ²

⇒ Which of the following contributes to harmonics distortion in amplifiers?
Positive feedback
Presence of noise
Defective active device
Non-linearity in active device

⇒ Semiconductor ROM's are sometimes preferred to semiconductor RAM's because
ROM's are cheaper than RAMs
ROMs are faster
ROMs do not require power supply for their operations
Programs stored in ROMs cannot be altered either by the power failure or by the user

⇒ The most commonly used logic family is
ECL
TTL
CMOS
PMOS

⇒ The dimension of flux density is
MT^-1Q^-1
MT^-2
MT¹Q¹
MT^-1Q^-2

⇒ The register set and instruction set of 8088 is similar to that of
8085
8086
partly 8085 and partly 8086
none of the above