Question is ⇒ Which of the following computer memories is fastest?, Options are ⇒ (A) Cache, (B) Primary, (C) Mass storage, (D) Off line back up, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following computer memories is fastest?, Options are ⇒ (A) Cache, (B) Primary, (C) Mass storage, (D) Off line back up, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following computer memories is fastest?
A.	Cache [Correct Answer]
B.	Primary [Wrong Answer]
C.	Mass storage [Wrong Answer]
D.	Off line back up [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The phase velocity of an EM wave propagating in a hollow metallic rectangular waveguide in the TE₁₀ mode is
equal to its group velocity
less than the velocity of light in free space
equal to the velocity of light in free space
greater than the velocity of light in free space

⇒ In case of frequency modulation, modulating voltage remains constant if the modulating frequency is lowered, then
amplitude of distant sidebands decreases
amplitude of distant sidebands increases
amplitude of distant sidebands remains constant
amplitude of distant sidebands first increases, then decreases

⇒ The poles and zeros of a positive real function
may lie any where in s plane
may have positive or negative real part
must occur in conjugate pair
must have either negative or zero real part

⇒ In figure as the load resistance is cha
the zener current remain constant
the load current remains constant
the output voltage remains constant
the output voltage and current through R remain constant

⇒ The characteristic equation of a closed loop system is (s + 2) (s + 3) + K = 0. The centroid of the asymptotes in root locus is:
2.5
-2.5
0.5
-0.5

⇒ Consider z transform of a signal as given b
IIR
FIR
Depends on value of n
Cannot determined

⇒ For a bit rate of 8 kbps, the best possible values of the transmitted frequencies in a coherent binary FSK system are
16 kHz and 20 kHz
20 kHz and 32 kHz
20 kHz and 40 kHz
32 kHz and 40 kHz

⇒ DeMorgan's first theorem shows the equivalence of
OR gate and Exclusive OR gate
NOR gate and Bubbled AND gate
NOR gate and NAND gate
NAND gate and NOT gate

⇒ According to maximum power transfer theorem, the maximum power is absorbed by one network from another network when
the impedance of one of the networks is half that of the other
the impedance of one is the complex conjugate of the other
the impedance of one is equal to that of the other
none of the above

⇒ Point out the wrong statement, Sequential logic circuit is
one that requires a clock to change states
one in which past affects the present states
one whose outputs changes immediately when the inputs change
also called clock logic or synchronous logic

⇒ Consider the following sys
System I has larger bandwidth and faster speed of response than System II
System II has larger bandwidth and faster speed of response than System I
System I has larger bandwidth but System II has faster speed of response
System II has larger bandwidth but System I has faster speed of response

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will register A and (CY) contain after CMA?
6 AH, 1
6 AH, 0
59 H, 0
9 H, 0

⇒ An electron in a homogeneous magnetic field and having velocity perpendicular to the direction of field moves
perpendicular to the field
along the field
along a straight line inclined at 45° to field
in a circular path

⇒ Find the radiation resistance of an antenna of length λ/10 meter?
8 Ω
780 Ω
7.8 Ω
78 Ω

⇒ Which of these commutation methods uses an external pulse for commutation?
Class A
Class C
Class E
Class F

⇒ If a class C power amplifier has an input signal with frequency of 200 kHz and the width of collector current pulses of 0.1 ms, then the duty cycle of the amplifier will be
0.01
0.02
0.1
0.2

⇒ Two sinusoidal signals of equal amplitude and frequency are applied to X and Y plate of CRO respectively. The observed Lissajous pattern is a straight line. The phase shift between signals is
zero
90°
either zero or 180°
either 90° or 270°

⇒ A woofer should be fed from the input through a
low pass filter
high pass filter
band pass filter
band stop filter

⇒ Which one of the following gives maximum probability of error?
ASK
DPSK
FSK
PSK

⇒ The most commonly used system of modulating for telegraphy is
single tone modulation
on-off keying
frequency shift keying
pulse code modulation

⇒ To realize following function 'f'
3
6
4
10

⇒ Which of the following addressing modes is used in the instruction PUSH B?
Direct
Register
Register Indirect
Immediate

⇒
Assertion (A): The forward dynamic resistance of p-n diode varies inversely with current.
Reason (R): The forward dynamic resistance of p-n diode varies with the operating voltage.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The power in the signal s(t) = 8 cos (20 p - p/2) + 4 sin (15 pt) is
40
41
42
82

⇒ In a specimen of silicon steel, a field strength of 200 A/m causes a flux density of 0.5 T. In a specimen of cast iron, the same H would cause B to be
0.5 T
less than 0.5 T
more than 0.5 T
0.5 T or more or less

⇒ The eign values of n x n matrix A are the root of the characteristic equation 1λI - AI = 0
TRUE
FALSE

⇒ If i = 10 + 12 cos 500t - 3.5 sin 500 t, then in amplitude phasse form i =
10 + 12.5 sin (500 t + 106.20°)
5 + 12.5 sin (500 t + 106.20°)
10 + 11 sin (500 t + 106.20°)
10 + 12.5 sin (500 t + 10°)

⇒ A 1 kHz sinusoidal signal is ideally sampled at 1500 samples/sec and the sampled signal is passed through an ideal low pass filter with cut off frequency 800 Hz. The output signal has the frequency.
0 Hz
0.75 kHz
0.5 kHz
0.25 kHz

⇒
Assertion (A): When an SCR is conducting, the voltage drop across is about 1 V.
Reason (R): When an SCR is conducting, the junction temperature is about 200°C.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The Z inverse of the given Z transform i
unit step
unit impulse
unit ramp
unit parabola

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math