Question is ⇒ A 3 bit binary adder should use, Options are ⇒ (A) 3 full adders, (B) 2 full adders and 1 half adder, (C) 1 full adder and 2 half adders, (D) 3 half adders, (E) , Leave your comments or Download question paper.

Question is ⇒ A 3 bit binary adder should use, Options are ⇒ (A) 3 full adders, (B) 2 full adders and 1 half adder, (C) 1 full adder and 2 half adders, (D) 3 half adders, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A 3 bit binary adder should use
A.	3 full adders [Wrong Answer]
B.	2 full adders and 1 half adder [Correct Answer]
C.	1 full adder and 2 half adders [Wrong Answer]
D.	3 half adders [Wrong Answer]
View Answer 3 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): When V_DS is more than rated value the drain current in a JFET is very high.

Reason (R): When V_DS is more than rated value, avalanche breakdown occurs.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ In telephone, the dial tone has a frequency of
5 Hz
15 Hz
33 Hz
233 Hz

⇒ The open loop gain of an amplifier is 50 but likely to decrease by 20% due to various factors. If negative feedback with β = 0.1 is used, the change in gain will be about
0.2
0.02
0.005
0.0005

⇒ Which of the following does not cause losses in optical fibre cables?
Stepped index operation
Impurities
Microbending
Attenuation in glass

⇒ Which of the following real expressions is correct in Pascal?
- Z + P * X
(X + Y) (A + B)
Z ** M
Z P * M

⇒ When a lead acid battery is fully charged the colours of its positive and negative plates are
grey and dark brown
dark grey and brown
grey and brown
dark brown and grey

⇒ Consider the following reasons for using antenna coupler

To prevent illegal radiation of spurious frequencies
To tune out reactive components of antenna impedance
To have correct value of load impedance for transmitter.

Which of the above are correct?
1, 2, 3
1, 2
1 only
2, 3

⇒ Transformer coupling in transistor amplifier circuits provides high efficiency, because
d.c. resistance is low
collector voltage is stepped up
flux linkages are incomplete
all of the above

⇒ When an electron breaks a covalent bond and moves away,
a hole is created
a proton is also lost
atom becomes an ion
rest of the electron move at a faster rate

⇒ Which one is correct option?
Phase velocity is greater than light velocity
Group velocity is greater than light velocity
Phase velocity is equal to group velocity
Phase velocity is less than light velocity

⇒ Which of the following amplifiers has a voltage gain of less than 1?
CE
CC
CB
CE or CB

⇒ Using 4-bit numbers (n = 4) if k = 0011₂, how is k expressed in 2's complement?
1011₂
1101₂
1100₂
0101₂

⇒ How much is contributed by each bit in the code word of a PCM system under uniform and symmetric quantization to the signal to noise ratio?
3 dB
4 dB
5 dB
6 dB

⇒ Maximum usable frequency is [f_muf]
f_c sec i
f_c cos i
f_c sin i
f_c sec i

⇒ An electron in a homogeneous magnetic field and having velocity perpendicular to the direction of field moves
perpendicular to the field
along the field
along a straight line inclined at 45° to field
in a circular path

⇒ Which of the following represents the equivalent circuit of a crystal for crystal oscilla
Figure A
Figure B
Figure C
None of the above

⇒ An air-filled rectangular waveguide has dimensions 8cm x 10cm . The phase velocity of guided wave at frequency of 3 GHz for TE₁₀ mode is
1.5 x 10⁸ m/s
5.5 x 10⁸ m/s
3.46 x 10⁸ m/s
0.18 x 10⁷ m/s

⇒ Audio-signal modulates a 125 MHz carrier, causing a frequency deviation of 5 kHz. The bandwidth of the narrowband FM signal is __________ kHz.
10
8
9
20

⇒ Parabolic and lens antenna used at
microwave frequency
medium frequency
low frequency
high frequency

⇒ Intrinsic concentration of charge carriers in a semiconductor varies as
T
T²
T³
T^-2

⇒ Symbol shown in figure represen
P-channel DMOSFET
N-channel DMOSFET
UJT with P-type base
UJT with N-type base

⇒ Which factor determines whether the medium is free space, lossless dielectric, lossy dielectric or good conductor?
Attenuation constant
Constitutive parameters (σ, μ, ε)
Loss tangent
Reflection coefficient

⇒ Consider the real expression in Pascal language XZ and MP + K
XZ + Y and MP + K
(MP + K + X) / Y
Y / (MP + K)

⇒

Match the following:

	List I (Power device)		List II (Max. frequency)
A.	Power Bipolar	1.	MHz
B.	Power MOSFET	2.	100 kHz
C.	SCR	3.	10 kHz
D.	Insulated gate bipolar transistor	4.	1 kHz

A-2, B-1, C-3, D-4
A-3, B-4, C-2, D-1
A-3, B-1, C-4, D-2
A-4, B-1, C-3, D-2

⇒ A logarithmic amplifier has diode in the feedback path.
TRUE
FALSE

⇒ The turn off time of a bipolar transistor is about
0.5 ns
10 ns
70 ns
150 ns

⇒ Which of the following is multiband HF receiving antenna?
Square loop
Log-periodic
Conical horn
Folded dipole

⇒ A 16 bit counter type ADC uses 1 MHz clock then its maximum conversion time is __________ .
16 μs
15 ms
6.6 ms
66 ms

⇒ A single turn loop is situated in air, with a uniform magnetic field normal to its plane. The area of the loop is 5 m² and the rate of change of flux density is 2 Wb/m²/s. What is the emf appearing at the terminals of the loop?
-5 V
-2 V
-0.4 V
0 V

⇒ The resistance of a dc galvanometer is 20 Ω. A current of 10 mA causes full scale deflection. To convert it into 0-300 V voltmeter, we have to use a series resistance of
30000 Ω
29980 Ω
6000 Ω
15 Ω