Question is ⇒ An FM signal is modulated by an 8 kHz sine wave and has maximum and minimum frequencies of 100.05 MHz and 99.95 MHz respectively. Its deviation frequency is, Options are ⇒ (A) 100 kHz, (B) 100 MHz, (C) 500 kHz, (D) 108 kHz, (E) , Leave your comments or Download question paper.

Question is ⇒ An FM signal is modulated by an 8 kHz sine wave and has maximum and minimum frequencies of 100.05 MHz and 99.95 MHz respectively. Its deviation frequency is, Options are ⇒ (A) 100 kHz, (B) 100 MHz, (C) 500 kHz, (D) 108 kHz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An FM signal is modulated by an 8 kHz sine wave and has maximum and minimum frequencies of 100.05 MHz and 99.95 MHz respectively. Its deviation frequency is
A.	100 kHz [Wrong Answer]
B.	100 MHz [Wrong Answer]
C.	500 kHz [Wrong Answer]
D.	108 kHz [Correct Answer]
View Answer 3 -5 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following parameters of CE circuit has the unit of ohms?
h_ie
h_re
h_fe
h_oe

⇒ A low-pass filter frequency responce H (jω) = A (ω) e^jΦ(ω) does not produce any phase distortion, if
A(ω) = Cω², Φ (ω) = kω³
A(ω) = Cω², Φ (ω) = kω
A(ω) = Cω², Φ (ω) = kω²
A(ω) = C, Φ (ω) = kω^-1

⇒ A capacitor does not allow sudden changes
in currents
in voltage
in both current and voltage
neither of two

⇒ In 8086 the flag which enables or disables external interrupts is
IF
DF
TF
CF

⇒ A signal is sampled at Nyquist rate f_s = 2f₀. The function can be recovered from its samples only. If it is a
Periodic square wave of fundamental frequency f₀
Triangular wave of fundamental frequency f₀
Periodic sine wave of fundamental frequency f₀
Unit impulse function

⇒ SHF range is
30 - 300 MHz
300 - 3000 MHz
3000 - 30000 MHz
30000 - 300000 MHz

⇒ For determining the network functions of a two-port network, it is required to consider that
all initial conditions remain same
all initial conditions are zero
part of initial conditions are equal to zero
initial conditions vary depending on nature of network

⇒ Consider the following statements as regards SAW filter

The centre frequency is determined by the pitch of IDT comb shaped electrodes
The response can be modified shaping the overlap of comb electrodes
The response is maximum when acoustic wave has its wavelength equal to pitch
When a number of identical electrodes are arranged at the same pitch, the frequency characteristics of the filter is expressed by (sin x)/x

Which of the above statements are correct?
1, 2, 3, 4
1, 2, 3 only
1, 2, 4 only
2, 3, 4 only

⇒ The emf of a Weston cell is 1.286 V.
TRUE
FALSE

⇒ While drawing vector diagram for a series circuit, the reference vector is
voltage
current
power
phase angle

⇒ The number of switching functions of 3 variables are
3
8
16
32

⇒ It is necessary to measure the amplitudes of two signals and also the phase difference between them. This can be done by using a
phase meter
waveform meter
vector voltmeter
digital voltmeter

⇒ In the network shown in figure, the voltage drops across R₂ and R₃ are 10 V and 16 V with polarities as shown. The current in R_{1is 9 A and directed towards node 0
is 9 A and directed away from node 0
is 9 A but directed of current cannot be found
is impossible to be found}

⇒

Assertion (A): The surge current which an SCR can withstand is much higher than rms on state current.

Reason (R): The duration of surge current is very small.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In a rectifier only a portion of input power is converted into DC power. The rest is AC power.
TRUE
FALSE

⇒ Roughly the time required for microwave cooking as compared to conventional cooking is
about twice
about half
about 10 times
about one-tenth

⇒ The dominant mode in a rectangular wave-guide is
TE₀₁
TM₀₁
TE₁₀
TM₁₁

⇒ Two similar coils have self inductance of 1 mH each. Coefficient of coupling is 0.5. The mutual inductance M is
0.25 mH
0.5 mH
0.707 mH
1 mH

⇒ The multiplication time for 10-bit numbers with 1 MHz clock will be
32 μ sec
20 μ sec
21 μ sec
22 μ sec

⇒ If the target cross-section is changing, the best scanning system for accurate tracking is
lobe switching
monopulse
sequential lobing
conical scanning

⇒ In a broadcast superheterodyne receiver
the local oscillator operates below the signal frequency
local oscillator frequency is normally double the IF
RF amplifier normally works at kHz above the carrier frequency
mixer input must be tuned to the signal frequency

⇒ For iron, the ferromagnetic Curie temperature is
about 20 K
about 100°C
about -20°C
about 1000 K

⇒ In figure I_D = 4 mA. Then V_{GS4.4 V
-4.4 V
0.44 V
-0.44 V}

⇒ The induced magnetic dipole moment has a direction opposite to the applied magnetic field.
TRUE
FALSE

⇒ The normal operation of JFET is
constant voltage region
constant current region
both constant voltage and constant current regions
either constant voltage or constant current region

⇒ In sound recording the degree of pre-emphasis is about 6 dB/ octave.
TRUE
FALSE

⇒ A series RLC circuit has a resonant frequency of 1000 Hz. The maximum voltage across C is likely to occur at a frequency of about
1000 Hz
2000 Hz
1025 Hz
975 Hz

⇒ ADM stands for
Angle Delta Modulation
Angle Digital Modulation
Adaptive Delta Modulation
Adaptive Digital Modulation

⇒ A transconductance amplifier has
high input impedance and low output impedance
low input impedance and high output impedance
high input and output impedance
low input and output impedance

⇒ Class C amplifier is suitable for
a narrow frequency band
a wide frequency band
audio frequencies
either (b) or (c)