Question is ⇒ In FORTRAN 77 FLOAT (-28) gives the value, Options are ⇒ (A) 28, (B) -28, (C) -28, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ In FORTRAN 77 FLOAT (-28) gives the value, Options are ⇒ (A) 28, (B) -28, (C) -28, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In FORTRAN 77 FLOAT (-28) gives the value
A.	28 [Wrong Answer]
B.	-28 [Wrong Answer]
C.	-28 [Correct Answer]
D.	none of the above [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A 4 bit modulo 16 ripple counter uses JK flip-flops. If the propagation delay of each FF is 50 ns. The max. clock frequency that can be used is equal to
20 MHz
10 MHz
5 MHz
4 MHz

⇒ Schottky clamping is resorted to in TTL gates
to reduce propagation delay
to increase noise margin
to increase packing density
to increase fan out

⇒ The open loop gain of an amplifier is 50 but likely to decrease by 20% due to various factors. If negative feedback with β = 0.1 is used, the change in gain will be about
0.2
0.02
0.005
0.0005

⇒ For a sine wave the average value is calculated over half the cycle.
TRUE
FALSE

⇒ A periodic voltage has following value for equal time intervals changing suddenly from one value to next... 0, 5, 10, 20, 50, 60, 50, 20, 10, 5, 0, -5, -10 etc. Then rms value of the waveform is
31 V
32 V
insufficient data
none of these

⇒ The address to which a software or hardware restart branches is known as
Vector location
SID
SOD
TRAP

⇒

Match the following:

	List I		List II
A.	lag compensation	1.	Exterior of unit circle \|z\| = 1
B.	lead compensation	2.	PD control
C.	stability	3.	Non-minimum phase
D.	Instability	4.	Left half s plane
		5.	PI control

A-2, B-5, C-1, D-3
A-3, B-1, C-2, D-5
A-1, B-2, C-3, D-4
A-5, B-2, C-4, D-1

⇒ Cross-over distortion behaviour is a characteristic of
class A output stage
class B output stage
class AB output stage
common base output stage

⇒ The measure of mismatch between the load and the transmission line is known as
directivity
Gain
standing wave ratio
reflection coefficient

⇒ The current wave shape shown in figure (1) is applied to a circuit element. The voltage across the element is shown in figure (2). The element
R
L
C
Semiconductor

⇒ In memory mapped I/O means that
an input or output device is treated by the microprocessor as one memory location
input or output devices are treated as distinct
an address on the address bus may refer either to a memory location or to an I/O device
none of the above

⇒ If two time varying signals of equal magnitudes and 90° phase displacement are applied to X and Y plates of CRO, the display will be
a straight line
a circle
an ellipse
a rectangle

⇒ If it is desired to tabulate number of students in a class in Fortran language, a proper variable name is
ST
STUD
NSTUD
STD

⇒ A scheme shown below is to generate a wide band FM modulate sign
30
6
250
12

⇒ A seven bit (even parity) code 0010001 may have error. The correct code is
10001
1110001
11001
1111110

⇒ Which wave is also called surface wave?
Ground wave
Sky wave
Space wave
Both (b) and (c)

⇒ In a full wave diode rectifier circuit each diode carries current for
90° in each cycle
180° in each cycle
270° in each cycle
360° in each cycle

⇒ Which part of radio spectrum is more crowded?
Lower frequency part
Higher frequency part
Both (a) and (b)
None of these

⇒ In a loss less line the propagation constant is equal to
jωLC
LC
jωLC
LC

⇒ In figure readings of the two voltmeters shoul
100 V on each meter
200 V on each meter
150 V on V₁ and 50 V on V₂
50 V on V₁ and 150 V on V₂

⇒ SHF range is
30 - 300 MHz
300 - 3000 MHz
3000 - 30000 MHz
30000 - 300000 MHz

⇒ With increasing temperature, the electrical conductivity of metals
increases
decreases
increases first and then decreases
remains unaffected

⇒ EPROM can be
UVPROM
EEPROM
both UVPROM and EEPROM
none of the above

⇒

Assertion (A): Inter-digitated geometry is widely used for microwave transistors.

Reason (R): Tuning at input and output of transistor uses MOS chip capacitors.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In an home T.V. receiver, the leed in from the antenna is
coaxial cable of 75 Ω
ordinary twisted wire
bar copper wire
twin wire

⇒ If V = 100 ∠ 16°, the (V) is
10 ∠ 32°
10 ∠ 8°
10 ∠ 16°
10 ∠ 4°

⇒ In a tape recorder the output from RF oscillator is given to
only erase head coil
only record head coil
coils of both erase head and record head
none of the above

⇒ Consider the following statements as regards noise

If Gaussian noise is applied at input of a rectifier, the output is not gaussian
The noise encountered on a telephone line consists of short, pulse type disturbances whose amplitude distribution is not Gaussian
Shot noise results from random emission of electrons from a cathode
Shot noise results from phenomenon associated with the flow of current across semi conductor junctions

Which of the above are correct?
1, 2, 3, only
1, 2, 4 only
1, 2, 3, 4
2, 3 only

⇒ For a current transformer, the standard secondary rating is
1 A or 5 A
2.5 A
0.416666666666667
5 A or 10 A

⇒ Which of the following circuit does not need a coupling capacitor?
Resistance loaded
Transformer coupled
Impedance coupled
Single tuned