Question is ⇒ In a transistor βdc is likely to vary between 100 and 400. The proper value of βdc to be used to located Q point is, Options are ⇒ (A) 100, (B) 400, (C) 250, (D) 200, (E) , Leave your comments or Download question paper.

Question is ⇒ In a transistor βdc is likely to vary between 100 and 400. The proper value of βdc to be used to located Q point is, Options are ⇒ (A) 100, (B) 400, (C) 250, (D) 200, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a transistor β_dc is likely to vary between 100 and 400. The proper value of β_dc to be used to located Q point is
A.	100 [Wrong Answer]
B.	400 [Wrong Answer]
C.	250 [Wrong Answer]
D.	200 [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the following operation in a computer

Multiplication of scalar
Iversion of matrix
Printing a line of 120 characters on a printer

Which of the above is a subroutine?
1 and 2 only
1 and 3 only
1, 2 and 3
2 only

⇒ In the expression b = 2.1 / 1.2 * 3.1 + 3 / 7.1 * 6 which operation would have the first priority in C?
2.1 / 1.2
1.2 * 3.1
2.1 / 1.2 * 3.1
3 / 7.1

⇒ In a low level AM system, the amplifier which follows the modulated stage must be the
linear device
harmonic device
class C amplifier
non-linear device

⇒ The response of D'Arsonval galvanometer is over damped if
D² > 4CJ
D² > 2CJ
D² < 4CJ
D² < 2CJ

⇒ Some features of RF stage in good radio receivers is

It increases sensitivity by providing amplification to RF signal
It eliminates image frequency interference
It increases selectivity
It reduces noise level

Which of the above are true?
1, 2 and 3 only
1, 2 and 4 only
2, 3, 4 only
1, 2, 3, 4

⇒ In the sale of diamonds the unit of weight is carat. One carat is equal to
100 mg
150 mg
200 mg
500 mg

⇒

Match the following:

	List I (Memories)		List II (Characteristic)
A.	Static PLA	1.	erasable, programmable
B.	CCD	2.	ultra high speed
C.	ECL	3.	stores large volume of data
D.	GAL	4.	Does not need refreshing
		5.	Non-volatile

A-4, B-3, C-2, D-1
A-4, B-2, C-3, D-1
A-5, B-1, C-2, D-3
A-3, B-5, C-2, D-1

⇒ An R-L series circuit is excited by a voltage v(t). The circuit was initially relaxed. Which of the following sources of v(t) would cause maximum current at t = 0⁺?
unit step
unit impulse
unit ramp
unit step plus unit ramp

⇒ Poles and zeros of a driving point function of a network are simple and alternate on jω axis. The network consists of
R and C
L and C
R and L
R, L and C

⇒ A . 0 =
1
A
0
A or 1

⇒ In a piezoelectric crystal, applications of a mechanical stress would produce
plastic deformation of the crystal
magnetic dipoles in the crystal
electrical polarization in the crystal
shift in the Fermi level

⇒ The characteristic equation of a control system is given as s⁴ + 8s³ + 24s² + 32s + K = 0. What is the range of values of K for this system to be stable?
0 ≤ K < 80
0 ≤ K < 100
0 ≤ K < 2300
0 ≤ K < 600

⇒ A Schottky diode clamp is used along with a switching BJT for
reducing the power
reducing the switching time dissipation
increasing the value of β
reducing the base current

⇒ In the case of the circuit shown in the figure V_io = 10 mV dc maximum, the maximum possible output offset voltage V_oo caused by the input offset voltage V_io with respect to groun
60 mV dc
110 mV dc
130 mV dc
150 mV dc

⇒ A thyristor has a turn on time of 6 μs. If the anode circuit is inductive, the turn on time will be
6 μs
less than 6μs
more than 6 μs
either 6 μs or less

⇒ In a digital circuit, a clock is a
crystal type
multivibrator
flip-flop
free running multivibrator

⇒ Tesla is a unit of
flux
field strength
flux density
MMF

⇒ The currents fed to the two dipoles of turnstile antenna are
in phase
in quadrature
in phase opposition
either (a) or (c)

⇒ Simplify : A + B + A B + (A + B)AB + C(B + AB)
B + A
C
C
1

⇒

Assertion (A): A demultiplexer cannot be used as a decoder

Reason (R): A multiplexer selects one of many outputs whereas a decoder selects on output corresponding to coded input.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ For a photoconductor with equal electron and hole mobilities and perfect ohmic contacts at the ends, an increase in intensity of optical illumination results in
a change in o.c voltage
a change in s.c current
decrease in resistance
increase in resistance

⇒ If two mutually exclusive events A and B can happen in m and n ways, then either A or B can happen in (m + n) ways.
TRUE
FALSE

⇒ In a full wave diode rectifier circuit each diode carries current for
90° in each cycle
180° in each cycle
270° in each cycle
360° in each cycle

⇒ Low frequency response of amplifier is mainly limited by
input capacitor
bypass capacitor
output capacitor
biasing capacitor

⇒ In using Nyquist stability criterion it is not necessary to determine closed loop poles.
TRUE
FALSE

⇒ Nichols chart consists of
constant magnitude loci
constant phase angle loci
magnitude and phase angle loci in log-magnitude versus phase diagram
none of the above

⇒ Study the circuit of figure and examine the following statem
1, 2 and 3
1 and 2
1 and 3
2 and 3

⇒ In the signal flow graph of figure, y/x equ
3
42857
2
None of the above

⇒ For the Infix expression A + B - C + D the Postfix notation is
AB + C - D +
+ AB - C + D
AB - C + D
None of the above

⇒ A system has 12 poles or 2 zeros. Its high frequency asymptote in its magnitude plot has slope of
-200 dB/decade
-240 dB/decade
-280 dB/decade
-320 dB/decade