Question is ⇒ Figure shows current pulses of a class C power amplifier. The fundamental frequency of these pulse, Options are ⇒ (A) 100 kHz, (B) 1000 kHz, (C) 10 kHz, (D) 1 kHz, (E) , Leave your comments or Download question paper.

Question is ⇒ Figure shows current pulses of a class C power amplifier. The fundamental frequency of these pulse, Options are ⇒ (A) 100 kHz, (B) 1000 kHz, (C) 10 kHz, (D) 1 kHz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Figure shows current pulses of a class C power amplifier. The fundamental frequency of these pulse
A.	100 kHz [Correct Answer]
B.	1000 kHz [Wrong Answer]
C.	10 kHz [Wrong Answer]
D.	1 kHz [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The circuit of the given figure realizes the func
Y = (A + B) C + DE
Y = A + B + C + D + E
AB + C +DE
AB + C(D + E)

⇒ Vectored interrupt is an interrupt that takes the program to a vector location. TRAP vectors to 0024 FI, RST 7.5 to 003 CH, RST 6.5 to 0034 H and
RST 5.5
RST 6.5
24 H to 48 H
RST 5.5 to 002 CH

⇒ The memory hierarchy in microprocessor based system is
register, cache, primary, mass, off line back up
cache, register, primary, mass, off line back up
cache, register, mass, primary, off line back up
register, cache, mass, primary, off line back up

⇒ Which of the following frequency is likely to be associated with AM radio broadcast?
1000 kHz
100 MHz
500 MHz
10 GHz

⇒ The resistance of a standard conductor.
increases with frequency
same for ac and dc
increases with frequency
increases as square root of frequency

⇒

Assertion (A): In 8085 when RESET OUT goes low processing begins.

Reason (R): CPU remains reset till RESET IN signal goes high.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ The work function of a photo surface whose threshold wave length is 1200 A, will be
0.103 eV
0.673 eV
1.03 eV
1.27 eV

⇒ In which mode of BJT operation are both junctions forward biased?
Active
Saturation
Cut off
Reverse active

⇒ Why npn-transistors are preferred over pnp-transistors?
Leakage current in npn-transistors is less than pnp-transistors
Mobility of majority carrier in npra-transistors is greater than the mobility of majority carrier in pnp-transistors
Bias voltage required in npn is less than in/wp-transistors
Bias voltage required in npn is greater than in pnp-transistors

⇒ The polar plot of transport lag is a unit circle.
TRUE
FALSE

⇒ A wave is propagated in a waveguide at frequency of 9 GHz and separation is 2 cm between walls find cut off wavelength for dominant mode.
4 cm
1 cm
2 cm
8 cm

⇒ For a second order system delay time t_d is the time required to reach
half the final value for the very first time
the final value for the very first time
90% of the final value for the very first time
none of the above

⇒ If a sequence is causal then ROC is (where a is any number)
|z| > a
|z| < a
|z| = a
Entire Plane

⇒ Satellite communication uses frequencies in the range of
3 to 6 GHz
3-10 MHZ
10-50 GHz
100-200 GHz

⇒ E_G for silicon is 1.12 eV and that for germanium is 0.72 eV. Therefore, it can be concluded that
the conductivity of silicon will be less than that of germanium at room temperature
the conductivity of silicon will be more than that of germanium at room temperature
the conductivity of two will be same at 60°C
the conductivity of two will be same at 100°C

⇒ For a NPN bipolar transistor, what is the main stream of current in the base region?
Drift of holes
Diffusion of holes
Drift of electrons
Diffusion of electrons

⇒ During playback the take up reel is
in clockwise motion
in anticlockwise motion
either clockwise or anticlockwise motion
none of the above

⇒ Power gain of a multicavity klystron amplifier is
more than 30 dB
causes retardation of all electrons
causes acceleration of some electrons and retardation of others
none of the above

⇒ If x₁(t) = 2 sin pt + cos 4 pt and x₂(t) = sin 5 pt + 3 sin 13 pt then
x₁, x₂ both periodic
x₁ x₂ both not periodic
x₁ periodic, x₂ not periodic
x₁ is not periodic ; but x₂ is periodic

⇒ PAM stands for
Pulse Analogue Modulation
Phase Analogue Modulation
Pulse Amplitude Modulation
Phase Amplitude Modulation

⇒ Single parity check is not reliable in case of
paper tape
magnetic tape
magnetic drum
cores

⇒ In the below figure the rms voltage across each half of secondary is 200 V. The peak inverse voltage across each of thyristor
200 V
2(200) V
2(400) V
800 V

⇒ In magnetic film memory, the memory element consits of
plated wires
superconductive material
nickel iron alloy
doped aluminium

⇒ Consider the following statements, regarding an OP AMP:

All types of negative feedback reduce non-linear distortion.
All types of negative feedback reduce the output offset voltage.
Non-inverting (current and voltage) feedback increases the input impedance.
Inverting (current and voltage) feedback decreases input impedance.

Which of the above statements is/are correct?
1 only
2 and 3 only
2 and 4 only
1, 2, 3 and 4

⇒ A first order system will never be able to give a __________ response

band stop
band pass
all pass

Choose the correct option
1, 2, 3 true
1 and 3 true, 2 false
1, 2 are true 3 is false
1, 2 are false, 3 is true

⇒ For the system with given characteristic equat
3, 2, 0
4, 0, 1
3, 0, 2
4, 1, 0

⇒ A generated voltage is equally dependent on three resistances R₁, R₂, R₃ and its value is V = (R₁R₂)/R₃. If tolerance of each resistor is 0.1%, the maximum error in voltage is
0.003
± 0.3%
0.001
± 0.1%

⇒ As the diameter of a wire is doubled, the resistance becomes
twice
one half
one fourth
four times

⇒ In figure the dc emitter current of each transistor is a
4 mA
2 mA
3 mA
1 mA

⇒ Which of the following is invalid in Basic?
A ** B - C
5.2 ** 4.3
5.2 ** (- 4.3)
(- 5.2) ** (4.3)