Question is ⇒ Which of the following does not cause losses in optical fibre cables?, Options are ⇒ (A) Impurities, (B) Microbending, (C) Attenuation in glass, (D) Stepped index operation, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following does not cause losses in optical fibre cables?, Options are ⇒ (A) Impurities, (B) Microbending, (C) Attenuation in glass, (D) Stepped index operation, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following does not cause losses in optical fibre cables?
A.	Impurities [Wrong Answer]
B.	Microbending [Wrong Answer]
C.	Attenuation in glass [Wrong Answer]
D.	Stepped index operation [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following will increase the antenna radiation efficiency?
Use of larger section of conductor
Providing insulation on conductor
Top loading of antenna
Any of the above

⇒ In the given figure the ratio T/d is the duty fac
TRUE
FALSE

⇒ The boolean expression for shaded area in the given figur
AB + AC
ABC + ABC
ABC + ABC
None of these

⇒ The total lumens emitted by a source of 1 candle are
0.4 p
4 p
2 p
8 p

⇒

Assertion (A): In TE mode for rectangular waveguide.

Reason (R): In TM mode for rectangular waveguide.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The accuracy of an instrument is determined by
closeness of indicated value to the actual value
repeatability of measured value
speed with which the reading approaches final value
least value which can be measured

⇒ Negative feedback in amplifier
reduces gain
increases frequency and phase distortion
reduces bandwidth
increases noise

⇒ A permanent magnet moving coil measures
true rms value
dc value
peak value
rms plus dc value

⇒ A communication satellite is a repeater between
a transmitting station and a receiving station
a transmitting station and many receiving station
many transmitting station and many receiving station
none

⇒ The logic performed by the high-noise immunity logic circuit shown belo
OR
AND
NOR
NAND

⇒ Two resistances R₁ = 18.7 Ω. and R₂ = 3.624 Ω in series. The total resistance to the appropriate number of significant figures is
22.324 Ω
22.32 Ω
22.3 Ω
22 Ω

⇒ A cascade amplifier stage is equivalent to
common emitter stage followed by a common base stage
common base stage followed by an emitter follower
an emitter follower stage followed by a common base stage
a common base stage followed by a common emitter stage

⇒

Assertion (A): In n-p-n transistor conduction is mainly due to electrons.

Reason (R): In n type materials electrons are majority carriers.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The impedance of an RC series circuit is 12 Ω at f= 50 Hz. At f= 200 Hz, the impedance will be
more than 12
less than 3
more than 3 Ω but less than 12 Ω
more than 12 Ω but less than 24 Ω

⇒ The attenuation in a waveguide near the cut off frequency is
zero
low
high
very high

⇒ As per Hartley law
redundancy is essential
it is necessary to use only binary codes
maximum rate of information transmission depends on the channel bandwidth
the maximum rate of information depends on depth of modulation

⇒ In a four variable Karnaugh map, eight adjacent cells give a
two variable term
single variable term
three variable term
four variable term

⇒ In a P-N-P transistor, with normal bias
the collector junction has negligible resistance
only holes cross the collector junction
the collector-base junction is reverse biased and the emitter base junction is forward biased
only majority carriers cross the collector junction

⇒ The magnitude response of a normalised Butterworth low pass filter is
linear starting with value of unity at zero frequency and 0.707 at cut off frequency
non linear all through but with values of unity at zero frequency and 0.707 at cut off frequency
linear upto cut off frequency and nonlinear thereafter
nonlinear upto cut off frequency and linear thereafter

⇒ A signum function is
zero for t greater than zero
zero for t less than zero
unity for t greater than zero
2∪(t) - 1

⇒ In the circuit, S was initially open. At time t = 0, S is closed. When the current through the inductor is 6 A, the rate of change of current through the resistor is 6 A/s. The value of the inductor woul
1 H
2 H
3 H
4 H

⇒ Which of the following statement is false?
A stationary process is always a ergodic process
A ergodic process is always a stationary random process
It is possible to have a stationary random
None of the above

⇒ As the temperature increases the mobility of electrons __________ .
decreases because the number of carries increases with increased collisions
increases because the number of carries decreases with decreased collisions
remains same
none of the above

⇒ In a PCM system, if we increase the quantization levels from 2 to 8, how do the relative bandwidth requirements vary?
Get doubled
Get tripled
Remains same
Become eight times

⇒

Assertion (A): Electromagnetic waves in free space spread uniformly in all directions from a point source

Reason (R): Free space has no interference or obstacles.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ TRAP is __________ whereas RST 7.5, RST 6.5, RST 5.5 are __________ .
maskable, non-maskable
maskable, maskable
non-maskable, non-maskable
non-maskable, maskable

⇒ In communication satellites, the up-link normally operates at a higher frequency than the down-link because it
gives a narrow beam shining into space
results in lesser signal attenuation
gives better beam-shaping
is easier to polarize a high frequency beam

⇒ The directive gain of a transmitting antenna is
proportional to wavelength
inversely proportional to wavelength
proportional to square of wavelength
inversely proportional to square of wavelength

⇒ If the number of information bits is m, the number of parity bits p in the Hamming code is given by equation
2^p = m + p + 1
2^p ≥ m + p + 1
2^P = m + p
2^p ≥ m + p

⇒ Symbol in the given figure is IEEE symbol
AND
OR
NAND
NOR