Question is ⇒ In an amplifier, if the output current flows for 120° of the input cycle, the class of amplifier will be, Options are ⇒ (A) A, (B) B, (C) C, (D) AB, (E) , Leave your comments or Download question paper.

Question is ⇒ In an amplifier, if the output current flows for 120° of the input cycle, the class of amplifier will be, Options are ⇒ (A) A, (B) B, (C) C, (D) AB, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In an amplifier, if the output current flows for 120° of the input cycle, the class of amplifier will be
A.	A [Wrong Answer]
B.	B [Wrong Answer]
C.	C [Correct Answer]
D.	AB [Wrong Answer]
View Answer 1 -3 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The braking torque in single phase energy meter is proportional to speed of disc.
TRUE
FALSE

⇒ Consider the following statement: In case of a superconductor

B = 0
μ_r is high
diamagnetism is high
transition temperature varies with isotopic mass.

Of the above statements
1 and 2 are correct
2, 3, 4 are correct
1, 3, 4 are correct
2, 4 are correct

⇒ A transistor with a = 0.9 and I_CBO = 10 μA is biased so that I_BQ = 90 μA. Then I_CQ will be
910 mA
5 mA
5.25 mA
4.95 mA

⇒ Which of the following is not a valid character constant in C?
A'
2'
='
2

⇒ In pulse code modulation when the maximum frequency in the signal is f_max the bandwidth required will be
≤ p.f_max
≥ p.f_max
≤ (p.f_max)²
≥ (p.f_max)²

⇒ High cut off frequency can be expected in case of
common-base
common-emitter
common-collector
all of the above

⇒ Resistivity of metals consists of two parts, one part constant and the other temperature dependent.
TRUE
FALSE

⇒ In a D latch
a high D sets the latch and low D resets it
a low D sets the latch and high D resets it
race can occur
none of the above

⇒ In a full wave rectifier circuit using centre tapped transformer, the peak voltage across half of the secondary winding is 30 V. Then PIV is
30 V
60 V
15 V
10 V

⇒ In figure, the switch is initially open. At t = 0 switch is closed. v_c (0⁺) and i_L (0⁺)
60 V and - 0.3 A
150 V and zero
zero and 0.3 A
90 V and - 0.3 A

⇒ If B is the bandwidth, the thermal noise voltage is proportional to
B
B^0.5
B^1.5
B²

⇒ When a voltage is applied to a semiconductor crystal then the free electrons will flow.
towards positive terminal
towards negative terminal
either towards positive terminal or negative terminal
towards positive terminal for 1 μs and towards negative terminal for next 1 μs

⇒

Assertion (A): Tunnel diode is used in many pulse and digital circuits.

Reason (R): The v-i curve of a tunnel diode resembles letter 'N'.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will accumulator (A) and carry (CY) contain after ANA A?
A 6 H, 1
A 6 H, 0
00 H, 0
00 H, 1

⇒ If the absolute value of a number is less than decimal 1, the sign of exponent in floating point representation is
zero
negative
zero or negative
positive

⇒ An open coil has
zero resistance and inductance
zero resistance and high inductance
infinite resistance and zero inductance
infinite resistance and normal inductance

⇒ A BJT amplifier has a power gain of 0.5 from source to base. The power gain in dB is
-0.3 dB
-3 dB
-6 dB
-10 dB

⇒ A transistor may fail due to
open weld at the wire leads to the semi-conductor
short circuit caused by momentary overloads
overheating due to circuit failures
any of the above

⇒ The light output of LED varies as (current)ⁿ. The value of n is about
0.5
1
1.3
2.1

⇒ Which one of the following is correct? Energy of a power signal is
finite
zero
infinite
between 1 and 2

⇒ The signal cos ω_ct + 0.5 cos ω_mt sin ω_ct is
FM only
AM only
both AM & FM
neither AM nor FM

⇒ Which of the following oscillators is used for the generation of high frequencies?
R-C phase shift oscillator
Wien bridge oscillator
L-C oscillator
Blocking oscillator

⇒ The gate current required to turn on an SCR is
few amperes
a few mA
almost equal to anode current
about 50% of anode current

⇒ The number of essential prime implicant for the logic express
3
5
4
6

⇒ Even at room temperature, an intrinsic semiconductor has some holes. These holes are due to
electron
doping
thermal energy
free electrons

⇒ McMurrary full bridge inverter uses
auxiliary commutation
complementary commutation
natural commutation
any of the above

⇒ In a full bridge inverter, the waveshape of load current depends on
relative values of load parameters R, L and C
relative values of load parameters R and L
relative values of load parameters L and C
gating frequency

⇒ In the given circuit, V₁ = 40 V when R is 10 Ω. When R is zero, the value of V₂ wil
40 V
30 V
20 V
10 V

⇒ An instruction used to set cany flag in a computer is classified as
data transfer
arithmetic
logical
program control

⇒

Assertion (A): Microprocessor 8085 has on-chip oscillator with inbuilt crystal.

Reason (R): For frequency stability crystal oscillator is preferred.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct