Question is ⇒ Square root of 4 is, Options are ⇒ (A) (16)16, (B) (2)2, (C) (8)16, (D) (5)16, (E) , Leave your comments or Download question paper.

Question is ⇒ Square root of 4 is, Options are ⇒ (A) (16)16, (B) (2)2, (C) (8)16, (D) (5)16, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Square root of 4 is
A.	(16)₁₆ [Wrong Answer]
B.	(2)₂ [Wrong Answer]
C.	(8)₁₆ [Wrong Answer]
D.	(5)₁₆ [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The terminals of a power MOSFET are called
emitter, base, collector
source, gate, drain
source, base, drain
emitter, gate, drain

⇒ A full adder has two outputs SUM and CARRY.
TRUE
FALSE

⇒

Assertion (A): Atomic number of sodium is 11.

Reason (R): Sodium has a body centred cubic lattice.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ A sine wave is passed through an amplifier which severely limits it symmetrically. If then passes to a second amplifier which is narrow band and tuned to the frequency of the original sine wave. What will be the output wave from this second amplifier?
A square wave of the same frequency as that of the original sine wave
A square wave of double the frequency of that of original sine wave
A sine wave of constant amplitude at the frequency of the original sine wave
A sine wave of constant amplitude at double frequency of the original sine wave

⇒

Assertion (A): Manufacturer's quote h parameters of transistor

Reason (R): h parameters of a transistor are easiest to measure

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ When negative feedback is used the fractional changes in closed loop gain are desensitized by the factor (1 + A_vβ)
TRUE
FALSE

⇒ Frequency shift keying is used mostly in
telegraphy
telephony
satellite communication
radio transmission

⇒ In a transistor with normal bias
the emitter junction has a low resistance
the emitter junction has a very high resistance
the emitter junction supplies majority carries into the base region
none of the above

⇒ A digital voltmeter can count from 0 to 9999. If full scale reading is 9.999 V, the resolution of full scale reading is
0.001
1000
2 digit
1 mV

⇒ Measurement of Hall coefficient enables the determination of
transportation factor decreases and a increases
transportation factor increases and a increases
transportation factor increases and a decreases
transportation factor decreases and a decreases

⇒ The magnitude of transport lag factor is always zero.
TRUE
FALSE

⇒ Unit doublet is the Laplace inverse of __________ .
1/s
s²
s
none of these

⇒ VSWR = E_max/E_min.
TRUE
FALSE

⇒ For a high pass filter, β = p in attenuation band.
TRUE
FALSE

⇒ Strip lines are used at
microwave frequency
low frequency
High frequency
at any frequency

⇒ A TV receiver has a width of 60 cm. The aspect ratio is 4/3. The required EHT supply is about
29 kV
2.9 kV
45 kV
4.5 kV

⇒ Which of the following microphones has maximum distortion?
Ribbon
Condenser
Crystal
Carbon

⇒ Consider the following expression for the driving point imped
2 and 4
1 and 3
1 and 4
2 and 3

⇒ The integral of unit step function is a ramp of slope unity.
TRUE
FALSE

⇒ A JFET operates in ohmic region when
V_GS = 0
V_GS is less than pinch off voltage
V_GS = is Positive
V_GS = V_DS

⇒ Light dependent resistors are
highly doped semiconductor
intrinsic semiconductor
lightly doped semiconductor
either (a) or (c)

⇒ The system of the given fi
has two poles and one zero in left half plane
has two poles and one zero in right half plane
has two poles in left half plane and zero in right half plane
none of the above

⇒ In a biased limiter the clipping level can be adjusted by adjusting the voltage of battery.
TRUE
FALSE

⇒ Consider the following statements regarding registers and latches:

Registers are made of edge-triggered FFs, whereas latches are made from level-triggered FFs.
Registers are temporary storage devices whereas latches are not.
A latch employs cross-coupled feedback connections.
A register stores a binary word whereas a latch does not.

Which of the above statements is/are correct?
1 only
1 and 3
2 and 3
3 and 4

⇒ Binary 1111 when subtracted from binary 11111 is
101110
10110
10000
100010

⇒ The symbol ! in Java means
logical NOT
logical OR
AND
logical XOR

⇒ Direct and reflected sound waves may interfere with each other.
TRUE
FALSE

⇒

Assertion (A): When an SCR is conducting, the voltage drop across is about 1 V.

Reason (R): When an SCR is conducting, the junction temperature is about 200°C.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Consider the circ
0
(C + D)
1
(A + B) + (C + D)

⇒ A trinitron colour picture tube uses
three electron guns
one electron gun
one electron gun with three separate in line cathodes
none of the above