Question is ⇒ The circuit in figure will act as ideal current source with respect to terminals A and B when frequenc, Options are ⇒ (A) 0, (B) 1 rad/sec, (C) 4 rad/sec, (D) 16 rad/sec, (E) , Leave your comments or Download question paper.

Question is ⇒ The circuit in figure will act as ideal current source with respect to terminals A and B when frequenc, Options are ⇒ (A) 0, (B) 1 rad/sec, (C) 4 rad/sec, (D) 16 rad/sec, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The circuit in figure will act as ideal current source with respect to terminals A and B when frequenc
A.	0 [Wrong Answer]
B.	1 rad/sec [Correct Answer]
C.	4 rad/sec [Wrong Answer]
D.	16 rad/sec [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ UHF and microwaves in the frequency range 300 MHz to 30 GHz can be best transmitted using __________ propagation
sky wave
ground wave
duct
none of the above

⇒ The total power radiated from an antenna system is determined by imagining that the antenna is at the centre of a very large
sphere
rectangle
square
ellipse

⇒ The circuit of figure give an output which
a frequency modulated signal
an amplitude modulated signal
a phase modulated signal
none of the above

⇒ In a radio receiver, the local oscillator is tuned to a frequency
lower than the incoming frequency
higher than the incoming frequency
equal to incoming frequency
any of the above

⇒ Which antenna is frequently used for local area transmission at UHF/VHF?
Ground monopole
Turnstile antenna
Slot antenna
Loop antenna

⇒ A magic tee is to be used as CW duplexer. Then port 1, port 2, port 3 (E arm), port 4 (H arm) respectively should be connected to
matched load, antenna, receiver and CW transmitter
CW transmitter, antenna, receiver and matched load
CW transmitter, receiver, antenna and matched load
CW transmitter, matched load, receiver and antenna

⇒ The value of current read by ideal ammeter A in figure is __________ amp
0
3
2.5
5

⇒ The z-transform of a particular signal is gi
casual and stable
non-casual and stable
non-casual and unstable
casual and unstable

⇒ A rectangular pulse train s(t) is shown in figure is convolved with the signal cos²(4p x 10³t). The convolved signal will
DC
12 kHZ sinusoidal
8 kHZ sinusoidal
14 kHZ sinusoidal

⇒

Assertion (A): Megger is used to check insulation resistance of cables.

Reason (R): Insulation resistance of cables is very high.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Race condition occurs in
synchronous circuit
asynchronous circuit
combinational circuit
all the Digital circuit

⇒ A pulse function having magnitude E and duration from t = 0 to t = a can be represented as
sum of two pulse functions
difference of two pulse functions
difference of two step functions each of magnitude E and one originating at t = 0 and the other at t = a
none of the above

⇒ An induction wattmeter can be used for
dc only
50 Hz ac only
both ac and dc
high frequency ac only

⇒ A linear diode detector uses RC filter. As modulation index increases the maximum permissible value of time constant RC
increases
decreases
remains constant
either (a) or (c)

⇒ In Pascal if I = 55, 10 * I div 10 =
55
50
5.5
5

⇒ The concentration of minority carriers in a semiconductor depends mainly on
the extent of doping
temperature
the applied bias
none of the above

⇒

Assertion (A): Dielectric constant is independent of temperature unless the temperature is extremely high.

Reason (R): For normal temperatures the number of atoms per unit volume is constant.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Magnetic susceptibility of a medium is the ratio of
magnetic field strength to mmf
intensity of magnetization to magnetic flux density
intensity of magnetization to field strength
mmf to magnetic field strength

⇒ Two current sources each of rms value 10 A have frequencies 40 Hz and 50 Hz respectively. They are connected in series, the expression for resultant wave is
i = 10 sin 40 t + 10 sin 50 t
i = 14.14 sin 40 t + 14.14 sin 50 t
i = 14.14 sin 80 pt + 14.14 sin 100 pt
i = 20 sin 80 pt + 20 sin 100 pt

⇒ It is required to measure a low magnitude high frequency current. The proper instrument is
moving iron
dynamometer
thermocouple
induction

⇒ An SCR has a turn on time of 4 μs. The gate pulse should have a duration of about
2 μs
5 μs
20 μs
50 μs

⇒ For 0 < M < 1, the centres of M circle lie to the right of origin.
TRUE
FALSE

⇒ What happens when a paramagnetic material is heated above Curie temperature?
It becomes diamagnetic
It becomes nonmagnetic
It becomes ferromagnetic
It becomes anti-ferromagnetic

⇒ Which of the following are useful in comparing the noise performance of receivers?

Input noise voltage
Noise figure
Noise resistance
Noise temperature

Select answer as per the following codes:
1, 2 and 3
1, 3 and 4
2, 3, 4
1, 2, 4

⇒ The system in the given fi
will be unstable due to the presence of positive feedback in the inner loop
may be stabilized by the negative feedback outer loop
can never be stable
will always be stable

⇒ In ionosphere incidence angle is 60°. The maximum usable frequency f_m is equal to
2f_c
f_c
0.5 f_c
3 f_c

⇒

Assertion (A): A dc potentiometer measures the true open circuit emf of a source.

Reason (R): At balance point, a dc potentiometer does not draw any current from the source.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Which one of the systems described by the following I/P - O/P relations is time invariant
y(n) = n x(n)
y(n) = x(n) - x(n - 1)
y(n) = x(- n)
y(n) = x(n) cos 2pf₀n

⇒ For the network shown below, the Thevenin voltage and R_TH is equal to _______
0 V, 58.82 Ω
0 V, 96.774 Ω
0 V, 3 KΩ
None of these

⇒ For the shaded area in Venn diagram of the given figure, the Boolean expressio
AB + BC + CA
ABC + A B C
ABC + A B C
ABC+AB