Question is ⇒ The stator of phase shifting transformer for use in conjunction with an ac potentiometer has a, Options are ⇒ (A) single phase winding, (B) two phase winding, (C) 3 phase winding, (D) either (a) or (c), (E) , Leave your comments or Download question paper.

Question is ⇒ The stator of phase shifting transformer for use in conjunction with an ac potentiometer has a, Options are ⇒ (A) single phase winding, (B) two phase winding, (C) 3 phase winding, (D) either (a) or (c), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The stator of phase shifting transformer for use in conjunction with an ac potentiometer has a
A.	single phase winding [Wrong Answer]
B.	two phase winding [Correct Answer]
C.	3 phase winding [Wrong Answer]
D.	either (a) or (c) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For a resistance of about 15 kΩ operating in a frequency range of a few MHz, the noise voltage is in the range of
a few μV
about 100 μV
a few μV
a few volts

⇒ The image frequency of a superheterodyne receiver is
independent of the frequency at which the receiver is tuned
always outside the operating range of the receiver
typical to FM receivers only
not rejected by the IF tuned circuits

⇒ A single phase full bridge inverter for R-L loads needs
4 thyristors
4 thyristors and 4 diodes
4 thyristors and 2 diodes
8 thyristors

⇒ For the K map of the given figure the simplified Boolean expressio
A B + A B
B
A
AB

⇒ If an amplifier with gain of - 1000 and feedback factor β = - 0.1 had a gain change of 20% due to temperature, the change in gain of the feedback amplifier would be
0.1
0.05
0.002
0.0001

⇒ In AM increased depth of modulation increases __________ and in FM with increased depth of modulation __________ increases.
total transmitted power, bandwidth
bandwidth, bandwidth
bandwidth, total transmitted power
total transmitted power, sideband power

⇒ A power supply has full-load voltage of 20 V. What will be its no load voltage when its voltage regulation is 100%
0 V
10 V
20 V
40 V

⇒ Integrated fin line can be utilized as a medium for constructing millimeter wave circuits.
TRUE
FALSE

⇒ Which of the following devices has metal-silicon junction?
General purpose power diode
Schottky diode
SCR
MOSFET

⇒ The current due to thermionic emission is proportional to
T
T²
T³
T⁴

⇒ In memory mapped I/O means that
an input or output device is treated by the microprocessor as one memory location
input or output devices are treated as distinct
an address on the address bus may refer either to a memory location or to an I/O device
none of the above

⇒ As compared to TTL, CMOS logic has
higher speed of operation
higher power dissipation
smaller physical size
all of the above

⇒ The integral of a unit step function is
an impulse function
a ramp function
a ramp function of slope 1
none of these

⇒ When the circuit is switched on, the loop gain of a Wien bridge oscillator is
1
more than 1
less than 1
about 0.5

⇒

Assertion (A): A half wave controlled rectifier has poorer efficiency and higher ripple factor than a full wave controlled rectifier.

Reason (R): The use of a freewheeling diode in half wave controlled rectifier circuit improves the waveform of load current and circuit power factor.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which of the following is also called Non volatile RAM?
Shadow RAM
UVEPROM
EEPROM
Both (b) and (c)

⇒ The noise figure of FET circuit is
independent of the quiescent point
dependent on the quiescent point only
dependent on the triggering mechanism
independent of all above

⇒

Assertion (A): For high frequency lines inductive reactance is very high as compared to ac resistance.

Reason (R): Due to skin effect ac resistance of line is higher than dc resistance.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Insulation resistance of a cable is directly proportional to its length.
TRUE
FALSE

⇒ When a JFET is cut off, it's like an __________ switch and when it is saturated, it's like a __________ switch.
closed, open
open, closed
open, open
closed, closed

⇒ In energy band diagram of p type semiconductor the acceptor energy level is
in valence band
in conduction band
slightly above valence band
slightly below conduction band

⇒ Consider the sequence x[n] = [- 4 - j5 1 + J2 4]
[- 4 - J2.5 J2 4 - J2.5]
[- J2.5 1 J2.5]
[- J5 J2 0]
[- x 1 4]

⇒ An impulse function consist of
pure dc
pure a.c
entire frequency range with constant phase
infinite bandwidth with linear phase vaariations

⇒ Which antenna is frequently used for local area transmission at UHF/VHF?
Ground monopole
Turnstile antenna
Slot antenna
Loop antenna

⇒ If an inverter is placed at the input to an SR flip-flop, the result is
T flip-flop
D flip-flop
JK flip-flop
BCD decade counter

⇒ A single phase full converter gives maximum and minimum output voltage at firing angles of
0 and 180° respectively
180° and 0° respectively
0 and 90° respectively
90° and 0° respectively

⇒ The circuit of the given figur
full adder
magnitude comparator
parity detector
none of the above

⇒ Which of the following statements is incorrect?
A mesh with two resistors has two mesh currents
The algebraic sum of all voltages around any mesh or any loop must be zero
The principle node is a function where branch current can divide or combine
A Norton is a series circuit

⇒ Consider the following statements about a magic tee

The collinear arms are isolated from each other.
On of the collinear arms is isolated from E arm.
On of the collinear arms is isolated from H arm.
E and H arms are isolated from each other.

Of the above statements
1 and 2 are correct
1 and 3 are correct
1 and 4 are correct
2 and 3 are correct

⇒ If a electromagnetic signal is incident at 0° in a waveguide then at other port of waveguide we will get
zero power
∞ power
depend upon input signal strength
depend on frequency