Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | In a 3 phase fully controlled converter the firing frequency is |

A. | 3 times the line frequency [Wrong Answer] |

B. | 6 times the line frequency [Correct Answer] |

C. | 9 times the line frequency [Wrong Answer] |

D. | 12 times the line frequency [Wrong Answer] |

View Answer
Explanation:-
Answer : BDiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ For 0 < M < 1, the centres of M circle lie to the right of origin.

TRUE

FALSE

⇒ For a photoengraving the mask used is

master mask

slave mask

working mask

photo mask

⇒ At a temperature of 7 K, lead is a superconductor.

TRUE

FALSE

⇒ The most serious problems in ac bridge measurement is

eddy currents

leakage current

residual magnetism

stray fields

⇒ Which of the following is not a data base function?

DAVERAGE

MAX

DCOUNT

DSTDEV

⇒ If

*p*is the probability of success and

*q*is the probability of failure, then the probability that there are

*r*successes in

*n*trails is

^{n}

*c*

_{r}

*p*

^{r}*q*

^{n}

^{-}

^{r}

^{n}*c*

_{r}

*p*

^{n -}

^{r}*q*

^{r}^{n}

*c*

_{r}

*p*

^{r}*q*

^{n}

^{+}

^{r}

^{n}*c*

_{r}*p*

^{n}*q*

^{n}^{- r}

⇒ Which one of the following is not a negative resistance device?

Gunn diode

Tunnel diode

Impatt diode

Varactor diode

⇒ For the wave shown in figure, the average valu

14.14 A

15 A

17.17 A

19.19 A

⇒ The Hilbert transform of cos ω

_{1}

*t*+ sin ω

_{2}

*t*is

sin ω

_{1}

*t*+ cos ω

_{2}

*t*

sin ω

_{1}

*t*- cos ω

_{2}

*t*

cos ω

_{1}

*t*- cos ω

_{2}

*t*

sin ω

_{1}

*t*+ sin ω

_{2}

*t*

⇒ In a single-stage RC coupled common emitter amplifier, the phase shift at the lower 3 dB frequency is

zero

135°

180°

225°

⇒ The first dominant pole encountered in the frequency response of a compensated op-amp is approximately at

5 Hz

10 kHz

1 MHz

100 MHz

⇒ A decade counter skips

binary states 1000 to 1111

binary states 0000 to 0011

binary states 1010 to 1111

binary states 1111 to higher

⇒ Which of the following is a valid FORTRAN assignment statement?

10 = N

X + 2.1 = 5.6

A = B

A = B = 1

⇒ The main difference between the broadside arrays and end fire arrays is that

individual elements are fed with same current in broadside arrays and of different magnitude in end fire arrays

in broadside arrays the elements are equidistant whereas in end fire array the distance between elements increases progressively

the total number of elements in broadside array is always one and a half times that of elements in end fire arrays

in broadside array the individual elements are fed in, out of phase by 180° whereas in end fire array individual elements are fed with currents of equal magnitude but their phases vary progressively along the line in such a way as to make the entire arrangement substantially unidirectional

⇒ A ship-to-ship communication system is plagued by fading. The best solution seems to be the use of

space diversity

frequency diversity

a broad band antenna

a more directional antenna

⇒ A series RLC circuit is supplied from a variable frequency ac source. The resonant frequency is ω

_{0}. The voltage across C is maximum at a frequency

equal to ω

_{0}

slightly less than ω

_{0}

slightly more than ω

_{0}

none of the above

⇒ The PCM signal shown below uses amplitude level of +1 volt and -1 volt to represent binary symbol 0 and 1 respectively. Each code word consists of 4 bits. The sampled version of analog signal from which this PCM signal is derived

EB596

CD231

DA495

25B6A

⇒ A 6 bit DAC uses binary weighted resistors. If MSB resistor is 20 k ohm, the value of LSB resistor is

20 k ohm

80 k ohm

320 k ohm

640 k ohm

⇒ The depth of penetration at 4 MHz is 10 cm, then at 2.5 MHz it is

62.5 cm

13 cm

6.25 cm

8 cm

⇒ Master control facility (MCF) for INSAT-2 series satellites is located at

Madras

New Delhi

Leh

Hassan

⇒ Which of the following is not the main characteristic of a FET?

Drain resistance

Forward transconductance

Temperature stability

Amplification factor

⇒ The point P in the following figure is stock at 1. The output

*f*wil

ABC

A

AB C

A

⇒ Read the following statements about address space in microprocessors

- An address space is a set of all possible addresses which can be generated by a microprocessor.
- Each address in the address space allows a designer to provide at least one memory or I/O location in the system.
- Two types of address spaces are memory and I/O address space.
- Some micro processors have only one type of address space.

All

1, 2, 3 only

1, 2, 4 only

1, 3, 4 only

⇒ A lossless transmission line is 50 cm long and operates at a frequency of 500 MHz. Inductance and capacitances present in a line are 0.5 μH/m and 200 pF/m. Phase constant and phase velocity are respectively.

5p, 2p x 10

^{8}m/sec

5p, 10

^{8}m/sec

31.4, 10

^{8}m/sec

31.4, 2p x 10

^{8}m/sec

⇒ The ratio of tangential component of electric field at the surface of a conductor and the linear current density resulting from this field is __________ impedance

characteristic

critical

surface

polarizing

⇒ A diode detector load consists of 0.01 μF capacitor in parallel with a 5 k ohms resistor. The maximum depth of modulation without diagonal clipping at modulating frequency of 1000 Hz and 10 kHz is

0.76, 0.24

0.95, 0.3

0.24, 076

0.3, 0.95

⇒ The primary colours are

blue and green

blue and red

red and green

blue, red and green

⇒ Surface waves can propagate on Piezoelectric substrates.

TRUE

FALSE

⇒ When the channel is noisy, producing a conditional probability of error

*p*= 0.5; the channel capacity and entropy function would be, respectively,

1 and 1

1 and 0.5

0.5 and 1

0 and 1

⇒ A FET is a __________ controlled device whereas a bipolar transistor is a __________ controlled device.

gate, drain

drain, gate

current, voltage

voltage, current