Question is ⇒ The dynamic characteristics of capacitive transducer are similar to those of, Options are ⇒ (A) LP filter, (B) HP filter, (C) notch filter, (D) band stop filter, (E) , Leave your comments or Download question paper.

Question is ⇒ The dynamic characteristics of capacitive transducer are similar to those of, Options are ⇒ (A) LP filter, (B) HP filter, (C) notch filter, (D) band stop filter, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The dynamic characteristics of capacitive transducer are similar to those of
A.	LP filter [Wrong Answer]
B.	HP filter [Correct Answer]
C.	notch filter [Wrong Answer]
D.	band stop filter [Wrong Answer]
View Answer 1 -5 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Maximum undistorted power output of a transmitter is obtained when its modulation is __________ percent.
more than 100
100
less than 100
50

⇒ In standing wave pattern on a transmission line
voltage and current nodes coincide
voltage and current antinodes coincide
voltage nodes and current antinodes as well as current nodes and voltage antinodes coincide
both (a) and (b)

⇒ Equipment using BCD numbers
pocket calculators
electronic counter
digital voltmeters
all of the above

⇒ The electric flux and field intensity inside a conducting sphere is
minimum
maximum
uniform
zero

⇒ Which of the following capabilities are available in a Universal Shift Register?

Shift left
Shift right
Parallel load
Serial add

Select the correct answer from the codes given below:
2 and 4 only
1, 2 and 3
1, 2 and 4
1, 3 and 4

⇒ The logic realized by the circuit shown in figure belo
F = A - C
F = A + C
F = B ⊙ C
F = B ⊕ C

⇒ When load is coupled to class A amplifier through transformer, efficiency decreases.
TRUE
FALSE

⇒ A JFET can operate on
enhancement mode only
depletion mode only
both depletion as well as enhancement modes
neither depletion nor enhancement mode

⇒

Assertion (A): Stubs, directional couplers and baluns are very commonly used in communication systems

Reason (R): Characteristic impedance of a line is an important parameter.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ What is typical bandwidths of a 2-wire telephone line?
300 Hz to 3.4 kHz
20 Hz to 4 kHz
dc to 4 kHz
20 Hz to 20 kHz

⇒ If a signal g(t) has energy E, then the energy of the signal g(2t) is equal to ...
E/2
E/4
E
2E

⇒ Amplification of ultrasonic waves is possible in a piezoelectric semiconductor under applied electric field. The basic phenomenon involved is known as
electrostriction
acousto-optic interaction
acousto-electric interaction
stimulated Brillouin scattering

⇒ Which of the following is used to generate PDM?
Free running multi-vibrator
Monostable multi-vibrator
JK flip-flop
Schmitt trigger

⇒ A series circuit has fixed resistance and variable reactance. The impedance locus will be a straight line parallel to Y-axis.
TRUE
FALSE

⇒ With respect to transmission parameters, which one of the following is correct?
A and B are dimensionless
B and C are dimensionless
A and D are dimensionless
B and D are dimensionless

⇒ VTM stands for voltage tunable magnetron.
TRUE
FALSE

⇒ Thermal noise has a power spectral density which is quite uniform upto frequencies in the order of
100 Hz
10⁶ Hz
10⁹ Hz
10¹³ Hz

⇒ The number of possible colours with a 4 line digital input monitor are
4
16
64
2

⇒ The main advantage of TWT over klystron is
higher bandwidth
higher gain
higher frequency
higher output

⇒ Consider the following
only statement 1 is correct
only statement 2 is correct
both statements are correct
both the statements 1 and 2 are not correct

⇒ In a class C amplifier, full cycle conductor of the current is achieved by employing
tuned circuit
transformers
complementary pair
Push pull configuration

⇒ The v-i characteristics of a FET is shown in figure. In which region is the device biased for small signal amplifica
AB
BC
CD
BD

⇒ Consider the following statements about DRAM

Page mode read operation is faster than RAS read
RAS input remains active during column address strobe
The row and column addresses are strobed into the internal buffers using RAS and CAS inputs respectively

Which of the above statements are correct?
1 and 3 only
All
1 and 2 only
2 and 3 only

⇒

Assertion (A): Peak to peak value of a sinusoidal wave is 2.828 times the rms value.

Reason (R): Peak factor of a sinusoidal wave is 1.414.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The instrument used to check insulation of household wiring is
megger
ohmmeter
multimeter
high resistance voltmeter

⇒ In the transformer shown in figure, the inductance measured across terminal 1 and 2 was 4 H with terminals 3 and 4 open. It was 3H when terminals 3 and 4 are short circuited. The coefficient of couplin
1
0.707
0.5
indeterminate due to insufficient data

⇒ Find the value of K and velocity constant K_v so that the maximum overshoot in the unit step response is 0.2 and the peak time is 1
12.37, 0.175
12.86, 2.175
11.36, 1.175
1.86, 0.175

⇒ Characteristic impedance of a coaxial cable is inversely proportional to ∈_r.
TRUE
FALSE

⇒ As compared to dimensions of most feeds, the skin depth at microwave frequencies is
of the same magnitude
much larger
much smaller
either (b) or (c)

⇒ A multivibrator generates
sinusoidal waveforms
non-sinusoidal waveforms
both (a) and (b)
none of the above