Question is ⇒ To ensure that a zener diode does not get destroyed, Options are ⇒ (A) the applied voltage should not exceed breakdown voltage, (B) the current should not exceed rated current, (C) the current should be less than magnitude of barrier potential, (D) both (a) and (b), (E) , Leave your comments or Download question paper.

Question is ⇒ To ensure that a zener diode does not get destroyed, Options are ⇒ (A) the applied voltage should not exceed breakdown voltage, (B) the current should not exceed rated current, (C) the current should be less than magnitude of barrier potential, (D) both (a) and (b), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	To ensure that a zener diode does not get destroyed
A.	the applied voltage should not exceed breakdown voltage [Wrong Answer]
B.	the current should not exceed rated current [Correct Answer]
C.	the current should be less than magnitude of barrier potential [Wrong Answer]
D.	both (a) and (b) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ An intrinsic semiconductor (intrinsic electron density = 10¹⁶ m^-3) is deped with donors to a level of 10²² m^-3. What is the hole density assuming all donors to be ionized?
10⁷ m^-3
10⁸ m^-3
10¹⁰ m^-3
10⁶ m^-3

⇒ The poles and zeros of a positive real function
may lie any where in s plane
may have positive or negative real part
must occur in conjugate pair
must have either negative or zero real part

⇒ His rather casual remarks on politics __________ his lack of seriousness about the subject.
masked
belied
cherish
conserve

⇒ Binary number 1101101101 is equal to decimal number
3289
2289
1289
289

⇒

Match the following:

	Microwave Measuring Instruments		Measurements Effected
A.	Bolometer	1.	Reflection coefficients
B.	VSWR meter	2.	Half power beam widths
C.	Cavity wave meter	3.	Microwave power
D.	Pattern recorder	4.	Microwave frequency

A-2, B-1, C-4, D-3
A-3, B-1, C-4, D-2
A-2, B-4, C-1, D-3
A-3, B-4, C-1, D-2

⇒ In a purely inductive ac circuit, the supply voltage and voltage induced across inductance are equal and opposite at all instants.
TRUE
FALSE

⇒ A full adder adds
2 bits
3 bits
4 bits
any number of bits

⇒ Which capacitor-store higher amount of energy?
Air capacitor
Paper capacitor
Mica capacitor
Plastic film capacitor

⇒ At a temperature of about 1 K, aluminium is a
conductor
insulator
photoconductor
superconductor

⇒ Linear diode detector utilizes
linear portion of static characteristics of diode
linear portion of dynamic characteristic of diode
square law portion of dynamic characteristics of diode
rectification property of diode

⇒ Which statement is true for an ac circuit?
Active power is always less than apparent power
Active power cannot be more than apparent power
Active power is always more than reactive power
Active power cannot be more than reactive power

⇒ In a 3 phase full wave regulator feeding a star connected resistance load, firing angle is 75°. Then the number of thyristors conducting at one time is
1
2
3
4

⇒ In which of the following is the width of junction barrier very small?
Tunnel diode
Photo diode
PIN diode
Schottky diode

⇒ A network N is dual of network N if
both of them have same mesh equation
both of them have same node equation
mesh equation of one are the node equations of the other
KCL and KVL equations are the same

⇒ Which one is correct statement?

Circuit is always open
Network is always open
Circuit is always closed
Network is always closed

1, 2
2, 3
3, 4
1, 4

⇒ A 1 μF capacitor is connected to 12 V battery. The energy stored in the capacitor is
12 x 10^-6 J
24 x 10^-6 J
48 x 10^-6 J
72 x 10^-6 J

⇒ Which of the following number specification refers to FET with one gate?
2N
3N
3Y
3X

⇒ Common emitter transistor has
high current and high voltage gain
low current gain and low voltage gain
high current gain and low voltage gain
low current and voltage gain

⇒ Measurement of non-electrical quantity involves the following subsystems

Amplifier block
Display block
Instrumentation block
Transducer block

The correct sequence of these blocks is
4, 1, 3, 2
4, 3, 1, 2
1, 3, 2, 4
1, 2, 3, 4

⇒

Assertion (A): Microprocessor 8085 has facility of interrupt control.

Reason (R): TRAP, RST 7.5, RST 6.5, RST 5.5 and 1NTR are interrupt signals in 8085.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ The switch in the circuit shown was on position a for a long time, and is moved to position b at time t = 0. The current i(t) for t > 0 is give
0.2e^-125tu(t) mA
20e^-1250tu(t) mA
0.2e^-1250tu(t) mA
20e^-1000tu(t) mA

⇒ FET amplifier is more difficult to analyse than BJT amplifier.
TRUE
FALSE

⇒ In C the keywords are also called
special words
reserved words
class words
character words

⇒ The concentration of minority carriers in a semiconductor depends mainly on
the extent of doping
temperature
the applied bias
none of the above

⇒ An electrodynamometer instrument has the advantage of
freedom from hysteresis and eddy currents because air cored coils are used
freedom from hysteresis and eddy currents because cores of coils have special ferromagnetic material
high torque/weight ratio
low cost

⇒

Match the following:

	List I (Antenna)		List II (Communication system)
A.	Turnstile	1.	Radar
B.	Yagi	2.	TV transmission
C.	Dish	3.	MW broadcasting
D.	Vertical mast	4.	TV reception

A-4, B-2, C-3, D-1
A-2, B-4, C-1, D-3
A-2, B-4, C-3, D-1
A-4, B-2, C-1, D-3

⇒ The impurity added to extrinsic semiconductor is of the order of
1 in 100
1 in 1000
1 in 100, 0000
1 in 100, 000, 000

⇒ The divergence of the electric field intensity at any point equals
1/4 pε₀ times the volume charge density
l/ε₀ times the volume charge density at that point
ε₀ times the volume charge density at that point
the volume charge density at that point

⇒ Am equivalent 2's complement representation of the 2's complement number 1101 is
110100
1101
110111
111101

⇒ In a voltage regulated power supply the zener operates in the breakdown region when (V_in is input voltage and V_z is zener breakdown voltage)
V_in < V_z
V_in > V_z
V_in = V_z
both (a) or (b)