Question is ⇒ In <i>p</i> type semiconductor, the hole concentration, Options are ⇒ (A) is nearly equal to density of acceptor atoms, (B) is much greater than density of acceptor atoms, (C) is much less than density of acceptor atoms, (D) may be equal to or more or less than density of acceptor atoms, (E) , Leave your comments or Download question paper.

Question is ⇒ In <i>p</i> type semiconductor, the hole concentration, Options are ⇒ (A) is nearly equal to density of acceptor atoms, (B) is much greater than density of acceptor atoms, (C) is much less than density of acceptor atoms, (D) may be equal to or more or less than density of acceptor atoms, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In p type semiconductor, the hole concentration
A.	is nearly equal to density of acceptor atoms [Correct Answer]
B.	is much greater than density of acceptor atoms [Wrong Answer]
C.	is much less than density of acceptor atoms [Wrong Answer]
D.	may be equal to or more or less than density of acceptor atoms [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If a wave is propagated in free space, it will be in nature of
TE
TM
TEM
Any one of above

⇒ Frequency modulation consists in
varying the frequency and amplitude of the carrier in accordance with the instantaneous value of modulating signal
varying the amplitude of the carrier in accordance with the instantaneous value of the modulating voltage
varying the frequency of the carrier voltage in accordance with the instantaneous value of the modulating voltage
vary the frequency of the carrier voltage

⇒ In the stabilized reactance modulators AFC system
the discriminator must have a fast time constant to prevent demodulation
the higher discriminator frequency the better the oscillator frequency stability
the discriminator frequency must not be too low, or the system will fail
phase modulation is converted into FM by the equalizer circuit

⇒ If the switch is thrown to the START position, Q and Y will be equal to
Q = 0, Y = 0
Q= 1, Y= 1
Q = 1, Y = CLK
Q = 0, Y = CLK

⇒ In a class C operation
V_CC is much larger than V_CE(sat)
V_CC is much smaller than V_CE(sat)
V_CC and V_CE(sat) are nearly equal
none of the above

⇒ If a common emitter amplifier with an emitter resistance R_C has an overall transconductance gain of 1 m A/V, a voltage gain of - 4 and desensitivity of 50, then the value of the emitter resistance R would be
50 kΩ
0.98 kΩ
50 Ω
0.98 Ω

⇒

Match the following:

	List I		List II
A.	45	1.	10110100
B.	90	2.	11010010
C.	180	3.	01011010
D.	210	4.	00101101
		5.	10101000

A-3, B-4, C-5, D-2
A-4, B-3, C-5, D-2
A-4, B-3, C-1, D-2
A-3, B-4, C-2, D-1

⇒ The complement of Boolean expression AB (B C + AC) is
(A + B) + (B + C) + (A + C)
A B + (B + C)(A + C)
(A + B) + (B + C) (A + C)
none of the above

⇒ Consider the following statements

EEPROM has the problem of high write time.
EEPROM has the problem of limited number of write cycles.
Shadow RAM has the problem of high write time.

Which of the above statements are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ The circuit in figure is
resonant commutation
line commutation
auxiliary commutation
complementary commutation

⇒ Which of the following is λ/2 length?
Marconi
Hertz
Parabolic
Yagi-uda

⇒ Measurement of Hall coefficient enables the determination of
recovery time of stored carrier
type of conductivity and concentration of charge carriers
temperature coefficient and thermal conductivity
Fermi level and forbidden energy gap

⇒ The silicon sample with unit cross-sectional area shown below is in thermal equilibrium. The following information is given: T = 300 K, electronic charge = 1.6 x 10^-19C, thermal voltage = 26mV and electron mobility = 1350 cm²
1 kV/cm
5 kV/cm
10 kV/cm
26 kV/cm

⇒ Some possible disadvantages of high level modulation in TV transmitters are

Video monitor has to supply high video voltages upto several hundred volts into highly capacitive loads drawing high current at video frequencies
The grid modulated stage presents a varying load to its driver
The linearity and high video driving power present design problems

Out of above which are true?
1 only
1 and 2 only
1, 2 and 3
2 and 3 only

⇒ Consider the following differences between QPSK and MSK

The side lobes in MSK are relatively much smaller in comparison to the main lobe
The spectrum of MSK has a main centre lobe which is 1.5 times as wide as the main lobe of QPSK
The waveforms of both MSK and QPSK exhibit phase continuity

Which of the above statements are correct?
1 only
1 and 2 only
1, 2 and 3
2 and 3 only

⇒ A MASER is a
low noise device
high noise device
medium noise device
may be either high or medium noise device

⇒ The conductivity of materials found in nature ranges from 10⁹ ohm^-1m^-1 to nearly 10¹⁸ ohm^-1 m^-1 from this it can be concluded that the conductivity of silicon in ohm^-1 cm^-1 will be nearly
0.5 x 10^-15
0.5 x 10^-21
0.5 x 10^-12
0.5 x 10^-3

⇒ A major advantage of TWT over a Klystron lies in its
higher bandwidth
higher gain
higher frequency
higher output

⇒ If the AF voltage is raised to 10 V, while the AM is dropped to 200 Hz, what is the deviation?
10 kHz
15 kHz
20 kHz
40 kHz

⇒ The earliest uses of electromagnetic waves were
point to point communication
radar
both (a) and (b)
neither (a) nor (b)

⇒ The current distribution along a travelling wave antenna can be written in the form
f(z) = f₀e^-jβ_z
f(z) = f₀ sin β_z
f(z) = f₀
f(z) = f₀ cos (ωt - β_z)

⇒ A power supply has full-load voltage of 20 V. What will be its no load voltage when its voltage regulation is 100%
0 V
10 V
20 V
40 V

⇒

Match the following:

	List I (Diode Rectifier)		List II (Efficiency is R_f/R_L = 0.25)
A.	Half wave	1.	0.54
B.	Bridge Rectifier	2.	0.65
C.	Full wave using tapped centre transformer	3.	0.325

A-1, B-2, C-3
A-2, B-1, C-3
A-3, B-2, C-1
A-3, B-1, C-2

⇒ If the amplitude of the voltage is kept constant, but its frequency is raised to 6 kHz, the new deviation will be for the modulation index is, if f_m = 500 Hz, Δf = 2.25
6 kHz
12 kHz
27 kHz
54 kHz

⇒ In 8085
RST 6.5 and RST 5.5 are high level sensitive interrupts
RST 6.5 and RST 5.5 are low level sensitive interrupts
RST 5.5 is low level sensitive interrupt but RST 5.5 is high level-sensitive interrupt
RST 5.5 is low level sensitive interrupt but RST 6.5 is high level sensitive interrupt

⇒ An angle modulated signal is given by s(t) = cos 2p (2 x 10⁶t + 30 sin 150t + 40 cos 150t). The maximum frequency and phase deviations of s(t) are
10.5 kHz, 140p rad
6 kHz and 80p rad
10.5 kHz, 100p rad
7.5 kHz, 100p rad

⇒ An OR gate has 4 inputs. One input is high and the other three are low. The output
is low
is high
is alternately high and low
may be high or low depending on relative magnitude of inputs

⇒ The inverse of given Laplace transfor
sin t
cos t
e^t
e^2t

⇒ A parallel RLC circuit has ω₀ = 10⁶ and Q = 30, Given C = 30 pF, the value of R is
0
1 μΩ
2 MΩ
1 MΩ

⇒ The unit of loudness is
phon
sone
decibel
mel