Question is ⇒ For a wave v = V 1m sin (ωt + θ1 ) - V3m sin (3ωt + θ3), the rms value is (0.5 V21m + 0.5 V23m)0.5, Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ For a wave v = V 1m sin (ωt + θ1 ) - V3m sin (3ωt + θ3), the rms value is (0.5 V21m + 0.5 V23m)0.5, Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For a wave v = V _1m sin (ωt + θ₁ ) - V_3m sin (3ωt + θ₃), the rms value is (0.5 V²_1m + 0.5 V²_3m)^0.5
A.	TRUE [Correct Answer]
B.	FALSE [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Match the following:

	List I		List II
A.	Continuous and aperiodic	1.	Fourier representation is continuous and aperiodic
B.	Continuous and Periodic	2.	Fourier representation is discrete and aperiodic
C.	Discrete and aperiodic	3.	Fourier representation is continuous and periodic
D.	Discrete and periodic	4.	Fourier representation is discrete and periodic

A-3, B-2, C-4, D-1
A-1, B-3, C-2, D-4
A-1, B-2, C-3, D-4
A-2, B-1, C-4, D-3

⇒ If the sign bit of mantissa is 0 and the exponent is increased from a positive to a more negative number the result is
a larger floating point number
a smaller floating point number
either (a) or (b) depending on the actual number
a negative floating point number

⇒ A rectangular waveguide is a
rectangular conducting wire to propagate electromagnetic waves
hollow rectangular walled room carrying electromagnetic wave
hollow rectangular conducting tube through which electromagnetic waves can be propagated
tube antenna to transmit and receive electromagnetic waves

⇒ The impulse response of the DT - LTI system is given be
1 and 2
2 and 3
1 and 3
1, 2 and 3

⇒ In a BCD to 7 segment decoder the minimum and maximum number of outputs active at any time is
2 and 7
3 and 7
1 and 6
3 and 6

⇒

Assertion (A): If the duty cycle of chopper is low the current would not become discontinuous

Reason (R): If the time constant L/R of the load in chopper is low the current may become discontinuous.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The geostationary communication satellite APPLE is parked in the equatorial orbit at
102° E longitude over Sumatra
90° E longitude over Bangladesh
74° E longitude over India
67° E longitude over Pakistan

⇒ The ripple factor for a bridge rectifier is
0.406
1.21
1.11
2.22

⇒ A line has L = 0.8 µH/m and C = 32 pF/m. Z₀ =
6000
600
158
15.8

⇒ The most commonly used logic family is
ECL
TTL
CMOS
PMOS

⇒ If A = 0101, then A' is
1010
1011
1001
110

⇒

Assertion (A): For a dielectric, P = ∈₀(∈_r - 1) E.

Reason (R): Dipole moment per unit volume is called polarization of dielectric.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ IC 74181 performs arithmetic operations when M = 1.
TRUE
FALSE

⇒ In figure, the value of R shoul
5 kΩ
50 kΩ
20 kΩ
10 kΩ

⇒ 9's complement of 12₁₀ is
21₁₀
87₁₀
78₁₀
76₁₀

⇒ In CC configuration, the output signals has approximately
the same amplitude and phase
opposite amplitude and phase
same amplitude but opposite phase
none of the above

⇒ The phase angle curve of G(jω) H(jω) is drawn by adding the phase angles of individual factors.
TRUE
FALSE

⇒

Assertion (A): Most of actual systems are non-linear.

Reason (R): Non linearity may be due to saturation, dead zone, square law etc.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ In a thyristor, the forward breakover voltage
is constant
may be constant or may depend on gate current
decreases as gate current is increased
increases as gate current is increased

⇒ If a and b are the width and height of rectangular wave-guide the cut off wavelength λ_c for TE₂₀ mode is equal to
a
a + b
a - b
a² + b²

⇒ The 2 out of 5 code has
two 0s and three 0s in each code group
one 1s and four 0s in each code group
four 1s and one 0s in each code group
three 1s and two 0s in each code group

⇒ The phase angle curve of G(jω) H(jω) can be drawn
by adding the phase angle curves of individual factors
by subtracting the phase angle curves of individual factors
by multiplying the phase angle curves of individual factors
by dividing the phase angle curves of individual factors

⇒ The purpose of impedance matching in an amplifier circuit is to achieve
high efficiency
reduce distortion
maximum power transfer
none of the above

⇒ If f(t) = r (t - a), F(s) =
e^-as/s²
a/(s + a)
1/(s + a)
e^-as/s

⇒ The maximum power dissipation capacity of a transistor is 50 mW. If the collector emitter voltage is 10 V, what is the safe collector current that can be allowed through the transistor?
5 mA
2.5 mA
10 mA
25 mA

⇒ In FDM systems used for telephone, which modulation scheme is adopted?
AM
DSB-SC
SSB-SC
FM

⇒ If in a radio receiver, RF signal has a frequency of 800 kHz and local oscillator that of 1000 kHz, then at the output of the mixer, the frequencies found would be __________ kHz.
800 to 1000
200, 800, 1000, 1800
only 200
only 1800

⇒ Consider the following applications/ advantages of radar beacons

navigation
target identification
accurate tracking of enemy targets
large increase in maximum range

Which of the above are correct?
1, 2, 3, 4
1, 2, 4
1, 2
2, 3, 4

⇒ In 8421 Binary coded Decimal system the decimal number 237 is represented by
1000110111
1000111110
1000110111
10010010011

⇒

Assertion (A): A presettable counter can be preset to any desired starting point

Reason (R): The maximum frequency of a ripple counter depends on the modulus.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true