Question is ⇒ An antenna couple is used due to all of the following reasons except, Options are ⇒ (A) to prevent reradiation of the local oscillator, (B) to discriminate against harmonics, (C) to make the antenna look resistive, (D) to provide the output amplifier with the correct load impedance, (E) , Leave your comments or Download question paper.

Question is ⇒ An antenna couple is used due to all of the following reasons except, Options are ⇒ (A) to prevent reradiation of the local oscillator, (B) to discriminate against harmonics, (C) to make the antenna look resistive, (D) to provide the output amplifier with the correct load impedance, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An antenna couple is used due to all of the following reasons except
A.	to prevent reradiation of the local oscillator [Correct Answer]
B.	to discriminate against harmonics [Wrong Answer]
C.	to make the antenna look resistive [Wrong Answer]
D.	to provide the output amplifier with the correct load impedance [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following statement about receivers is false?
Double conversion is used to improve image rejection
Double conversion is used to improve selectivity
Variable sensitivity is used to improve selectivity
Variable sensitivity is used to eliminate selective fading

⇒ Consider a 300 Ω, quarter wave long at 1 GHz transmission line as shown in figure. It is connected to a 10 V, 50 Ω source at one end is left open circuited at the other end. The magnitude of the voltage at the open circuit end of the line
10 V
5 V
60 V
60/7 volt

⇒ In a zener diode
the forward current is very high
sharp breakdown occurs at a certain reverse voltage
the ratio v-i can be negative
there are two p-n junctions

⇒ In a transmission line, losses due to dielectric heating are
proportional to voltage and inversely proportional to Z₀
proportional to voltage and proportional to Z₀
proportional to current and proportional to Z₀
proportional to current and inversely proportional to Z₀

⇒ The input impedance of short-circuited line of length l where λ/4 < l < λ/2, is
resistive
inductive
capacitive
none of the above

⇒ Find the FSV (full scale voltage) in a 6 bit R-2R ladder D/A converter has a reference voltage of 6.5 V.
6.4 V
0.1 V
7 V
8 V

⇒ Which of the following amplifier circuit using junction transistor has the best gain?
Common base
Common emitter
Common collector
All have the same gain

⇒ Which of the following is non-saturating?
TTL
CMOS
ECL
Both (a) and (b)

⇒ If the energy is supplied from a source, whose resistance is 1 ohm, to a load of 100 ohms the source will be
a voltage source
a current source
both of the above
none of the above

⇒ The first critical frequency nearest the origin of the complex frequency plane for an RL driving point impedance will be
a zero in left half plane
a zero in right half plane
a pole in left half plane
a pole or zero in left half plane

⇒ EEPROM permits
read operation only
read and byte erase operations
read, byte erase and byte write operations
read, byte erase, byte write and chip erase operations

⇒ Which of the follow
Voltage series feedback and decrease I/P impedance.
Voltage shunt feedback and decrease I/P impedance.
Voltage series feedback and increase I/P impedance.
Voltage shunt feedback and increase I/P impedance.

⇒ In 8085 the instruction MOV A, B is an example of
Direct addressing
Immediate addressing
Register addressing
Register indirect addressing

⇒

Assertion (A): For satellites and space probes, PRF of a radar is pretty low.

Reason (R): PRF of a radar depends on the range of a radar.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A pulse train can be delayed by a finite number of clock periods by using
serial in-serial out shift register
parallel in serial out shift register
serial in-parallel out shift register
parallel in parallel out shift register

⇒ What does the instruction 'PCHL' in 8085 do?
Load the program counter with contents of register pair H L
Double the contents of register pair H L
Shift the contents of register pair H L by one bit to the right
Shift the contents of register pair H L by one bit to left

⇒ Consider the sequence x(n) whose fourier transform X(e^jω) is depicted for - p ≤ ω ≤ p as shown in fig
1 - True, 2 - True, 3 - True, 4 - True
1 - False, 2 - True, 3 - False, 4 - True
1 - True, 2 - False, 3 - True, 4 - False
1 - False, 2 - False, 3 - False, 4 - True

⇒ Which of the following statements is correct?
In the magnetic circuit energy is needed continuously to maintain the flux
In the magnetic circuit energy is needed continuously to maintain the flux
The flow of current in the electric circuit involves discontinuous expedition of energy
The flow of current in the electric circuit requires energy for creating the current but not to maintain it

⇒ For the waveform shown below, the slew rate and full power bandwidth with respect to op-amp will be respecti
0.02 V/μsec, 1.59 KHz
0.04 V/μsec, 1.59 KHz
0.02 V/μsec, 3.58 KHz
0.02 V/μsec, 1.59 KHz

⇒ To ensure that only dominant mode TE₁₀ is allowed to propagate in an air filled rectangular waveguide, the lower frequency limit and upper frequency limit are
about 25% above f_c for TE₁₀ and 5% below f_c for TE₂₀ mode respectively
about 50% above f_c for TE₁₀ and 25% below f_c for TE₂₀ mode respectively
about 25% above f_c for TE₁₀ and 25% below f_c for TE₂₀ mode respectively
none of the above

⇒ Which type of modulator amplifier is used in AM transmitter?
Class A
Class B
Classes AB
Class C with negative feedback

⇒ An interrupt in which the external device supplies its address as well as the interrupt is known as
vectored interrupt
maskable interrupt
polled interrupt
non-maskable interrupt

⇒ Which of the following is used as a passive component in electronic circuits?
Tunnel diode
Capacitor
Transistor
Vacuum tube

⇒ In waveguide Degenerate modes are
two mode having same cut off frequency
two mode having same power
two mode having same phase velocity
it is a hypothetical mode

⇒ Pressing a key on telephone set generates two frequencies. The basis for selection of these frequencies is
the harmonics of one frequency should not be mistaken for the other frequency
the audio input to the handset transmitter should not be mistaken for a key pressing
both (a) and (b)
neither (a) nor (b)

⇒ For a distortionless line, the parameters are related as
R/G = L/C
R/L = 1
R/G = C/L
RG = LC

⇒ Measurement of an unknown voltage with a dc potentiometer loses its advantage of open circuit measurement when
the primary circuit battery is changed
standardization has to be done again to compensate for drifts
voltage is larger than range of the potentiometer
range reduction by a factor of 10 is employed

⇒ For attenuation of high frequencies we should use
shunt capacitance
series capacitance
inductance
resistance

⇒ In a reflex klystron oscillator, repeller electrode is at
low positive potential
high positive potential
negative potential
zero potential

⇒ Which junction has least junction capacitance?
Alloy
Grown
Diffused
Point contact