Question is ⇒ In an op-amp comparator, the positive or negative output is, Options are ⇒ (A) saturated, (B) amplifier, (C) unsaturated, (D) any of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ In an op-amp comparator, the positive or negative output is, Options are ⇒ (A) saturated, (B) amplifier, (C) unsaturated, (D) any of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In an op-amp comparator, the positive or negative output is
A.	saturated [Correct Answer]
B.	amplifier [Wrong Answer]
C.	unsaturated [Wrong Answer]
D.	any of the above [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A parity detector can detect
single error only
single error or odd number of errors
two errors
single or two errors

⇒ In figure, V reads 45V. Then
10.1 A
13.3 A
16.1 A
19.4 A

⇒ The time required for horizontal blanking is 16% of that for each horizontal line. If horizontal time is 63.5 μs, the horizontal blanking time for each line is about
1 μs
10 μs
100 μs
none of the above

⇒ 1 GHz is equal to
10⁶ Hz
10⁸ Hz
10⁹ Hz
10¹⁰ Hz

⇒ Which of the following are needed both for protection and metering?
Wattmeters
Instrument transformers
Energy meters
Power factor meters

⇒ Panel type instruments are used in
power stations
automobiles
industries
all of the above

⇒ An arrangement of several individual antennas to spaced and phased that their individual contributions combine in one preferred direction and cancel in all other directions, to get greater directive gain or directivity, is known as
directional radiation of antennas
antenna gain stability
array of antennas
none of the above

⇒ The number of thyristors in a single phase fully controlled bridge rectifier is
16
8
4
2

⇒ When diodes are connected in series to increase voltage rating the peak inverse voltage per junction
should not exceed half the breakdown voltage
should not exceed the breakdown voltage
should not exceed one third the breakdown voltage
may be equal to or less than breakdown voltage

⇒ When the length of antenna is a whole wavelength
the radiation at right angles is zero
the radiation at right angles is maximum
the radiation is zero in all directions
the radiation is maximum in all directions

⇒ Hall's effect can be used to measure
magnetic field intensity
average number of holes
carriers concentration
electrostatic field intensity

⇒ An advantage of memory interlacing is that
a larger memory is obtained
effective speed of memory is increased
cost of memory is reduced
a non-volatile memory is obtained

⇒ The density of states (i.e. number of states per eV per m³) in the conduction band for energy level E is proportional to
E
E
E^1.5
E²

⇒ End fire array is called a linear resonant dipole array.
TRUE
FALSE

⇒ Which of the following can not be used as a variable name in C?
else
coal
ram
vendy

⇒ In the circuit of figure the current through 5 Ω resistance at t = &infin
0.166666666666667
2.5 A
3.1 A
0

⇒ Which of the following assembler directives in 8085 does not cause any memory location to be used μp?
D S
D B
D W
E Q U

⇒ The curve representing Ohm's law is
linear
a parabola
a hyperbola
sine function

⇒

Assertion (A): Schottky transistors are preferred over normal transistors in digital circuits

Reason (R): A Schottky transistor when used as a switch, between cutoff and active region.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The specific gravity of tungsten is 13.8 and its atomic weight is 184.0 Assume that there are two free elements per atom. Then the Fermi level or characteristic energy for the crystal in eV will be
8.95 eV
-8.95 eV
7.326 eV
-7.326 eV

⇒ The message carrying efficiency is best in
AM
FM
AM-SC
Phase modulation

⇒ In a radio receiver, the local oscillator is always tuned to a frequency higher than the incoming frequency to
facilitate tracking
allow permit adequate frequency coverage without switching
facilitate image frequency rejection
all of the above

⇒ A p matching network for coupling the transmitter output of the antenna is shown in figu
minimum D.C. plate current
maximum D.C. plate current
maximum RF antenna current
specified value of the D.C. plate current

⇒ SCR can be turned on by

applying anode voltage at a sufficient fast rate
applying sufficiently large anode voltage
increasing the temperature of SCR to a sufficiently
applying sufficiently large gate current.

1, 2, 4 only
4 only
1, 2, 3, 4
none

⇒ Which one is Analog Continuous modulation technique?
AM
DM
PAM
PCM

⇒ In an op-amp differentiator
the amplitude of output is proportional to rate of change of input
the amplitude of output is proportional to input
output occurs when input is finite and constant
polarity of input and output is the same

⇒ Which element exhibits the property of inertia?
Resistance
Capacitance
Inductance
Both resistance and inductance

⇒ The inverse of given Laplace transfor
sin t
cos t
e^t
e^2t

⇒ Noise limiter is provided on AM receivers to
reduce interfering noise due to ignition system
reduce noise due to electrical storms
reduce interference due to electrical machinery
all of the above

⇒ In a line with finite attenuation
power transmission is least efficient when there are no standing waves on the line
power transmission is most efficient when there are no standing waves on line
Load power depends on phase constant
standing waves will always exist on the line