Question is ⇒ DeMorgan's second theorem is, Options are ⇒ (A) A . A = 0, (B) A = A, (C) A + B = A . B, (D) AB = A + B, (E) , Leave your comments or Download question paper.

Question is ⇒ DeMorgan's second theorem is, Options are ⇒ (A) A . A = 0, (B) A = A, (C) A + B = A . B, (D) AB = A + B, (E) , Leave your comments or Download question paper. A = 0, (B) A = A, (C) A + B = A . B, (D) AB = A + B, (E) , Leave your comments or Download question paper. '/> A = 0, (B) A = A, (C) A + B = A . B, (D) AB = A + B, (E) , Leave your comments or Download question paper. '/>Previous question Next question


Q1.	DeMorgan's second theorem is
A.	A . A = 0 [Wrong Answer]
B.	A = A [Wrong Answer]
C.	A + B = A . B [Wrong Answer]
D.	AB = A + B [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For H(s) to be positive real, the condition Re[H(jω)] ≥ 0 for 0 ≤ ω ≤ ∞ is
a necessary condition
a sufficient condition
a necessary and sufficient condition
is not a necessary condition

⇒ Consider an angle modulated si
10W
18W
20W
28W

⇒ A radio station works at 800 kHz and uses AM. If this is a public broadcast system, it should transmit using
parabolic reflector to transmit all round
turnstile antenna for the required land
half wave long horizontal wave
a vertical antenna less than quarter for practical reasons

⇒ In the circuit of figure, the value of r_e is (neglecting v_{be100 Ω
75 Ω
50 Ω
25 Ω}

⇒ In telephone systems the relation between load r, number of calls initiated during a specified interval λ and average duration of a call (h) is
r = λh
r = λh²
λ = rh
h = λr

⇒ The output of a battery eliminator is about
110 V DC
110 V AC
45 V DC
6 V DC

⇒

Assertion (A): Magnetic tape can be accessed only sequentially.

Reason (R): Magnetic tape consists of magnetised spots or tracks.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ An RC impedance function has a constant value at s = 0. The last element in the first cauer synthesis
will be a capacitor
may be R or C
will be R
will depend on the behaviour of function at s = ∞

⇒ In a superheterodyne receiver, the IF stage has better selectivity than RF stage because
of higher frequency
of lower frequency
of high L/C ratio
of constant passband

⇒ Which of the following is not a valid variable in FORTRAN 77?
BRG
VS
VS 3A
3 VSA

⇒ A Clapp's oscillator is
a modified Hartley oscillator
a modified Colpitt's oscillator
a modified RC oscillator
none of the above

⇒ During discharging a capacitor through a resistance, voltages across R and C are equal in magnitude.
TRUE
FALSE

⇒ Typical value of reverse current in a semiconductor diode is
0.0416666666666667
0.1 A
1 μA
0.1 μA

⇒ State variable formulation is very suitable for computer solution.
TRUE
FALSE

⇒

Assertion (A): A TRIAC is a bidirectional SCR.

Reason (R): A TRIAC is a four layers 3 terminal device and can conduct in both directions.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which one of the following cannot be used to remove the unwanted sideband in SSB?
Balanced modulator
Phase shift method
Filter system
Third method

⇒ Electric dipole moment is usually expressed in debye units. Here, 1 debye unit equals
3.33 x 10^-30 C-m
3.33 x 10^-30 C-m²
3.30 x 10^-10 C-m
3.33 x 10^-10 C-m²

⇒ In the vacuum diode equation i_b = ke_b^1.5, the current is
temperature limited current
space charge limited current
any of the above
none of the above

⇒ The Boolean expression (A + B) (A + C) (B + C) simplifies to
(A + B) C
(A + B) C
(A + B) C
none of these

⇒ Resistivity of metals consists of two parts, one part constant and the other temperature dependent.
TRUE
FALSE

⇒ A static induction thyristor
is a majority carrier device
is a minority carrier device
either a majority carrier or minority carrier device
has a total number of 2 leads

⇒ The system shown in figure remains stable wh
k £ - 1
-1 < k < 1
l < k < 3
k > 3

⇒ For an RC admittance function
all poles and zeros are simple
all poles and zeros are simple and lie on negative real axis
all poles and zeros lie on imaginary axis
all poles and zeros lie on positive real axis

⇒ In AM, if modulation index is more than 100%, then
bandwidth increases
the wave gets distorted
power of the wave increases
efficiency of transmission increases

⇒ A two port network is said to be reciprocal if
h₁₂ = - h₂₁
AD - BC = 1
y₁₂ = y₂₁
all

⇒ Consider isotropic radiator radiating a power of 1 watt. At a distance of 1 metre, the power per unit area with equal
1 watt/m²
4p watt/m²
1/4p watt/m²
2p watt/m²

⇒ If other parameter are constant, transmission loss at 5 GHz as compared to that at 0.5 GHz is
20 dB more
20 dB less
700 dB more
100 dB less

⇒ A 400 W carrier is amplitude modulated with m = 0.75. If single side band suppressed carrier is used the total power in modulated wave is
400 W
512 W
112 W
56 W

⇒ As temperature increases
the forbidden energy gap in silicon and germanium increase
the forbidden energy gap in silicon and germanium decrease
the forbidden energy gap in silicon decreases while that in germanium decreases
the forbidden energy gap in silicon increases while that in germanium decreases

⇒ In 8085, TRAP is
always maskable
cannot interrupt a service subroutine
used for catastrophic events like temporary power failure
lowest priority interrupt