Users Also Read
MCQ's Search Engine
Electrical Engineering
Mechanical Engineering
Civil Engineering
Automobile Engineering
Chemical Engineering
Computer Engineering
Electronics Engineering
Medical Science Engg
A gate function which occurs at t = t_{0} and lasts for duration T can be written as | |
A. | u (t - t_{0} - T) [Wrong Answer] |
B. | u(t - t_{0}) = u(t - t_{0} - T) [Wrong Answer] |
C. | u(t - t_{0}) - u(t - t_{0} - T) [Correct Answer] |
D. | u(t - t_{0}) - u(t - t_{0} + T) [Wrong Answer] |
View Answer
Explanation:-
Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result |
Also Read Similar Questions Below :
⇒ The series element for a prototype high pass filter is
resistive
inductive
capacitive
combination of L and C
⇒ In memory mapped I/O means that
an input or output device is treated by the microprocessor as one memory location
input or output devices are treated as distinct
an address on the address bus may refer either to a memory location or to an I/O device
none of the above
⇒ Poles and zeros of a driving point function of a network are simple and alternate on jω axis. The network consists of
R and C
L and C
R and L
R, L and C
⇒ The type of noise that interfere very much with high frequency transmission is
white
transit time
flicker
shot
⇒ A-P type material has an acceptor ion concentration of 1 x 10^{16} per cm^{3}. Its intrinsic carrier concentration is 1.48 x 10^{10}/ cm. The hole and electron mobilities are 0.05m^{2}/V-sec and 0.13 m^{2}/V-sec respectively calculate the resistivity of the material
12.5 Ω-cm
1.25 Ω-cm
0.125 Ω-cm
125 Ω-cm
⇒ The ROC of sequence x[n] = (0.8)^{n} ∪[n] + (0.4)^{n} ∪[n]
|z| > 0.8
|z| > 0.4
0.4 < |z| < 0.8
|z| < 0.8
⇒ Unit of e is __________ .
coulomb/newton-metre
coulomb^{2}/newton-metre
Farad/metre
Farad^{2}/metre
⇒ For an RC admittance function
the lowest critical frequency is a zero
the highest critical frequency is a pole
the lowest critical frequency is zero and the highest critical frequency is a pole
the lowest critical frequency is a pole
⇒ In a 3 phase full converter the average load current is 150 A. The average thyristor current is
150 A
75A
50 A
25 A
⇒ An electron in the conduction band
has higher energy than the electron in the valence band
has lower energy than the electron in the valence band
loses its charge easily
jumps to the top of the crystal
⇒ Find I for circuit shown b
0.125
0.0416666666666667
0.0833333333333333
0
⇒
A-1, B-3, C-5
A-5, B-4, C-2
A-6, B-4, C-5
A-2, B-4, C-5
⇒ In the circuit of figure the switch is closed at t = 0, At t = 0^{+} this current through inductanc
0
0.416666666666667
6.67 A
5.1 A
⇒ In a second order system with a unit step input, the speed of response is high if system is
overdamped
undamped system
critically damped
underdamped
⇒ Consider z transform of a signal as given b
IIR
FIR
Depends on value of n
Cannot determined
⇒ Two CE stages, 1 and 2 are coupled through a capacitor. V_{CC} is the same for both. Base resistances R_{B1} and R_{B2} are such that R_{B1} > R_{B2}. Then
base currents for both stages are equal
base current of stage 1 is more than that of stage 2
base current of stage 2 is more than that of stage 1
either (b) or (c)
⇒ A (75 - j 40) W load is connected to a co-axial line of z_{0} = 75ω at 6 MHz. The load matching on the line can be accomplished by connecting
a short circuit stub at the load
an inductance at the load
a short circuit stub at a specific distance from the load
a capacitance at a specific distance from the load
⇒ Find the radiation resistance of an antenna of length λ/10 meter?
8 Ω
780 Ω
7.8 Ω
78 Ω
⇒ In a micro computer the control bus
transmits and receives control signals between processor and other devices
transmits and receives control signals, also sends and receives data
transmits and receives control signals, sends and receives data and transmits address of the device
none of the above
⇒ In the circuit shown in the figure, steady-state was reached when the switch S was open. The switch was closed at t = 0. The initial value of the current through the capacitor 2
zero
0.0416666666666667
0.0833333333333333
0.125
⇒ With respect to the following 555 timer circuit what will be the value of R_{A} and R such that the LED turns on for a duration of 10 ms every time it receives negative trigger pulse. LED operating current = 20 mA, V_{f} = 1.4 V, Vo _{on} = 13.4 V and C = 0.22 nf
41.4 KΩ, 600 Ω
45 KΩ, 630 Ω
43.5 KΩ, 580 Ω
44.9 KΩ, 600 Ω
⇒ In figure, power in 6 Ω resistor is zero then
202∠45°
20 ∠30°
20 ∠45°
202∠30°
⇒ The IF bandwidth of a radar receiver is inversely proportional to
pulse interval
pulse width
PRF
none of the above
⇒ In a Communication system, noise is most likely to affect the signal.
at the transmitter
In the channel
in Information source
at the destination
⇒ The output V_{0} in figur
-100 V
-100 mV
10 V
10 mV
⇒ For a system to work, as oscillator the total phase shift of the loop gain must be equal to
90°
45°
270°
360°
⇒ Kirchoff's voltage law is not valid for a non-linear network
the statement is true
the statement is false
can't say
none of the above
⇒ The power dissipated in 4 Ω resistance in figur
64 W
32 W
16 W
8 W
⇒ Without any addition circuitry, an 8:1 MUX can be used to obtain.
some but not all Boolean functions of 3 variables
all functions of 3 variables but none of 4 variables
all functions of 3 variables and some but not all of 4 variables
all functions of 4 variables
⇒ In figure, the magnitude
must be more than that of V_{a}
must be more than that of V_{b}
must be more than that of V_{a} or V_{b}
can be equal to or less than or more than that of V_{a} or V_{b}
⇒ The series element for a prototype high pass filter is
resistive
inductive
capacitive
combination of L and C
⇒ In memory mapped I/O means that
an input or output device is treated by the microprocessor as one memory location
input or output devices are treated as distinct
an address on the address bus may refer either to a memory location or to an I/O device
none of the above
⇒ Poles and zeros of a driving point function of a network are simple and alternate on jω axis. The network consists of
R and C
L and C
R and L
R, L and C
⇒ The type of noise that interfere very much with high frequency transmission is
white
transit time
flicker
shot
⇒ A-P type material has an acceptor ion concentration of 1 x 10^{16} per cm^{3}. Its intrinsic carrier concentration is 1.48 x 10^{10}/ cm. The hole and electron mobilities are 0.05m^{2}/V-sec and 0.13 m^{2}/V-sec respectively calculate the resistivity of the material
12.5 Ω-cm
1.25 Ω-cm
0.125 Ω-cm
125 Ω-cm
⇒ The ROC of sequence x[n] = (0.8)^{n} ∪[n] + (0.4)^{n} ∪[n]
|z| > 0.8
|z| > 0.4
0.4 < |z| < 0.8
|z| < 0.8
⇒ Unit of e is __________ .
coulomb/newton-metre
coulomb^{2}/newton-metre
Farad/metre
Farad^{2}/metre
⇒ For an RC admittance function
the lowest critical frequency is a zero
the highest critical frequency is a pole
the lowest critical frequency is zero and the highest critical frequency is a pole
the lowest critical frequency is a pole
⇒ In a 3 phase full converter the average load current is 150 A. The average thyristor current is
150 A
75A
50 A
25 A
⇒ An electron in the conduction band
has higher energy than the electron in the valence band
has lower energy than the electron in the valence band
loses its charge easily
jumps to the top of the crystal
⇒ Find I for circuit shown b
0.125
0.0416666666666667
0.0833333333333333
0
⇒
Match the following:
List I | List II | ||
---|---|---|---|
A. | SSB Modulation | 1. | Transmission line |
B. | Δ . B = 0 | 2. | Hilbert transform |
C. | Model dispersion | 3. | Faraday's law |
4. | Absence of magnetic monopoles | ||
5. | Waveguides | ||
6. | Phase locked loop |
A-1, B-3, C-5
A-5, B-4, C-2
A-6, B-4, C-5
A-2, B-4, C-5
⇒ In the circuit of figure the switch is closed at t = 0, At t = 0^{+} this current through inductanc
0
0.416666666666667
6.67 A
5.1 A
⇒ In a second order system with a unit step input, the speed of response is high if system is
overdamped
undamped system
critically damped
underdamped
⇒ Consider z transform of a signal as given b
IIR
FIR
Depends on value of n
Cannot determined
⇒ Two CE stages, 1 and 2 are coupled through a capacitor. V_{CC} is the same for both. Base resistances R_{B1} and R_{B2} are such that R_{B1} > R_{B2}. Then
base currents for both stages are equal
base current of stage 1 is more than that of stage 2
base current of stage 2 is more than that of stage 1
either (b) or (c)
⇒ A (75 - j 40) W load is connected to a co-axial line of z_{0} = 75ω at 6 MHz. The load matching on the line can be accomplished by connecting
a short circuit stub at the load
an inductance at the load
a short circuit stub at a specific distance from the load
a capacitance at a specific distance from the load
⇒ Find the radiation resistance of an antenna of length λ/10 meter?
8 Ω
780 Ω
7.8 Ω
78 Ω
⇒ In a micro computer the control bus
transmits and receives control signals between processor and other devices
transmits and receives control signals, also sends and receives data
transmits and receives control signals, sends and receives data and transmits address of the device
none of the above
⇒ In the circuit shown in the figure, steady-state was reached when the switch S was open. The switch was closed at t = 0. The initial value of the current through the capacitor 2
zero
0.0416666666666667
0.0833333333333333
0.125
⇒ With respect to the following 555 timer circuit what will be the value of R_{A} and R such that the LED turns on for a duration of 10 ms every time it receives negative trigger pulse. LED operating current = 20 mA, V_{f} = 1.4 V, Vo _{on} = 13.4 V and C = 0.22 nf
41.4 KΩ, 600 Ω
45 KΩ, 630 Ω
43.5 KΩ, 580 Ω
44.9 KΩ, 600 Ω
⇒ In figure, power in 6 Ω resistor is zero then
202∠45°
20 ∠30°
20 ∠45°
202∠30°
⇒ The IF bandwidth of a radar receiver is inversely proportional to
pulse interval
pulse width
PRF
none of the above
⇒ In a Communication system, noise is most likely to affect the signal.
at the transmitter
In the channel
in Information source
at the destination
⇒ The output V_{0} in figur
-100 V
-100 mV
10 V
10 mV
⇒ For a system to work, as oscillator the total phase shift of the loop gain must be equal to
90°
45°
270°
360°
⇒ Kirchoff's voltage law is not valid for a non-linear network
the statement is true
the statement is false
can't say
none of the above
⇒ The power dissipated in 4 Ω resistance in figur
64 W
32 W
16 W
8 W
⇒ Without any addition circuitry, an 8:1 MUX can be used to obtain.
some but not all Boolean functions of 3 variables
all functions of 3 variables but none of 4 variables
all functions of 3 variables and some but not all of 4 variables
all functions of 4 variables
⇒ In figure, the magnitude
must be more than that of V_{a}
must be more than that of V_{b}
must be more than that of V_{a} or V_{b}
can be equal to or less than or more than that of V_{a} or V_{b}