Question is ⇒ In a series R-L-C circuit, the voltage across inductance will be maximum, Options are ⇒ (A) at resonance frequency, (B) just before resonant frequency, (C) just after resonant frequency, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ In a series R-L-C circuit, the voltage across inductance will be maximum, Options are ⇒ (A) at resonance frequency, (B) just before resonant frequency, (C) just after resonant frequency, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a series R-L-C circuit, the voltage across inductance will be maximum
A.	at resonance frequency [Wrong Answer]
B.	just before resonant frequency [Wrong Answer]
C.	just after resonant frequency [Correct Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Six sets of electromagnetic waves are given bel
VLF, LF, MF, HF, VHF, UHF
LF, VLF, MF, HF, VHF, VHF
LF, VLF, HF, MF, VHF, UHF
VHF, VLF, HF, MF, LF, UHF

⇒ In which one of the following types of analog to digital converts the conversion time is practically independent of the amplitude of the analog signal?
The dual slope integrating type
Successive approximation type
Counter ramp type
Tracking type

⇒ The circuit in the given figur
low pass filter
high pass filter
band Pass filter
band reject filter

⇒ GaAs has an energy gap 1.43 eV the optical cut off wavelength of GaAs would lie in the
visible region of the spectrum
infrared region of the spectrum
ultraviolet region of the spectrum
for ultraviolet region of the spectrum

⇒ A 16:1 multiplexer has 4 select input lines.
TRUE
FALSE

⇒ Voltage standing wave pattern in a loss less transmission line with characteristic impedance 50 Ω and a resistive load is shown in the figu
50 Ω
200 Ω
12.5 Ω
0 Ω

⇒ DMA stands for
Direct Memory Address
Distributed Memory Address
Direct Memory Accumulator
Decimal Machine Address

⇒ Magnetic deflection is inversely proportional to
voltage
(voltage)^0.5
(voltage)^1.5
(voltage)²

⇒ For a BJT, under the saturation condition,
I_C = βI_B
I_C = aI_B
I_C is independent of all other parameters
I_C < βI_B

⇒ Which of the following is correct?
y₂₂ = z₂₂/|z|
y₁₁ = z₂₂/|z|
z₁₁ = y₁₁/|y|
z₂₂ = y₂₂/|y|

⇒ If φ_sh is flux of shunt magnet, φ_se is flux of series magnet, i_sh is eddy current due to φ_se, the torque in an induction wattmeter is proportional to
φ_se i_se + φ_sh i_sh
φ_sh i_se - φ_se i_sh
φ_sh i_sh - φ_se i_se
φ_sh i_sh + φ_se i_se

⇒ For frequency up to 1650 kHz, the transmitting antenna is used a
parabolic dish
vertical antenna
yagi antenna
turnstile antenna

⇒ A signal m(t) = 5 cos 2p 100 t frequency modulates a carrier. The resulting FM signal
0.1 kHz
6 kHz
3.2 kHz
100 kHz

⇒ The basic storage element in a digital system is
flip flop
counter
multiplexer
encoder

⇒ How can the quantizing noise be reduced?
By using de-emphasis circuit
By using RF amplifier in the receiver
By increasing the number of quantization levels
By sending sloping pulses

⇒ A loss less line is terminated in a circular lines are E lines
SWR = 0
SWE = 0
SWR is finite
SWR = ∞

⇒

Assertion (A): 2's complement arithmetic is preferred in digital computers

Reason (R): The hardware required to obtain 2's complement is simple.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In a JFET, gates are always
forward biased
reverse biased
either forward or reverse biased
unbiased

⇒ Permeance is analogue to
reluctance
conductance
capacitance
resistance

⇒ For a class B amplifier using a supply of V_CC = 30 V and driving a load of 16 Ω the maximum efficiency will be __________ .
0.724
0.7854
0.624
0.6854

⇒ In a single phase full wave regulator feeding R-L load, short gate pulse are not suitable.
TRUE
FALSE

⇒ If the functions w, x, y, z are as foll
w = z x = z
w = z, x = y
w = y
w = y = z

⇒ The inductance of a single layer solenoid of 10 turns is 5 μH. Which one of the following is the correct value of inductance when the number of turns is 20 and the length is doubled.
10 μH
20 μH
40 μH
5 μH

⇒ In the network of figure it is desired that maximum power be supplied to Z₂. The values of Z₁ and Z₂ are fixed. However the transformation ratio 'a' of transformer can be changed. The value of 'a' for maximum power transfe
|Z₂|/|Z₁|
[|Z₂|/|Z₁|]^0.5
[|Z₂|/|Z₁|]²
[|Z₂|/|Z₁|]^0.75

⇒ In the television system in India, the odd and even fields are scanned
25 times each
25 times each but alternately
50 times each
50 times each but alternately

⇒ In 8085 microprocessor, the RST 5.5 interrupt service routine start from location
0020 H
0024 H
0028 H
002 CH

⇒ In figure The minimum and maximum load currents
0 and 60 mA
0 and 120 mA
10 mA and 60 mA
10 mA and 120 mA

⇒ Half bridge and full bridge inverters of one type use different commutation methods.
TRUE
FALSE

⇒ In the human eye, an image persists for a time of about
1 second
0.1 second
0.05 second
0.02 second

⇒ The number of doped regions in a SCR is
2
3
4
5