Question is ⇒ In a thermocouple two metal junctions between metals M1 and M2 are kept at temperature T1 and T2. The thermocouple emf is produced because, Options are ⇒ (A) M1, M2 are similar and T1, T2 are equal, (B) M1, M2 are similar but T1, T2 are unequal, (C) M1, M2 are dissimilar but T1, T2 are equal, (D) M1, M2 are dissimilar but T1, T2 are unequal, (E) , Leave your comments or Download question paper.

Question is ⇒ In a thermocouple two metal junctions between metals M1 and M2 are kept at temperature T1 and T2. The thermocouple emf is produced because, Options are ⇒ (A) M1, M2 are similar and T1, T2 are equal, (B) M1, M2 are similar but T1, T2 are unequal, (C) M1, M2 are dissimilar but T1, T2 are equal, (D) M1, M2 are dissimilar but T1, T2 are unequal, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a thermocouple two metal junctions between metals M₁ and M₂ are kept at temperature T₁ and T₂. The thermocouple emf is produced because
A.	M₁, M₂ are similar and T₁, T₂ are equal [Wrong Answer]
B.	M₁, M₂ are similar but T₁, T₂ are unequal [Wrong Answer]
C.	M₁, M₂ are dissimilar but T₁, T₂ are equal [Wrong Answer]
D.	M₁, M₂ are dissimilar but T₁, T₂ are unequal [Correct Answer]
View Answer 2 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The number of tightly bound electrons in silicon atom are
14
10
6
4

⇒ In a feedback series regular circuit, the output voltage is regulated by controlling the
magnitude of the I/P voltage
gain of the feed back BJT
reference Voltage
voltage drop across the series pass transistor

⇒ A fully charged mobile phone with a 12 V battery is good for a 20 minute talktime. Assume that, during the talk time, the battery delivers a constant current of 2 A and its voltage drops linearly from 12 V to 10 V as shown in the figure. How much energy does the battery deliver during this talk t
220 J
12 kJ
13.2 kJ
14.4 kJ

⇒ Generally op amp is used in
open loop
closed loop
cascaded loop
either (a) or (c)

⇒ The use of SSB
halves the bandwidth required for transmission
does not affect the bandwidth for transmission
decreases the bandwidth required for transmission by 25%
decreases the bandwidth required for transmission by 66.6%

⇒ The product kT (where k is Boltzmann's constant and T is absolute temperature) at room temperature is about
0.051 eV
0.026 eV
0.01 eV
0.001 eV

⇒ Which of the following conditions should be satisfied to call an astable multivibrator circuit using discrete components as a digital circuit?

A flip-flop is always a digital circuit.
Only when we assign 1 and 0 to the high and low levels of the output, a flip-flop is called a digital circuit.
Only if the power, supply voltage is maintained at + 5 V or - 5 V, it is called a digital circuit.
Only if it is in IC form, following the technology of IC manufacture, it is called a digital circuit.

Select the correct answer from the codes given below:
1 only
2 and 3
2 only
3 and 4

⇒ Digital circuits mostly use
Diodes
Bipolar transistors
Diodes and bipolar transistors
Bipolar transistors and FETs

⇒

Assertion (A): If source and destination addresses are made implicit the length of instruction is reduced.

Reason (R): 8085 has only 3 addressing modes.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ The number of flip-flops required to build a mod-19 counter is
4
5
6
7

⇒ The function (s + 2) (s + 4)/[(s + 1)(s + 3)]
is a reactance function
is an RC function
may be a reactance function or an RC function
may be RC function or an RL function

⇒ Which one is a non-causal system?
y(n) = x(2n)
y(n) = x(n/2)
y(n) = x(n/2) + x(n)
all

⇒ The given figure shows log magnitude versus ω plots of a system for different values of gain. For this sy
curve 1 shows highest gain margin and curve 2 shows poorest gain margin
gain margins shown by the three curves are equal
curve 1 shows poorest gain margin and curve 3 shows highest gain margin
curve 3 shows poorest gain margin while curve 1 shows highest gain margin

⇒ Consider the following statements about transport-lag

It is of non-minimum phase behaviour
It normally exists in thermal, hydraulic and pneumatic systems
It has an excessive phase lag with no attenuation at high frequency

Which of the above statements are correct?
1 only
1 and 2
All
2 and 3

⇒ Magnetic susceptibility of a medium is the ratio of
magnetic field strength to mmf
intensity of magnetization to magnetic flux density
intensity of magnetization to field strength
mmf to magnetic field strength

⇒ Input and output impedance with feedback for voltage series feedback having A = -200, R₁ = 10 kΩ, R₀ = 50 kΩ and feedback factor β = -0.2 will be
410 kΩ, 2050 kΩ
410 kΩ, 1.219 kΩ
≈ 0.243 kΩ, 2050 kΩ
≈ 0.24 kΩ, 1.219 kΩ

⇒ The use of coaxial microwave line should be restricted to frequencies
below cut off frequency of TE₁₁ mode
above cut off frequency of TE₁₁ mode
at frequencies much lower than cut off frequency of TE₁₁ mode
at frequencies much higher than cut off frequency of TE₁₁ mode

⇒ In a microprocessor the clock signal
is always generated internally
is always supplied externally
may be generated internally or supplied externally
is mostly supplied externally

⇒ A current of 3.18 A is flowing through resistance of 35.68 Ω. The voltage drop across resistance to the appropriate number of significant figures is
113.4624 V
113.462 V
113.46 V
113 V

⇒

Assertion (A): Typical value of thermal resistance from source to sink of an SCR is about 0.3° C/W

Reason (R): Heat sinks of thyristors are generally made of aluminium.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In the network of figure, the voltage drops across R₁, R₂, R₃ are 6 V, 8 V and 12 V with polarities as shown. The value of R_{312 Ω
8 Ω
5 Ω
3 Ω}

⇒ The effect of source inductance in a 3 phase fully controlled bridge converter is to
decrease the output voltage
increase the output voltage
decrease the output voltage and increase the output current
increase the output voltage and decrease the output current

⇒

Assertion (A): A transistor requires a continuous base signal for conduction but a thyristor requires a gate pulse.

Reason (R): Transistor find widespread application in power electronic circuits.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In 8156, the lower times byte is addressed with 24 H, and the upper times byte with
20 H
23 H
24 H
25 H

⇒ As the firing of a thyristor is delayed, the output voltage of a controlled rectifier decreases.
TRUE
FALSE

⇒ The SID data received is
LSB first
LSB last
1
none of these

⇒ The input impedance of a non-inverting amplifier is very low.
TRUE
FALSE

⇒ Which of the following statement is false?
The gate of DMOSFET may be biased positively, zero or negatively
N-channel enhancement-only MOSFET conducts only when its gate is highly positive
JFET has lower input impedance than MOSFET
The bipolar base is forward biased, JFET gate must also be forward biased

⇒

Assertion (A): In n-p-n transistor conduction is mainly due to electrons.

Reason (R): In n type materials electrons are majority carriers.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ India's first domestic geostationary satellite 1NSAT-IA was launched on 10th April 1982 from
USSR
USA
UK
UP