Question is ⇒ Which of the following are linear ICs?, Options are ⇒ (A) RF and IF amplifiers, (B) Wide band amplifier, (C) Audio amplifiers, (D) All of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following are linear ICs?, Options are ⇒ (A) RF and IF amplifiers, (B) Wide band amplifier, (C) Audio amplifiers, (D) All of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following are linear ICs?
A.	RF and IF amplifiers [Wrong Answer]
B.	Wide band amplifier [Wrong Answer]
C.	Audio amplifiers [Wrong Answer]
D.	All of the above [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The race condition in NOR SR latch occurs when
S = R = 1
S = 0, R = 1
S = 0, R = 0
S = 1, R = 0

⇒ Read the following statements about 8085

RAL instruction rotates ACC contents left by 1 bit
When RAL instruction is executed once the binary number gets doubled
STC means set CY to 1

Which of the above statements are correct?
1 and 2 only
1, 2 and 3 only
1, 2 and 4 only
1 and 4 only

⇒ The counter shown in the given figure is built using 4 -ve edge triggered toggle FFs. The FF can be set asynchronously when R = 0. The combinational logic required to realize a modulo-13 counte
F = Q₄ Q₃ Q₂ Q₁
F = Q₄ + Q₃ + Q₂ + Q₁
F = Q₄ + Q₃ + Q₂ + Q₁
F = Q₄Q₃Q₂Q₁

⇒ Which statement is correct?
BJT and MOSFET are current controlled devices
BJT is voltage controlled and MOSFET is current controlled device
BJT and MOSFET are voltage controlled devices
BJT is current controlled and MOSFET is voltage controlled device

⇒ A tweeter should be fed from the input through a
low pass filter
high pass filter
band pass filter
band stop filter

⇒ Vividh Bharati programme is transmitted in
short wave
medium frequency
very high frequency
all of the above

⇒ The more negative gate voltage, the conductive channel becomes
narrower
wider
thicker
linear

⇒ A dielectric should have poor heat conductivity.
TRUE
FALSE

⇒ An audio frequency of 5 kHz is translated to a radio frequency carrier of frequency 1 MHz and transmitted it to space through an antenna. The required height of antenna is
150 m
300 m
75 m
600 m

⇒ In cell communication, cell stands for
Geographical Area
Battery
Location
No meaning

⇒ On which bands, do the optical fibers operate?

Ultra violet band
Ultra high frequency band
Visible light band
Infrared band

Select the correct answer from the codes given below:
1 only
1 and 2 only
1, 2 and only
1, 3 and 4

⇒ The moving iron instruments are generally repulsion type.
TRUE
FALSE

⇒ An ideal op-amp can amplify dc signals
TRUE
FALSE

⇒ The analog signal given below is sampled by 600 samples per se
600 Hz
120 Hz
300 Hz
360 Hz

⇒ Which of these is also called 'hot carrier diode'?
PIN diode
LED
Photo diode
Schottky diode

⇒ Which binary addition is incorrect?
1001.1 + 1011.01 = 10100.11
100010 + 1000101 = 1001010
0.0011 + 0.1110 = 1.1
1011.01 + 1001.11 = 10111

⇒ An arithmetic statement in C must be
integer mode arithmetic statement
real mode arithmetic statement
mixed mode arithmetic statement
any of the above

⇒ In the circuit of figure, v_{03 v₁ + 4 v₂
-3 v₁ - 4 v₂
4 v₁ + 3 v₂
-4 v₁ - 3 v₂}

⇒

Assertion (A): The propagation delay in ECL is minimum

Reason (R): Transistors used in ECL switch between active and cutoff regions.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ x = AX + Bu is a state equation.
TRUE
FALSE

⇒ Ferromagnetic materials show hysteresis in B - H characteristic. As the magnetic field in increased slowly from zero value, what is the first process which sets the material to give net magnetization?
Growth of favourably oriented domains at the cost of other domains by reversible boundary displacements
Growth of favourably oriented domains at the cost of other domains by irreversible boundary displacements
Domain wall orientation
A combination of processes (a) and (c) above

⇒ Friction forces acts in a direction
opposite to that of velocity
same as that of velocity
at right angle to that of velocity
partly opposite and partly at right angle to the direction of velocity

⇒ A rectangular waveguide, in dominant TE mode, has dimensions 10 cm x 15 cm. The cut off frequency is
10 GHz
1 GHz
15 GHz
25 GHz

⇒ Generally op amp is used in
open loop
closed loop
cascaded loop
either (a) or (c)

⇒ Which of the following is not valid integer variable in FORTRAN 77?
MBR
LOTS
JAMMU
BRG

⇒ An antenna has a resistance of 50 Ω and an equivalent noise resistance of 30 Ω The noise figure in decibels is
1.6 dB
2 dB
3.6 dB
6 dB

⇒ Find cut off wavelength for mode TE₁₁ in a circular waveguide having radius 2 cm. Assume K'_a = 1.841
4 cm
6.82 cm
8 cm
68.2 cm

⇒ Impedance level of Impatt diodes is generally lower than that of Gunn diodes
TRUE
FALSE

⇒

Assertion (A): In C it is possible for functions to call themselves.

Reason (R): C makes use of 'Pointers'.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Which of the following circuit can operate class AB for audio power output?
Push pull
Cascade
Pull down
Darlington pair