Question is ⇒ A constant k low pass filter has fc = 500 Hz. At f = 1000 Hz, the attenuation is, Options are ⇒ (A) zero, (B) infinity, (C) may be zero or infinity, (D) more than zero but less than infinity, (E) , Leave your comments or Download question paper.

Question is ⇒ A constant k low pass filter has fc = 500 Hz. At f = 1000 Hz, the attenuation is, Options are ⇒ (A) zero, (B) infinity, (C) may be zero or infinity, (D) more than zero but less than infinity, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A constant k low pass filter has f_c = 500 Hz. At f = 1000 Hz, the attenuation is
A.	zero [Wrong Answer]
B.	infinity [Wrong Answer]
C.	may be zero or infinity [Wrong Answer]
D.	more than zero but less than infinity [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Each cell of a static Random Access memory contains
6 MOS transistor
4 MOS transistor, 2 capacitor
2 MOS transistor, 4 capacitor
1 MOS transistor and 1 capacitor

⇒

Assertion (A): A composite video signal has synchronising pulses.

Reason (R): It is necessary to synchronise the scanning process in the transmitter and receiver.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In 8086 the flag which enables or disables external interrupts is
IF
DF
TF
CF

⇒ The basic storage element in a digital system is
flip flop
counter
multiplexer
encoder

⇒

Assertion (A): In totem pole output the output impedance is low.

Reason (R): TTL gate with active pull up should not be used in wired AND connection.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In an induction wattmeter, the shading bands are made of non conducting material.
TRUE
FALSE

⇒ A copper atom is neutral. Its core has a net charge of
0
1
-1
2

⇒ If temperature increases by about 50°, the resistance of thermistor changes to
half of its initial value
twice of its initial value
eight times of its initial value
one eight of its initial value

⇒ Which part of radio spectrum is more crowded?
Lower frequency part
Higher frequency part
Both (a) and (b)
None of these

⇒ In radio receivers, the value of IF is
100 kHz
225 kHz
455 kHz
850 kHz

⇒ The circumference of an electron orbit is equal to integer times the wavelength of electron.
TRUE
FALSE

⇒

Assertion (A): McMurray Bredford half bridge inverter uses complementary commutation

Reason (R): Three phase inverter can have two modes of operation.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The device 'one shot' has
two stable states
one stable state
either 1 or 2 stable states
no stable state

⇒ The two conductors of a single phase transmission line suspended in air carry currents in opposite directions. The force per unit length on each conductor varies
directly as the current in either conductor
directly as the distance between the two conductors
directly as the square of the current in either conductor
inversely as the square of the distance between the two conductors

⇒ Greatest mobility can be expected in case of
holes
protons
electrons
negative ions

⇒ Square law modulators utilise
linear range of V-I characteristics of a diode
linear range of V-I characteristics of a triode
non-linear region of V-I dynamic characteristics of a diode
non-linear region of V-I dynamic characteristics of a triode

⇒ The statement ! (b < 5) in C means
b = 5
b > 5
b > = 5
none of the above

⇒ The household energy meter is
indicating instrument
recording instrument
integrating instrument
none of the above

⇒ The start of modern computer age was started by the event
development of disc drive
development of transistor
development of Hollerith code
design of EVIAC computer

⇒ In a series RLC circuit the dB level of currents at half power frequencies as compared to current at resonance is
3
-3
0.5
-0.5

⇒ Consider the following statements

The effect of feedback is to reduce system error
Feedback increases the system gain at one frequency but reduces the system gain as another frequency
Feedback can cause an originally stable system to become unstable

Which of the above statements are correct?
1, 2, 3
1, 2
2, 3
1, 3

⇒ Microprocessors find applications in
pocket calculators
scientific instruments
medical equipments
all of the above

⇒ A transistor is said to be in a quiescent state when
the amplitude of input and output signal is equal
the phase of input and output signal is identical
no signal is applied to the input
the transistor is unbiased

⇒

Assertion (A): Light triggering is very suitable for HVDC transmission.

Reason (R): Light triggering has the advantage of complete electrical isolation of gate circuit.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Karnaugh map can not be drawn when the number of variables is more than 4
TRUE
FALSE

⇒ Which capacitor-store higher amount of energy?
Air capacitor
Paper capacitor
Mica capacitor
Plastic film capacitor

⇒ What does a link budget for satellite communication include?
Total cost of satellite
Cost of satellite plus launch vehicle
Signal and noise levels is dB
Margins of error permitted

⇒ UHF and microwaves in the frequency range 300 MHz to 30 GHz can be best transmitted using __________ propagation
sky wave
ground wave
duct
none of the above

⇒ A metal loses electrons at room temperature.
TRUE
FALSE

⇒ If a common emitter amplifier with an emitter resistance R_C has an overall transconductance gain of 1 m A/V, a voltage gain of - 4 and desensitivity of 50, then the value of the emitter resistance R would be
50 kΩ
0.98 kΩ
50 Ω
0.98 Ω