Question is ⇒ Which of the following constitute the loss resistance of an antenna?, Options are ⇒ (A) Dielectric loss, (B) Leakage loss in insulation, (C) Loss in earth connections, (D) All of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following constitute the loss resistance of an antenna?, Options are ⇒ (A) Dielectric loss, (B) Leakage loss in insulation, (C) Loss in earth connections, (D) All of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following constitute the loss resistance of an antenna?
A.	Dielectric loss [Wrong Answer]
B.	Leakage loss in insulation [Wrong Answer]
C.	Loss in earth connections [Wrong Answer]
D.	All of the above [Correct Answer]
View Answer 2 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In rectangular waveguides the ratio of width to height is about
0.5
1
2
4

⇒ Which of the following analog modulation scheme requires the minimum transmitted power and minimum channel bandwidth?
VSB
DSB-SC
SSB
AM

⇒ In a PCM system, if we increase the quantization levels from 2 to 8, how do the relative bandwidth requirements vary?
Get doubled
Get tripled
Remains same
Become eight times

⇒ McMurrary full bridge inverter uses
auxiliary commutation
complementary commutation
natural commutation
any of the above

⇒ High speed counter
ring counter
ripple counter
synchronous counter
asynchronous counter

⇒

Assertion (A): The surge current which an SCR can withstand is much higher than rms on state current.

Reason (R): The duration of surge current is very small.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Assertion (A): The number ∈ such that the probability that an error is between -∈ and + ∈ is 1 is called probable error of single obserevation.

Reason (R): The standard deviation is the arms value of the deviation from the arithmetic mean.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ When a capacitor is connected to the terminals of an ohmmeter, the pointer indicated a low resistance initially and finally come to infinity position. This shows that capacitor is
short circuited
all right
faulty
open circuited

⇒ Piezoelectric materials serves as a source of
microwaves
ultrasonic waves
musical waves
resonant waves

⇒ The electric energy required to raise the temperature of a given amount of water is 1000 kWh. If heat losses are 25%, the total heating energy required is __________ kWh.
1500
1250
1333
1000

⇒ An electromagnetic wave incidents on a perfect insulator at an angle. If the wave is not entirely parallel polarized, then
the reflected wave will be entirely polarized parallel to the plane of incidence
there will be no reflection
the reflected wave will be entirely polarized perpendicular to the plane of incidence
any of the above

⇒ The first and the last critical frequencies (singularities) of a driving point impedance function of a passive network having two kind of elements, are a pole and a zero respectively. The above property will be satisfied by
RL network only
RC network only
LC network only
RC as well as RL network

⇒ The impulse response of the DT - LTI system is given be
1 and 2
2 and 3
1 and 3
1, 2 and 3

⇒ Consider the draw backs

Slope overload
Serration noise
Granular noise

Which of these draw backs does Delta modulation have?
1 and 2 only
2 and 3 only
1 and 3 only
1, 2, 3

⇒ In the given figure, A = B = 1 and C = D = 0. Then
1
0
either 1 or 0
indeterminate

⇒ The most suitable method for detecting a modulated signal g(t) = (3 to 6 cos 2pf_mt) cos 2pf_ct is
envelope detector
synchronous detector
ratio detector
both a and b

⇒ The current wave shown in figure is applied at t = 0 to a 0.1 F capacitor. At t = 1 s, the voltage across capacito
0 V
10 V
20 V
40 V

⇒ A series R, L, C circuit has R = 2Ω, L = 1H, C = 1 μF. It is connected to an ac variable frequency source of peak voltage 10 V. At resonance the power supplied by the source will be
50 Ω
25 Ω
12.5 Ω
6.25 Ω

⇒

Assertion (A): In rectangular waveguide TE₀₁ mode is just TE₁₀ mode rotated by 90°.

Reason (R): When a rectangular waveguide is rotated by 90°, the broad and narrow dimensions get interchanged.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ During induction heating of metals which of the following is abnormally high?
Frequency
Voltage
Current
Power factor

⇒ In a forward biased p-n junction current enters p material as hole current and leaves n material as electron current of the same magnitude.
TRUE
FALSE

⇒ Wave A = 100 sin ωt and wave B = 100 cos ωt. Then
rms values of the two waves are equal
rms values of A is more than that of B
rms values of A is less than that of B
rms values of the two waves may or may not be equal

⇒ An end fire array consisting of several half-wave lengths of directive gain 40, then array length will be
10 λ
100 λ
20 λ
5 λ

⇒ Hall coefficient is reciprocal of charge density.
TRUE
FALSE

⇒ As regards BCH code, Hamming code and Reed-Solomon code
BCH and Hamming code are special cases of Reed-Solomon code
Reed-Solomon and Hamming code are special cases of BCH code
BCH and Reed-Solomon code are special case of Hamming code
none of the above

⇒ Waveform shown in figure is that
FM
PCM
AM-DSB
AM-SSB

⇒ For an ideal antenna, numerical value of directivity must be
∞
0
1
any value

⇒ Intrinsic concentration of charge carriers in a semiconductor varies as
T
T²
T³
T^-2

⇒ In a series R-L-C circuit at the resonant frequency the
current is maximum
current is minimum
impedance is maximum
voltage is maximum

⇒ In an ac coordinate potentiometer, the currents inphase and quadrature potentiometer are adjusted to be
out of phase by 90°
in phase
out of phase by 45°
out of phase 180°