Question is ⇒ A scheme shown below is to generate a wide band FM modulate sign, Options are ⇒ (A) 88 MHz, 112 MHz, (B) 96 MHz, 104 MHz, (C) 92 MHz, 108 MHz, (D) 90 MHz, 110 MHz, (E) , Leave your comments or Download question paper.

Question is ⇒ A scheme shown below is to generate a wide band FM modulate sign, Options are ⇒ (A) 88 MHz, 112 MHz, (B) 96 MHz, 104 MHz, (C) 92 MHz, 108 MHz, (D) 90 MHz, 110 MHz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A scheme shown below is to generate a wide band FM modulate sign
A.	88 MHz, 112 MHz [Correct Answer]
B.	96 MHz, 104 MHz [Wrong Answer]
C.	92 MHz, 108 MHz [Wrong Answer]
D.	90 MHz, 110 MHz [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Class A amplifiers are preferred when
minimum distortion is required
maximum voltage gain is required
output signal is desired in phase with input signal
signal having A.C. superimposed on D.C. are to be amplified

⇒

Assertion (A): A power factor meter operates on dynamometer principle.

Reason (R): A power factor meter does not have a control spring.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ A number given in binary as 0101.01 is to be scaled up 4 times. The scaled up binary is
10101
1.0101
404.04
10.101

⇒ It is found that in a telephone system 60 subscribers initiate calls during a 30 minute interval and the total duration of all the calls is 100 minutes. The load is
2
3 erlang
3.333 erlang
0.333 erlang

⇒ Microprocessors were introduced in the year
1951
1961
1971
1981

⇒ The number of digits in octal system is
8
7
9
10

⇒ Read the following statements about TWT

It uses thermionic emission.
It uses an attenuater.
It is inherently a resonant device.
It has broad bandwidth.

Which of the above are correct?
1, 2, 3 and 4
1, 2 and 3
1, 3 and 4
1, 2 and 4

⇒ A dc voltage source is connected across a series RLC circuit, Under steady state conditions, the applied dc voltage drops entirely across the
R only
C only
L only
R and L

⇒ The abbreviation DTL stands for
Digital Timing Logic
Diode Transistor Logic
Dynamic Transient Logic
Delayed Tracking Logic

⇒ Read the following statements about Java

It is well suited to design software which works in conjunction with internet.
It is cross platform language.
Java is close to programming language C, C ++ etc.
It is an object oriented.

Which of the above are correct?
All
1, 2 and 3 only
1, 2 and 4 only
2, 3, 4 only

⇒ A transmission line has characteristics impedance of (75 + j 0.01) Ω and is terminated in a load impedance of (70 + j 50) Ω. The transmission coefficient will be
1.70 - j 2.97
0.08 + j 0.32
1.32 + j 1.38
1.08 + j 0.32

⇒ A digital clock uses __________ chip
SSI
LSI
VLSI
MSI

⇒ Characteristic impedance of a coaxial cable is inversely proportional to ∈_r.
TRUE
FALSE

⇒

Assertion (A): Damping in a vibration galvanometer is small.

Reason (R): Vibration galvanometer is a PMMC instrument.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ What are the counting stages (Q₁, Q₂) for the counter shown in the figure be
11, 10, 00, 11, 10, ...
01, 10, 11, 00, 10, ...
00, 11, 01, 10, 00, ...
01, 10, 00, 01, 10, ...

⇒

Assertion (A): If the reading of an instrument is low, the error is large.

Reason (R): The error of an instrument is certain percentage of its full scale deflection.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ A band limited signal is sampled at the Nyquist rate. The signal can be recovered by passing the samples through
an RC filter
an envelope detector
a PPL
an ideal low pass filter with the appropriate bandwidth

⇒ What is the frequency of audio modulation?
1000 Hz
2000 Hz
3000 Hz
2000 kHz

⇒ A peak responding ac voltmeter using a half wave rectifier has been calibrated to read 1 V for 1 V rms sine wave input. If input is 1 V dc the reading will be
0.707 V
0.707 or 0 V
1.414 V
1.414 or 0 V

⇒ The bandwidth of an amplifier can be reduced by
miller effect compensation
pole zero compensation
dominant pole compensation
lead compensation

⇒ In the circuit shown, the power supplied by the voltage so
0 W
5 W
10 W
100 W

⇒ Probability of error in DPSK is less than PSK
TRUE
FALSE
equal
depend upon noise

⇒ Which one of the following is used to change data from spatial code to temporal code?
Shift register
Counter
A/D converters
Combinational circuits

⇒ In a monolithic IC, resistors are formed from
ceramic material
manganin wire
P-type semiconductor
aluminium ribbon

⇒ T.V. antennas are usually
Yagi-Uda
loops
helical
parabolic

⇒ What does the operator ( ) mean in C?
Function expression
Array expression
Structure operator
Increment / Decrement

⇒ In ferromagnetic materials
the atomic magnetic moments are antiparallel and unequal
the atomic magnetic moments are parallel
the constituent is iron only
one of the constituents is iron

⇒ A number of impulses spaced fron one another form an impulse train.
TRUE
FALSE

⇒ For a permanent magnetic material
the residual induction and coercive field should be large
the residual induction and coercive field should be small
area of hysteresis loop should be small
initial relative permeability should be high

⇒ The causal system given below is _______
minimum phase
maximum phase
mixed phase
none of these