Question is ⇒ The amount of time between the creation and disappearance of a hole in an intrinsic semiconductor material is called, Options are ⇒ (A) life cycle, (B) recombination time, (C) life time, (D) half life, (E) , Leave your comments or Download question paper.

Question is ⇒ The amount of time between the creation and disappearance of a hole in an intrinsic semiconductor material is called, Options are ⇒ (A) life cycle, (B) recombination time, (C) life time, (D) half life, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The amount of time between the creation and disappearance of a hole in an intrinsic semiconductor material is called
A.	life cycle [Wrong Answer]
B.	recombination time [Wrong Answer]
C.	life time [Correct Answer]
D.	half life [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The L/C has the dimension of
time
capacitance
velocity
resistance

⇒ In a radio receiver, the local oscillator is tuned to a frequency
lower than the incoming frequency
higher than the incoming frequency
equal to incoming frequency
any of the above

⇒ For demodulating PCM; it is first converted into
PDM
PPM
PWM
PAM

⇒ An impulse train is
a number of pulses
a number of pulses spaced from each other
a number of pulses all originating together
none of the above

⇒ When number of quantization levels are two; then the average transmission power in NRZ polar signaling is __________ that of NRZ unipolar signaling
42737
42739
42743
none of these

⇒

Match the following:

	List I		List II
A.	GTO	1.	Widely used in digital computers
B.	UJT	2.	Used for freewheeling
C.	Power Diode	3.	Can be turned off by negative gate signal
D.	MOSFET	4.	Used in generating triggering pulses

A-1, B-2, C-3, D-4
A-4, B-2, C-3, D-1
A-3, B-4, C-2, D-1
A-2, B-1, C-3, D-4

⇒ Which of the following methods does not cause any reduction in instruction length?
Using program counter
Common source and destination address
Implicit source and destination address
Machine language programming

⇒ When the video signal is applied to the picture tube in a TV receiver, the strength of video signal is about
1000 V
200 V
50 V
1 V

⇒ JFET is also known as
linear device
square law device
inverse law device
logarithmic law device

⇒ A transistor with a = 0.9 and I_CBO = 10 μA is biased so that I_BQ = 90 μA. Then I_EQ will be
5.15 mA
5.2 mA
5 mA
990 mA

⇒ The five flags in 8085 are designated as
Z, CY, S, P and AC
D, Z, S, P, AC
Z, C, S, P, AC
Z, CY, S, D, AC

⇒ In the circuit shown, the steady state is reached with S open S is closed at t = 0, the current I in the 1 Ω resistor connected is to be determined at t = 0⁺ is give
1
2
3
42828

⇒ Ionospheric storm causes an abnormal decrease in the critical frequency.
TRUE
FALSE

⇒ A loss less line is terminated in a circular lines are E lines
SWR = 0
SWE = 0
SWR is finite
SWR = ∞

⇒ A bit synchronizer regenerates at the receiver a clock waveform which is
synchronous with original clock waveform
out of phase by 180° with original clock waveform
out of phase by 90° with the original clock waveform
none of the above

⇒ Microprocessors were introduced in the year
1951
1961
1971
1981

⇒ For a superconductor, magnetisation M in a field H is
extremely small
- H
- I
zero

⇒

Assertion (A): Temperature control of the passenger compartment of car uses both feed forward and feedback controls.

Reason (R): Feed forward control gives corrective action before the disturbance affects the output and feedback control applies corrective action after output changes.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A meter has a resistance of 1 Ω and full scale deflection current of 1 mA. To convert into an ammeter of 1 A range, the shunt resistance should be
1000 Ω
1 Ω
0.01 Ω
0.001 Ω

⇒

Assertion (A): In series R-L-C circuit, the current may lead or lag the voltage depending on the value of R.

Reason (R): Phase angle of an R-L series circuit is tan^-1 (ωL/R).

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In order to obtain triangular pulses at the output of the circuit in the figure, the input should
grounded
a square wave
Triangular wave
Trigger

⇒ Poynting vector is associated with which of the following?
Power flow in electromagnetic
Flux in magnetic field
Charge in electrostatic field
Current in electrostatic field

⇒ For TE or TM modes of propagation in bounded media, the phase velocity is
independent of frequency
is a linear function of frequency
is a non-linear function of frequency
can be frequency dependent or frequency independent on the source

⇒ The IF amplifier in a superheterodyne receiver is
single-stage single-timed amplifier
two stage of single tuned amplifier
double tuned amplifier
class-C amplifier

⇒ A scheme shown below is to generate a wide band FM modulate sign
30
6
250
12

⇒ The difference between sequential and combinational circuits is
Combinational circuits store bits
Combinational circuits have memory
Sequential circuits store bits
Sequential circuits have memory

⇒ At room temperature, the current in the, intrinsic semiconductor is due to
holes
electrons
ions
holes and electrons

⇒ The forbidden band in semiconductors is of the order of
6 eV
1 eV
10 eV
0.01 eV

⇒ While obtaining minimal SOP expression
all do not care terms are ignored
all do not care terms are treated as 1
all do not care terms are treated as 0
only such do not care terms which aid minimization are treated as 1

⇒ The sensitivity of human eyes is maximum at
white portion of spectrum
green portion of spectrum
red portion of spectrum
violet portion of spectrum