Question is ⇒ The minimum energy of a photon required for intrinsic excitation is equal to, Options are ⇒ (A) energy of bottom of conduction band, (B) energy of top of valence band, (C) forbidden gap energy, (D) Fermi energy, (E) , Leave your comments or Download question paper.

Question is ⇒ The minimum energy of a photon required for intrinsic excitation is equal to, Options are ⇒ (A) energy of bottom of conduction band, (B) energy of top of valence band, (C) forbidden gap energy, (D) Fermi energy, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The minimum energy of a photon required for intrinsic excitation is equal to
A.	energy of bottom of conduction band [Wrong Answer]
B.	energy of top of valence band [Wrong Answer]
C.	forbidden gap energy [Correct Answer]
D.	Fermi energy [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Long distance short wave radio broadcasting based on
line of sight
ionospheric wave
ground wave
skywave

⇒ Which of the following is not an assembler directive in 8085?
D S
D B
D Q
E Q U

⇒ Find the electric charge required on the earth and moon to balance their gravitational attraction if the charge on the earth is 12.5 times that on the m
48.9 TC
4.89 GC
4.89 TC
48.9 GC

⇒ Calculate the resistivity of n-type semiconductor from the following data, Density of holes = 5 x 10¹² cm^-3. Density of electrons = 8 x 10¹³ cm^-3, mobility of conduction electron = 2.3 x 10⁴ cm²/ V-sec and mobility of holes = 100 cm²/V-sec.
0.43 Ω-m
0.34 Ω-m
0.42 Ω-m
0.24 Ω-m

⇒

Assertion (A): PC-XT is a personal computer.

Reason (R): PC-XT uses a floppy drive and has a medium sized hard disc.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ The 54/74164 chip is an 8-bit serial-input-parallel-output shift register. The clock is 1 MHz. The time needed to shift a 8-bit binary number into the chip is
1 μs
2 μs
8 μs
16 μs

⇒

Assertion (A): As the length of the resonant antenna is increased, the number of lobes increases and the direction of the major lobes is closer and closer to the direction of the diode.

Reason (R): As the length increases, the current distribution along the wire becomes more and more uniform.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The 8085 instruction LDA FFA is an example of
Direct addressing
Register addressing
Immediate addressing
Register indirect addressing

⇒ In a CE amplifier the ac cut off voltage is 9 V and slope of ac load line is - 0.5 mA/V. The ac saturation current is
9 mA
4.5 mA
3 mA
18 mA

⇒ In a four element Yagi-Uda antenna
there is one driven element, one director and two reflectors
there is one driven element, two directors and one reflector
there are two driven elements, one director and two reflectors
all the 4 elements are driven element

⇒ An AM signal and a narrowband FM signal with identical carriers, modulating signals and modulation index of 0.1 are added together. The resultant signal can be closely approximated by
Broadband FM
SSB with carrier
DSB-SC
SSB without carrier

⇒ Fibers have numerical aperture (NA) in the range of 0.15 to 0.4 Fibers with higher NA value would have
reduced losses
high bandwidth
reduced losses and low bandwidth
more losses and low bandwidth

⇒ The input gate current of a FET is
a few amperes
a few milli amperes
a few micro amperes
negligible

⇒ A linear displacement digital transducer generally uses
straight binary code
BCD
gray code
hexadecimal code

⇒ An FM transmitter delivers 80W to a load of 30 W when no modulation is present. The carrier is now frequency modulated by a single sinusoidal signal and the peak frequency deviation is so adjusted to make the amplitude of the second sideband is zero in the given out
84 W
97.44 W
100 W
77.44 W

⇒ The voltage drop per ampere-metre of an aluminium conductor is higher as compared to a copper conductor of the same size due to its higher
insulation resistance
resistivity
conductivity
current density

⇒ If A = 0101, then A' is
1010
1011
1001
110

⇒ Which of the following oscillator is generally not used at VHF?
Colpitts oscillator
Clapp oscillator
Armstrong oscillator
Ultra Audio oscillator

⇒ The Boolean function A + BC is a reduced form of
AB + BC
(A + B) . (A + C)
AB + ABC
(A + C) . B

⇒ In a broadcast superheterodynes receiver having no RF amplifier, the loaded Q of the antenna coupling circuit is 100. If the intermediate frequency is 455 kHz. The image frequency at 25 MHz will be
24.09 MHz
24.54 MHz
25.45 MHz
25.91 MHz

⇒ The parity bit is
always 1
always 0
1 or 0
none of the above

⇒ A direct radiating cone type loudspeaker attenuates :
medium range frequencies
very low frequencies
high frequencies
very low and high frequencies

⇒ In order to achieve accuracy, the slide wire of a potentiometer should be
as long as possible
as short as possible
neither too long nor too short
very thin

⇒ In which of the following schemes are several channels interleaved and transmitted together?
TDM
FDM
group
subgroup

⇒ Consider the following in C

Arithmetic operations can be performed on ints.
Arithmetic operations can be performed on floats.
Arithmetic operation can be performed on chars

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ To relay outdoor remotely located live programs, TV transmitter use
microwave links
coaxial cable link
open wire link
either (b) or (c)

⇒ Most of the digital computers do not have floating-point hardware because
floating point hardware is costly
it is slower than software
it is not possible to perform floating point addition by hardware
of not specific reason

⇒

Assertion (A): A fully controlled bridge converter can operate in first and fourth quadrant.

Reason (R): A semi converter is cheaper than a full converter.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In free space
phase velocity is greater than light velocity
phase velocity is equal to group velocity
phase velocity is equal to light velocity
Both (b) and (c)

⇒ A silicon wafer has 100 nm of oxide it and is inserted in a furnace at a temperature above 1000°C for further oxidation in dry oxygen. The oxidation rate
is independent of current oxide thickness and temperature
is independent of current oxide thickness but depends on temperature
slows down as the oxide grows
is zero as the existing oxide prevents further oxidation