Question is ⇒ In the circuit of figure β = 50 and VBE = 0.5 V. The quiescent value of base current IB</sub, Options are ⇒ (A) about 28 μA, (B) about 28 mA, (C) about 0.28 μA, (D) about 2.8 A, (E) , Leave your comments or Download question paper.

Question is ⇒ In the circuit of figure β = 50 and VBE = 0.5 V. The quiescent value of base current IB</sub, Options are ⇒ (A) about 28 μA, (B) about 28 mA, (C) about 0.28 μA, (D) about 2.8 A, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In the circuit of figure β = 50 and V_BE = 0.5 V. The quiescent value of base current I_B
A.	about 28 μA [Correct Answer]
B.	about 28 mA [Wrong Answer]
C.	about 0.28 μA [Wrong Answer]
D.	about 2.8 A [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The main advantage of CMOS circuit is
high gain
high output impedance
low power consumption
high gain and high output impedance

⇒

Match the following:

	List I (VCR system)		List II (Azimuth angle)
A.	VHS	1.	7°
B.	Video 2000	2.	15°
C.	Betamax	3.	6°

A-1, B-2, C-3
A-1, B-3, C-2
A-3, B-1, C-2
A-3, B-2, C-1

⇒ The conductivity of intrinsic semiconductor is given by
en_i(μ_p - μ_n)
en_i(μ_p + μ_n)
n_i(μ_p + μ_n)
n_i(μ_pμ_n)

⇒ The skin depth at 1000 MHz as compared to that at 500 MHz is
2
12
0.707
0.5

⇒ In Von-Neumann-or Princeton-type computers, the program
can appear any where within the memory
memory and data memory are clearly distinguished
data and instructions are distinguished at the first stage
none of the above

⇒ The basic circuit configuration for TTL resembles that of a
AND gate
NAND gate
NOR gate
OR gate

⇒

Assertion (A): In a circuit having high inductance, reactive power may be more than apparent power.

Reason (R): Reactive power = VI sin θ.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In the analogy between electric and magnetic circuits permeability is analogous to
resistivity
conductivity
electric field intensity
current density

⇒ An AC source or RMS voltage 20V with internal impedance Z_s = (1 + 2j) Ω feeds a load of impedance Z_L = (7 + 4j) Ω in the figure below. The reactive power consumed by the loa
8 VAR
16 VAR
28 VAR
32 VAR

⇒ For attenuation of high frequencies we should use
shunt capacitance
series capacitance
inductance
resistance

⇒ The log magnitude for the system in the given figure is (where T =
20 log (1 + ωT)
-20 log (1 + ωT)
-10 log (1 + ω²T²)
-20 log (1 + ω²T²)

⇒ In a normally biased N-P-N transistor the main current crossing the collector junction is
a drift current
a hole current
a diffusion current
same as the base current

⇒ In the given figure the line voltage after a number of reflections wil
30 V
-30 V
10 V
-10 V

⇒ In FM and AM the ratio of signal to noise ratio at the detector output least depends upon
bandwidth
transmission
carrier frequency
modulating frequency

⇒

Match the following:

	List I (Octal)		List II (Decimal number)
A.	35	1.	53
B.	65	2.	62
C.	54	3.	29
D.	76	4.	44

A-4, B-3, C-2, D-1
A-1, B-2, C-3, D-4
A-2, B-3, C-1, D-4
A-3, B-1, C-4, D-2

⇒ For parallel plane waveguides, which is the mode with lowest cut-off frequency?
TE₁₀
TM₁₀
TEM
TE₁₁

⇒ Which one of the following is also called 'rat race'?
E plane tee
H plane tee
Magic tee
Hybrid ring

⇒ A peak responding ac voltmeter using a half wave rectifier has been calibrated to read 1 V for 1 V rms sine wave input. If input is 1 V dc the reading will be
0.707 V
0.707 or 0 V
1.414 V
1.414 or 0 V

⇒ The circuit of the figure is an example of feedback of the following
current series
current shunt
voltage series
voltage shunt

⇒ Two current sources each of rms value 10 A have frequencies 40 Hz and 50 Hz respectively. They are connected in series, the expression for resultant wave is
i = 10 sin 40 t + 10 sin 50 t
i = 14.14 sin 40 t + 14.14 sin 50 t
i = 14.14 sin 80 pt + 14.14 sin 100 pt
i = 20 sin 80 pt + 20 sin 100 pt

⇒ Find the output voltage for 011100 in a 6 bit R-2R ladder D/A converter has a reference voltage of 6.5 V.
6.4 V
2.84 V
0.1 V
8 V

⇒ Four MSI TTL 4-bit ripple counters are cascaded to form a 16-bit binary counter. Its propagation delay is about __________ nanoseconds.
70
140
210
280

⇒ In the op-amp circuit of figure, V_{010 V
-10 V
5 V
-5 V}

⇒ The binary equivalent of 4096.90625 is
1000000000000.11
10000000000001.1
1000000000001.1
1000000000000.1

⇒ The transfer function of transportation lag is
G(jω) = e^jωT
G(jω) = e^-jωT
G(jω) = (1 + jωT)
G(jω) = (1 - jωT)

⇒ Photo electric emission can occur only if
wave length of incident radiation is equal to threshold value
wave length of incident radiation is less than threshold value
frequency of incident radiation is less than threshold frequency
none of the above

⇒ Consider the real expression in Pascal language XZ and MP + K
XZ + Y and MP + K
(MP + K + X) / Y
Y / (MP + K)

⇒ Which of the following is a valid FORTRAN assignment statement?
10 = N
X + 2.1 = 5.6
A = B
A = B = 1

⇒ The merging of a hole and an electron is called
recombination
covalent bonding
thermal union
none of the above

⇒ The most commonly used semiconductor material is
silicon
germanium
mixture of silicon and germanium
none of the above